Question about 1992 Nissan Pathfinder

Open Question

What is the use of the switch power A/T, hold on a nissan terrano?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
jdwills
  • 15 Answers

SOURCE: nissan terrano headlight

check out
http://www.sferamydlo.com.pl/Zbyszek/Nissan/R20/el.pdf


Bulb Replacement
The headlamp is a semi-sealed beam type which uses a replacable
halogen bulb. The bulb can be replaced from the engine compartment
side without removing the headlamp body.
I Grasp only the plastic base when handling the bulb. Never
touch the glass envelope.
1. Disconnect the battery cable.
2. Disconnect the harness connector from the back side of the
bulb.
3. Pull off the rubber cap.
4. Press end of the retaining pin together to release bulb.
5. Remove the headlamp bulb. Do not shake or rotate the bulb
when removing it.
6. Install the new bulb in reverse order of removal.

Posted on Nov 11, 2008

Ad
  • 66 Answers

SOURCE: Nissan Terrano Chugging

When you are going up a hill, the engine is under an incresed load - requiring more fuel and spark, so I'd first check all of the ignition related items (Plugs/wires/cap/rotor), and it isn't a bad idea to replace the fuel and air filters if you haven't in a while. Once those are checked, it is very very common for a TPS (Throttle Position switch) to develop "dead spots"; where under accelleration they cause a "chugging", which sometimes is quite unnoticable - unless/until vehicle is under a load ( eg. driving up a hill). A new TPS can be installed and set with a multi-meter - probes attached to the proper terminals, and have the output voltage set at .47V to .50 V at idle (Closed throttle). I'd bet this is the cause, as they usually do not set a DTC (Code - Service Engine light) . It isn't 100% for sure, an air flow meter and/or other things can cause this type thing as well (also a weak spark or coil, etc), but highly unlikely - other malfunctioning parts often set trouble codes as well, and usually either malfunction or they don't. Hope this helps and if you find anything else - please let me know.
DD

Posted on Jan 28, 2009

  • 323 Answers

SOURCE: The power outlet of a nissan terrano doesn`t work.

check the fuse under the hood

Posted on Nov 07, 2009

  • 1 Answer

SOURCE: Why does my Nissan Terrano 2.7 turbo diesel have no power?

i have got 2.7 turbo thats lost power ive changed fuel filter but when you put your foot down it blowing heaps of smoke ??

Posted on Dec 26, 2009

  • 1 Answer

SOURCE: heater plugs for nissan terrano 2

i have a nissan terrano 2.7 dti heater light not coming on some times dose and some times does'nt and it wont start

Posted on Mar 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1992 nissan terrano only my left rear wheel is getting power in 4WD


C clip that retains axel is broken or came off. Or the axel is bad.

Jan 12, 2014 | Nissan Cars & Trucks

1 Answer

Nissan terrano 2 3.0L SVE loss of power under


Go and have the computer scanned for codes. Go from there, otherwise you are just firing the parts cannon at the problem.....

Sep 30, 2013 | 2005 Nissan Terrano 3.0

1 Answer

1998 terrano immobiliser fault wont start


hi, i have nissan terrano wen i switched on engine light flash and start engine its start then go of.nissan terrano patrol engine

Sep 06, 2012 | Nissan Sentra Cars & Trucks

2 Answers

I have 1995 Nissan Terrano 4x4.Thishas an Automatic trans. It will not change gear.I have a power/hold button next to the hand brake.The power light flashes


If the power hold button switch On,It will stop the gear shifting & hold the gear position. or the problem with the system.

Feb 08, 2011 | Nissan Terrano Cars & Trucks

3 Answers

LATE SHIFTING FOR NISSAN TERRANO


Check transmission fluid after driving for a while, this could be down a bit. If 4 wheel drive, make sure it's in 2H.

Jul 16, 2009 | 1999 Nissan Pathfinder

Not finding what you are looking for?
1992 Nissan Pathfinder Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...