Question about 1996 Nissan Pickup

Open Question

Where is the fuel filter located for a 1996 nissan pickup

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ajkill
  • 2035 Answers

SOURCE: changing fuel filter on 2002 Mazda pickup

Clean all dirt and/or grease from the fuel filter fittings. "Quick Connect" fittings are used on models equipped with a pressurized fuel system. These fittings must be disconnected using the proper procedure or the fittings may be damaged. The fuel filter uses a "hairpin" clip retainer. Spread the two hairpin clip legs about 1/8 in. (3mm) each to disengage it from the fitting, then pull the clip outward. Use finger pressure only; do not use any tools. Push the quick connect fittings onto the filter ends. Mazda recommends that the retaining clips be replaced whenever removed. The fuel tubes used on these fuel systems are manufactured in 5/16 in. and 3/8 in. diameters. Each fuel tube takes a different size hairpin clip, so keep this in mind when purchasing new clips. A click will be heard when the hairpin clip snaps into its proper position. Pull on the lines with moderate pressure to ensure proper connection. Start the engine and check for fuel leaks. If the inertia switch (reset switch) was disconnected to relieve the fuel system pressure, cycle the ignition switch from the OFF to ON position several times to re-charge the fuel system before attempting to start the engine.
0900c15280192eed.jpgRemove the "hairpin" clip retainers to access the fuel line fittingsThe inline reservoir type fuel filter should last the life of the vehicle under normal driving conditions. If the filter does need to be replaced, proceed as follows:
CAUTIONIf the fuel filter is being serviced with the rear of the vehicle higher than the front, or if the tank is pressurized, fuel leakage or siphoning from the tank fuel lines could occur. to prevent this condition, maintain the vehicle front end at or above the level of the rear of vehicle. also, relieve tank pressure by loosening the fuel fill cap. cap should be tightened after pressure is relieved.

  1. Shut the engine off. Depressurize the fuel system.
  2. Raise and support the vehicle safely.
  3. Detach the fuel lines from both ends of the fuel filter by disengaging both push connect fittings. Install new retainer clips in each push connect fitting.
  4. Note which way the flow direction arrow points on the old filter.
  5. Remove the filter from the bracket by loosening the filter retaining clamp enough to allow the filter to pass through.
The flow direction arrow should be positioned as installed in the bracket to ensure proper flow of fuel through the replacement filter.
  1. Install the filter in the bracket, ensuring proper direction of flow as noted by arrow. Tighten clamp to 15-25 inch lbs.
  2. Install the push connect fittings at both ends of the filter.
  3. Lower the vehicle.
  4. Start the engine and check for leaks.
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Properly relieve the fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable
    • Push connect and R-clip fittings from the fuel filter
    • Fuel filter 0900c15280192eee.jpgFuel filter location and connections–2002–2006
To install:
  1. Install or connect the following:
    • Fuel filter. Torque the nut to 17 ft. lbs. (23 Nm).
    • R-clip and push connect fittings
    • Negative battery cable
  2. Start the vehicle, check for leaks and repair if necessary.

Posted on Oct 17, 2008

idrift240s
  • 22 Answers

SOURCE: 1996 fuel filter location

its on the left side of the engine under the intake..its a bit of a squeeze but it can be removed without removing other pieces

Posted on Mar 18, 2009

bitchn65cuda
  • 70 Answers

SOURCE: locate fuel filter on 2007 nissan sentra 2.0 liter engine

its in the gas tank but it doesnt have to be changed!!!YAY

Posted on Apr 25, 2009

sandman357
  • 236 Answers

SOURCE: where is fuel-filter on 2.4L D21 Nissan pickup?

it should be under the car close to the driver side door. if you can't see it trace it from the fuel tank it should be attached to the fuel line. if you have the repolacement in your hand you will know what you're looking for

Posted on Feb 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can't locate filler plug on 1996 Nissan pickup standard transmission


Manual trans fluid is checked by removing the fill plug located on the transmission on the driver's side. it is a 1/2" square drive flush mounted plug.

Aug 23, 2012 | 1996 Nissan Pickup

1 Answer

My 1996 nissan pick dies when given gas to suddenly . If I slowley aply gas the engine will rev. Where is the fuel filter located?


Fuel filter should be located near the fuel tank under the truck possibly on the frame rail

Apr 26, 2011 | 1996 Nissan Pickup

1 Answer

Where is fuel-filter on 2.4L D21 Nissan pickup?


it should be under the car close to the driver side door. if you can't see it trace it from the fuel tank it should be attached to the fuel line. if you have the repolacement in your hand you will know what you're looking for

Feb 28, 2010 | 1993 Nissan Pickup

1 Answer

Where is the fuel filter on a 1997 Nissan pickup?


1997 Nissan/Datsun Truck Pickup 4WD 2.4L SFI 4cyl
The Fuel Filter is located under hood, passenger side, front side of shock tower, mounted in fuel line .

Hope help with this (remember rated this help).

Feb 17, 2010 | 1997 Nissan Pickup

1 Answer

Changing the fuel filter


Starting at the fuel tank.. follow the fuel lines towards the front of the car. Make sure when you replace the fuel filter that you put the arrow on the fiter the right direction, otherwise there will be no flow and the engine will not start,

Good Luck!

Dec 14, 2009 | 1996 Nissan Quest

3 Answers

19966 nissan pickup sputters at a stop light,but


possibly a spark plug wire loose or plugs need replacing?

Feb 27, 2009 | 1994 Chevrolet S-10 Blazer

1 Answer

1996 nissan pcv valve location


I am used to the PCV valve being in the valve cover so I ran into the same problem myself on my 96 hardbody it is located down near the oil filter you will have to go in through the passenger front wheel well take off the splash guard and you may have to make a little room by disconnecting an electrical bracket and I believe it is a 19mm wrench.Hope this helps

Feb 07, 2009 | 1996 Nissan Pickup

Not finding what you are looking for?
1996 Nissan Pickup Logo

Related Topics:

697 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14251 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...