Camshaft sensor, in your truck it's call distributor pick-up assembly, sit in the distributor assembly, will be the connector with three wire's, to replace distributor will have to come out, before remove distributor out, remove cap and make a mark some where, where the rotor is pointing to, so when you put it back in the rotor points where the mark is at, or you will have a hard the setting it with number one cylinder again.
Bcas1298 is correct it's in the distributor and after you install it you'll have to get a scanner and reset the cam ****** timing.
CAM SENSOR ABOVE THE CRANKSHAFT PULLEY.CRANKSHAFT SENSOR ON SIDE OF ENGINE BLOCK.
A camshaft position sensor,or cylinder identification sensor is used to determin the engine cycle position the information is used to provide individual cylinder ignition and injection cotrol.Many engine mangement systems use an inductive type of sensor that is located near the camshaft;when the camshaft rotates a single signal is passed to the ECU to indicate a reference point in the engine cycle
954 views
Usually answered in minutes!
×