Question about 2003 Honda Accord

Open Question

Removing panel underneath steering wheel in 2003 Honda Accord to replace brake light switch. Panel comes loose in back, but won't come free in front. There don't appear to be any screws holding it, but I can't seem to pop it out. Any hints?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: 1999 Honda Accord Coupe

See an example
DISASSEMBLY 1. Remove the suction pipe and the O-ring from the oil pump.
ad6db20.gif 2. Remove the rear cover with the gasket and pins. 3. Remove the cam ring. 4. Remove the rotor and vanes. 5. Remove the front side plate.
1868d6d.gif 6. Remove the inner and outer O-ring. 7. Remove the spring. When assembling, use a new gasket and O-ring.
47a7732.gif 8. Remove the pulley nut with the spring washer. 9. Pull off the pulley and the woodruff key.a12b5d7.gif 10. Remove the snap ring using snap ring pliers. 11. Drive out the pulley shaft with the bearing. If necessary, use plastic hammer

Posted on May 30, 2008

Ad
  • 1779 Answers

SOURCE: inatallation 92 honda accord power steering pump

Hey, here's the procedure, disable air bag, if equipped w/ one, disconnect the pump return hose from the reservoir and place the end in a large container. Plug the port in the reservoir. Start the engine and turn the steering wheel lock to lock several times, until fluid stops running from the hose. Turn off engine immediately. Re-attach hose. Disconnect the inlet and outlet hoses at the pump. Remove the drive belt. Remove the mounting bolts/nuts and remove pump.
Install in reverse order. Adjust belt tension,fill ps reservoir and bleed any air from the system (to bleed air from system, fill reservoir, start engine and allow to idle, turn wheel from side to side all the way several times. Shut off, fill if necessary.
. Tighten bolts to : Thru bolt 30 ft lbs., mounting nut 16 ft lbs.

Posted on Dec 30, 2008

  • 1 Answer

SOURCE: car brake lights won t turn off when car is shut down Honda accord lx 1992

possible bad brake light switch below the brake peddle.

Posted on Jun 01, 2009

polarcycle
  • 1392 Answers

SOURCE: car brake lights won t turn off when car is shut down 1996 Honda Odyssey

It should be your brake light switch. There is a little plate welded to the arm of the pedal that has a hole with a rubber stopper. The rubber stopper is most likely missing, or damaged. You should be able to take a flashlight and see the plate and the switch. If the hole is plugged up, you will need the brake light switch, if not, replace the plug.

Posted on Jun 02, 2009

  • 7353 Answers

SOURCE: How do I get the ingition our of a 92 honda

the switch or the lock? the switch is only 2 screws and it pulls out. to get lock cylinder out, turn key to position "1" and depress locking pin, pull cyl out.

Posted on Oct 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 honda accord/ key wont turn,steering wheel is locked


To fix your problem, you have to turn the steering wheel either to the left or right as much as you can, then try to turn the key in the ignition. When the steering wheel locks, the key won't turn. By manually holding the steering wheel out of the lock position, the key will turn again and you're steering column will be back to normal.

Oct 19, 2011 | 2003 Honda Accord

1 Answer

04 Honda Accord EX : The cruise control master switch clicks off immediately after it is pressed; the air bag light comes on and stays on for several days and then goes off all to start the cycle again;...


your problem is a part called a clock spring located underneath the steering wheel.best to have a shop replace it for you, special wheel puller is required to remove the steering wheel, this part carries wires for all controls and air bag that are control by the steer wheel buttons.

Sep 04, 2011 | 2004 Honda Accord

3 Answers

How do i remove the dash on 2003 honda accord lx to replace brake light switch?


you will not have to remove the dash to replace the brake light switch this is usually located right behind the brake pedal

Feb 10, 2011 | 2003 Honda Accord

1 Answer

Where you find the brake light switch for 2003 honda accord v6


the brake light switch is under the dash above the brake pedal, it is actuated by the brake pedal arm, you will need to remove the panel under the dash to see it. here is a picture of the switch so u can ID itb906c1b.jpg

Oct 06, 2010 | 2003 Honda Accord

1 Answer

I have a 2003 Honda Accord and My key won't lock or unlock the doors. I would like to know what trouble shooting problem I can do before I take it to a repair shop. Any ideas are welcomed.


Check your power door lock fuse located underneath the drivers side steering wheel. Flip the fuse box cover over and there will be a diagram showing what fuse controls what component. When it burns out the power door locks will no longer work. If your fuse is ok then replace your power door lock actuator has gone bad. You will then need to remove your door panel and replace the PDL actuator with a new one.

Sep 14, 2010 | 2003 Honda Accord

1 Answer

My rear brake lights and blinkers won't come on. the bulbs are good,i checked the fuses there good whats nextto check


Hi!!

The turn signal switch overrides your brake lights when activated, that's why when it fails, cuts power to both circuits.

For your type of vehicle, it is relatively easy to replace, remove steering wheel, unscrew turn signal lever, unplug electrical connector from underneath instrument panel by steering column, remove the 3 or 4 .screws fastening the switch and pull it out until connector is free. It is about 1/2 hr. job.

I suggest to get new switch first so you can get familiar with it.

Don't forget to rate this post. Good Luck.

May 14, 2010 | 1988 Chevrolet K1500

2 Answers

I can't set the cruise control on my 2002 Honda Accord 4 cyclinder


Are you looking for the cruise button inside the car ? it is on the dash, steering wheel, or blinker lever, if you are looking for it under the hood it is tucked back toward the firewall.

Feb 03, 2010 | 2002 Honda Accord

1 Answer

Brake lights are not working on my 98 honda accord. Tail lights, turn signal, backup lights are all working.


probably the switch underneath the brake pedal. take off the drivers kick panel and look up underneath and behind the pedal arm to see if there is a small switch behind it. its probably pushed out of the way.

Jun 18, 2009 | 1999 Honda Accord

3 Answers

Car brake lights won t turn off when car is shut down 1996 Honda Odyssey


It should be your brake light switch. There is a little plate welded to the arm of the pedal that has a hole with a rubber stopper. The rubber stopper is most likely missing, or damaged. You should be able to take a flashlight and see the plate and the switch. If the hole is plugged up, you will need the brake light switch, if not, replace the plug.

Jun 02, 2009 | 1992 Honda Accord

Not finding what you are looking for?
2003 Honda Accord Logo

Related Topics:

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...