- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You probably turned it off. Most General Motors cars have the setting to turn off or on through the radio control panel Find the configure button on the radio control and scroll through till you find the parking assist page and then reset to on. check with your manuel seeing there are different radio controls depending on options.
Take out 1bolt just above headlight that holds headlight in place.Then to the left of headlight there is a 6inch pin you have to turn clockwise 1/4 turn then pull up and out.Remove headlight,ther is enough wire to put it to the side while you change the left turn signal.When the headlight is out of the way you can see the wires for the turn signal,turn the plug counter clockwise and pull,you will see lightbulb,pull out and change.To install do the reverse in order.
You can try pulling the radio fuse out to see if the radio will re-initialize and spit the disc out...sounds like the mechanism may be jammed in the fully loaded position. If it is a factory radio you may need to write down the security code for the theftlock system before you remove power to the radio so you will be able to use the radio again...the theft lock system locks the radio with a specific 4 digit code that you can set in the event your radio gets stolen...without the code..the radio is rendered useless. If the above power interupt doesn't do it then try removing the negative battery cable and give the radio a "hard" reset. This may cause the radio to kick out the cd.
You can reset the computer by turning the key to the on position. Don't start the engine. Press the gas pedal to the floor and release it all the way. Press all the way to the floor and release. Press all the way to the floor and release. After the third time it will reset the computer. PLEASE RATE! Check the 4 thumbs up. Thanks! Have a GREAT DAY!