Question about 1995 Lincoln Town Car

1 Answer

Driver side window assembly,is there a release so i can pull up the window manually?. the black box(the brain) clicks when you hit the switch,or is the switch gone bad all the other windows work fine?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 55 Answers

Common problem on these cars..switch needs to be replaced..85.00 at the dealer.

Posted on Jul 09, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power windows on automobile


Hey. This is very likely power window switch and second one would be a relay. Look in ovners manual which relay is responsible for your windows and or doors. Let me know if you can't check it out

Mar 14, 2017 | 1990 Acura Legend

1 Answer

Cant find fuse for power windows?


According with the Explorer Owner Guide, I suggest...
1. Check for power on the Light Blue/Black (LB/BK) wire at the master window switch.
2. Check for a good ground to the master window switch on the Black (BK) wire. This wire provides the ground circuit for all of the window motors.

If both of these are good you probably have a bad master switch(drivers master switch).

The Light Blue/Black (LB/BK) wire gets its power supply from the accessory delay relay in the Central Junction Box (CJB) located under the instrument panel. The Generic Electronic Module (GEM) controls activation of the accessory delay relay. Fuse 2.17 is a 15 amp fuse in the CJB which supplies power to the relay. Fuse F1.6 is a 60 amp fuse in Battery Junction Box (BJB) which also supplies power to the accessory delay relay. G400(ground) is located at the driver side rear of the vehicle near the tail light assembly. This connection provides a ground for the master window switch (click image for zoom).

zjlimited_780.gif


For additional details, i suggest try to look and obtain this 2002 Explorer Owner Guide 6th Printing (English).

Hope helps.

Oct 12, 2011 | 2002 Ford Explorer

1 Answer

I need to know the power source for the driverside master window control unit. is it afuse or relay? and where is it and its not in the fusebox underdash---driverside


Hello: The power source is a circuit breaker located in the fuse box under the driver side dash. There are 2 circuit breakers (about 1 inch long and 1/4 inch wide. The top one is for the windows, swap the two breakers, If the windows work then you have a bad breaker. If windows don't work the remove the window switch assembly from the door. on the back side of the window switch assembly you will have a heavy pink wire, that is power to the windows. with a test light check to see if you have power. If you don't the it could be a broken wire where the wire comes from the body to the door. If no broken wire then it could be a burnt fusible link that comes off the starter. ALSO BELOW the window circuit breaker is a black connector that supplies power to the windows, the trunk release and the sunroof if equipped. This information straight out of a 1988 CADILLAC service manual. Check that black connector for burnt wires and make sure its plugged in tight. Do any of the windows work from the individual switches in the door.

Aug 29, 2011 | 1988 Cadillac Brougham

1 Answer

How do you remove the headlight bulb


  • Take the keys out of the ignition and switch the headlights off. Then, open the hood using the primary and auxiliary release latches.
  • 2 Use a socket wrench to remove the two 10mm bolts holding the coolant overflow bottle in place. Pull the bottle out of the engine compartment and set it on the ground (passenger's side bulb replacement only.)
  • 3 Undo the bolt at the top of the air filter box, lift the top open and remove the filter from the engine compartment. Then, undo the fasteners holding the air dam in place and remove it from the filter box (driver's side bulb replacement only.)
  • 4 Pull the entire air box out of the car to access the backside of the headlight assembly.
  • 5 Turn the bulb socket counterclockwise to remove it from the assembly. Then, release the retaining spring, undo the electrical connector and carefully remove the old bulb from the socket.
  • 6 Hold the new bulb by its plastic base and insert it into the socket. Reattach the electrical connector and replace the retaining spring.
  • 7 Switch the headlights on to test the new bulb. If it works, reinstall the air box or coolant bottle and close the hood



  • Dec 04, 2010 | 2000 Nissan Altima

    1 Answer

    How to change cabin air filter in toyota avalon 2002?


    1) Turn off the ignition switch while leaving the wipers in the up position. 2) Open the hood and properly secure it in the open position. 3) Gently pull the rubber cowl seal away from the cowl vent screen. Place your hand underneath the right half of the cowl vent screen and lift straight up, thereby releasing the four spring clips and removing the right half of the screen 4) Remove the water shield. Carefully disengage the two water shield locking tabs and slide the water shield toward the front of the vehicle, lifting the water shield up and away from the vehicle 5) Remove the Passenger Compartment Air Filter, being careful not to allow debris or loose components to fall into the filter housing. Replace the Passenger Compartment Air Filter with a fresh filter and reverse the above procedures to reassemble the vehicle components. �
    I am not sure what time in the year your 2001 Avalon was built but her is the procedure that I just followed: 1. Open glove box and remove contents 2. Remove the three philips head screws along the top inside frame of the glove box. 3. Remove the hex head bolt in the lower right and Philips screw in the lower left side of the glove box frame. 4. Unlatch the black cover plate from the roof of the glove box. This holds an electrical connection and will need pushed up through the hole when the entire box is removed. 5. Pull on the top left side of the glove box to release the pop tab. Repeat on the right side. 6. Carefully lower the glove box assembly. 7. Disconnect the electrical connection to the trunk disable button 8. The entire glove box can now be removed from the area. The door gear assembly does not come off of the box and is easily damaged if attempted to do so. 9. The Cabin Air Filter assembly has a white cover. Pop the tabs on the right and left side and slide the assembly out. 10. Replace the filter in the assembly. Make sure the airflow indicator points down. 11. Re-Install Air Filter assembly. 12. Re-Install the electrical connections remembering to slide the one through the hole in the top of the glove box. 13. Push glove box assembly on pop tabs. 14. Re-Install screws and bolts. 15. Reconnect the black cover plate to the top of the glove box.
    rate it

    Jan 08, 2010 | 2002 Toyota Avalon

    1 Answer

    I have an A4 (technically my wife does) and the windows are electronic. The rear paasenger window (on the passenger side) willcome down but I have to pull it up manually.


    there is a little clip that has fallen out. so the window is not really connected to the window reglulator it is a fairly easy fix at a shop. you would need to get the window pin that is what it is called about a 2 dollar part remove the inner door trim. then the metal cover behind that also you will need to push in the black plastic rivots that can be pushed in with a phillips screw driver hit it hard to push them in. unscrew the door lacth also you will need a t-20 torx bit to release the little cap next to your door handle release the black insert that is attactched to the door handle that releases the door latch. remove door seal (the black metal cover) pull back just enough so you can see the window clip that is the white clamp looking thing its where the window is held in at insert the window clip make sure that the open parts of the clip are opposite eachother push into window hole.It will be at the bottom of the window. make sure the clip straiht up meaning the little slits are straight up and down not pointing toward the front or rear of the car. then reinstall the metal cover with a few of the bolts. firmly but not to hard push window down into the clamp portion of the window regulator till you hear a loud snap make sure the window now goes up in down with switch. then reasemble all back together. thats it good luck hope that helps.

    Sep 09, 2009 | 2004 Audi A4

    1 Answer

    There was an old security system in my truck prior to me buying it and ive had it for six months and today i tried to start it and it wouldnt even make a noise turnig the ignition except for the radio and...


    is the alarm factory or aftermarket?

    If aftermarket - the brain will be under the dash attached somewhere near the steering column.

    Look for an 10 or 12 Gauge YELLOW wire that has been cut.

    This is your starter wire.

    one half goes in one side of the brain, and the other comes out the other side.

    either solder or use crimp-connectors to return this yellow wire back to factory.

    If you no longer require the alarm - you can do the same for every other wire on the brain.






    Here is the color code chart for your vehicle...

    Constant 12V+ Red Ignition Switch Harness

    Starter Yellow Ignition Switch Harness

    Ignition Pink Ignition Switch Harness

    Ignition 2 White Ignition Switch Harness

    Ignition 3 Brown Ignition Switch Harness

    Accessory Orange Ignition Switch Harness (Heat/AC)

    Tach White Coil

    Brake Switch White Brake Switch

    Trunk Release Brown Switch or Driver's Kick Panel

    Trunk Pin DIESEL- Glow Connector Blue behind Instrument Cluster

    Parking Lights Brown (+) Light Switch

    Head Lamp Yellow (+) Light Switch

    Hood Pin n/a

    Factory Disarm n/a

    Door Trigger Purple (-) 4 Pin Black Connector Driver's Kick Panel
    Door Lock Light Blue Driver's Kick Panel w/Keyless Positive

    Door Unlock White W/o Keyless Entry Reverse Polarity (5 Wire)

    Horn Wire Black (-) Steering Column

    Windows Up LF=Blue, RF=Light Blue

    Windows Down LF=Brown, RF=Tan

    Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

    Apr 26, 2009 | 1995 GMC Sierra C1500

    1 Answer

    Hi I went to open the passiger door the alarm went off now every time I try start my 1997 jetta gt the alarm go's off and will not start? how do I by pass the alarm?


    if its an after market alarm u can pull the fuse from the wires that connect to the alarm brain it would be a black box usualy under drivers side dash above ur pedals u my have to remove plastic cover or look 4 a switch or button under dash drivers side turn key on and press button or switch

    Mar 25, 2009 | 1997 Volkswagen Jetta

    2 Answers

    2002 ford mustang power windows


    Not sure what a gem box is but we had the same problem on our 94. It was the plastic drive gear in the lift motor. Auto Zone sold the entire assembly for about $50. Yours might be rebuildable ie. plastic gear replacement. Considering where it is located R&R was relativly easy. Rmember to suuprt the window so as not to change position when you rmove the motor assy. Good Luck

    Sep 07, 2008 | 2002 Ford Mustang

    Not finding what you are looking for?
    1995 Lincoln Town Car Logo

    Related Topics:

    72 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Lincoln Experts

    yadayada
    yadayada

    Level 3 Expert

    75807 Answers

    fordexpert

    Level 3 Expert

    5495 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22133 Answers

    Are you a Lincoln Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...