Question about Ford Freestar

2 Answers

Air conditioning not working abs light on brake lights on engine lights on airbag lights on

Posted by on

  • lexxi747 Jul 09, 2010

    abs light on break lights on engine lights on airbag lights on doors dont lock when cars running no air conditioning

  • lexxi747 Jul 09, 2010

    i was not sure to my conclusion but thanks its the same

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 11,800 Answers

So many lights can mean only one thing: massive failure in the electronics. Since there are so many, and so different,  they don't point to a single cause. Take the car to a shop and have the codes read.

Posted on Jul 09, 2010

Check your fuse box located underneath the drivers side steering wheel and replace the A/C fuse. The fuse box cover lid will show a diagram to what fuse controls the air conditioner system. Open your hood and check your brake fluid level, it is probably low. The best thing to do for the check engine light and ABS lights is to borrow an on board diagnostics scan tool (OBD II) from your local auto parts store (for free) and plug it in underneath the drivers side steering wheel. This scan tool will provide you with the error codes stored inside your vehicles computer. Write these code numbers down and then look in the back of a Haynes repair manual (also avalible at the auto parts store) and match the code numbers up to the numbers found inside that repair book. This will elminate the guess work and pinpoint the exact componat that has failed on your vehicle

Posted on Jul 09, 2010

  • 1 more comment 
  • Anonymous Jul 09, 2010

    The best thing to do for the check engine light and ABS lights is to borrow an on board diagnostics scan tool (OBD II) from your local auto parts store (for free) and plug it in underneath the drivers side steering wheel. This scan tool will provide you with the error codes stored inside your vehicles computer. Write these code numbers down and then look in the back of a Haynes repair manual (also avalible at the auto parts store) and match the code numbers up to the numbers found inside that repair book. This will elminate the guess work and pinpoint the exact componat that has failed on your vehicle

  • Anonymous Jul 09, 2010

    The best thing to do for the check engine light and ABS lights is to borrow an on board diagnostics scan tool (OBD II) from your local auto parts store (for free) and plug it in underneath the drivers side steering wheel. This scan tool will provide you with the error codes stored inside your vehicles computer. Write these code numbers down and then look in the back of a Haynes repair manual (also avalible at the auto parts store) and match the code numbers up to the numbers found inside that repair book. This will elminate the guess work and pinpoint the exact componat that has failed on your vehicle

  • Anonymous Jul 09, 2010

    The best thing to do for the check engine light and ABS lights is to borrow an on board diagnostics scan tool (OBD II) from your local auto parts store (for free) and plug it in underneath the drivers side steering wheel. This scan tool will provide you with the error codes stored inside your vehicles computer. Write these code numbers down and then look in the back of a Haynes repair manual (also avalible at the auto parts store) and match the code numbers up to the numbers found inside that repair book. This will elminate the guess work and pinpoint the exact componat that has failed on your vehicle

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 chevy trailblazer when I turn on the air con my dash lighs for ABS and Brake come on, my cruise goes off and the air con will not work.


Have you had the vehicle checked for DTC'S - diagnostic trouble codes ? I would start there first . Battery , charging system all good ? What computer , the ABS has a control module all to it self . The Air con has a relay in the under hood fuse box controlled by the PCM / engine computer . If there is a problem with ABS , The EBCM - electronic brake control module will turn on ABS and the red brake light .
A low voltage condition could cause this problem , but I would expect more of the lights to be lit on the dash . Including the check engine light , battery light . This are not connected , Power or ground wise . Have the vehicle checked for codes , that should be the first place to start any diagnostic's always !

Dec 02, 2016 | 2004 Chevrolet TrailBlazer

1 Answer

Air bag light stays on also alternator and abs 3 lights at the same time, I want how to reset them


what is causing my airbag light, abs light and battery light to ...

https://answers.yahoo.com/question/index?qid...
Jul 12, 2014 - My battery light stays on sometimes it might blink on and off. But the problem is i can be driving my car and my airbag light and abs light will ...

Electrics HELP! Engine management light, Brake, Airbag, ABS, EPS ...

www.civinfo.com > ... > Bugs, faults and irritations
Feb 12, 2012 - 18 posts - ‎5 authors Airbag light. ABS ALSO - the speedometer, rev counter and engine temp ... 30 mins driving (apart from engine management light which stays on). ... I have ruled out problems with the alternator and the relays - they're all fine.

airbag abs srs light diagnose without a scanner air bag ...

? 4:14
www.youtube.com/watch?v=tIBjIr9a42w
Feb 6, 2010 - Uploaded by vehix411 airbag abs srs light diagnose without a scanner air bag ... Alsowhen I tried the scan plugging the paper ...

Oct 30, 2015 | 2010 Ford Escape XLS

1 Answer

I have 4 dash lights on - abs, brake, airbag and traction control as well as the speedo stopped working, the heated seats won't turn on-what might this be?


the ABS and traction light are on due to a failure with the speedometer. I SUSPECT A SEED SENSOR would be the culprit as if speed is not sensed from a wheel (RF / LF /RR / LR) the ABS module with be disabled and would lite the ABS and Brake light. the airbag and heated seats are on separate circuit. the air bag should be diagnosed with a handheld device ( go to advance auto or similar type parts store)n they will read the code.. post the code and I may be able to help ... also ask em to get the ABS / Brake codes a ell

Sep 27, 2014 | 2007 Ford Five Hundred Limited Sedan

1 Answer

How to reset abs light in a subaru forester


The ABS light on your vehicle will self-reset, once the condition causing the light to illuminate is rectified.
Reasons for the ABS light coming on are:
  1. Worn brake pads;
  2. Worn calipers (beyond tolerance);
  3. Defective ABS unit;
  4. Low brake fluid level;
  5. Defective master cylinder;
  6. Brake fluid leak.
It is important that whatever condition is causing the ABS light to illuminate is corrected as soon as possible, as it indicates a potential hazardous condition exists with your vehicle.

Jun 29, 2012 | 1998 Subaru Forester

1 Answer

Break lights on


Check the abs module for trouble codes. You will need a high end scan tool or a specific abs code reader to do it. The brake light is on likely because the abs light is on. The airbag light might be a different story. Does the horn and cruise work?

Jan 23, 2012 | 1999 Dodge Caravan

1 Answer

Air bag and abs lights staying on


If the Airbag light is on, it indicates that a electronic fault is stored in the memory for the airbag. You will need to have a diagnostic check done to pinpoint what the fault is, have it sorted out and only then can the fault be cleared so the light will go off. The ABS light also indicates a fault on the electronic side of the braking system. If the light comes on as you start the vehicle this indicates that there is an open circuit in the wiring or that the ABS control unit itself is faulty. If the light only comes on once the vehicle is in motion, this indicates that a wheel speed sender is incorrectly fitted or dirty and not sensing the ABS Rotor on one of the wheels. If a CV joint has been replaced, the joint may not have an ABS ring fitted on it.[front] At the rear the ABS pick up is fitted on the inside of the brake discs and must be fitted to the new disc when replacing discs.

Jun 02, 2010 | 1998 Audi A4

2 Answers

Sensors


disconnect your neg. cable for about 30 seconds

Dec 09, 2008 | 1998 Audi A4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...