Question about 2004 Toyota Sequoia

2 Answers

My VSC TRAC, TRAC OFF & brake light is on in board

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I have a 2004 sequoia with the same problem. VSC TRAC, TRAC OFF & brake light comes on at the same time. Sometimes just the brake light and other times all three. Sometimes no lights. Does anyone have a fix?

Posted on Jul 28, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Wow...I just did a search. Have a 2004 sequioa and the same thing is happening to me. Did you solve your problem?

Posted on Jul 15, 2010

  • spulers Nov 05, 2010

    It's probably an O2 sensor. Take it to Autozone and have the code read or buy a code reader for $40-$60 and do it yourself. It's fairly easy to replace them... at least the rear ones. The front ones tend to seize if there's alot of rust.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The vsc trac sensor location on a 2002 Toyota sequoia


A speed sensor failure in the rear axel housing has damaged friction plates in the differential (limited slip). This axel should have had oil serviced at 80,000 miles

Jun 02, 2017 | Toyota Cars & Trucks

2 Answers

Why are VSC, Engine, & TRC Off lights always on? I've tried to change the air filter with a new one. Now the car can accelerate only until 50 km/h, then car will stop. It seems that the car is choking


Check engine light, VSC TRAC & TRAC OFF lights - Toyota ...

www.toyota-4runner.org/.../4164-check-engine-light-vsc-trac-trac-off-li...
Jun 6, 2004 - I just bought it, and a few days later the check engine light, VSC TRAC, and TRAC OFF lights all came on. I took it to a dealership and was told ...

VSC and TRAC OFF lights came on? - Scion xB Forum


Nov 25, 2015 | Toyota Cars & Trucks

1 Answer

VSC TRAC, trac off AND cHECK eNGINE LIGHTS, 2006 toyota sequoia


  1. Traction Control System Problems - Car Forums and Automotive Chat ...

    www.automotiveforums.com > ... > Toyota > SequoiaTraction Control System Problems Sequoia Car Forums. ... The VSC/ATRAC indicator lights are staying on and the system will inadvertantly ..... giving a bad reading following the replacement of the steering angle sensor with a new one.

Aug 17, 2014 | 2006 Toyota Sequoia

1 Answer

Vsc trac off check engine


Check for codes & diagnose the new problem with the VSC

Tune-Ups ! --remember those back in the early 1980's, some
25 years ago,your not up to speed,you only get spark plugs

Mar 26, 2014 | 2006 Toyota Camry

1 Answer

I have a 2001 Sequoia replaced connectors to battery. Now E brake light ABS light Trac Off and VSC Trac light are on. I disconnected ground and let it sit. Had code ran and it said open closed circuit abs?...


More than likley its your VSC computer (VSC Trac, VSC Off, E brake and ABS brake lights all lit). This problem has been sited on other Sequoias that had the TSB brake caliper/rotor upgrade (recall) and that more than likely the VSC software or computer was not updated to meet the demands of the newly installed brake upgrade.

Nov 19, 2013 | Cars & Trucks

2 Answers

Check engine light and vsc trac off lights stay on. Cannot turn svc off by pressing button on Dash


Hi, have you scanned the vehicle to see why your check engine light is on? IF no, you need to. Toyota/Lexus computer system illumniates both engine light and VSC lights whenver a fault occurs in either unit. VSC or stability control is like trac-control or ABS braking system. Get car scanned and make sure all computers are scanned for additional codes, repair them first reset lights and test drive. ON a side note, fixing check engine light will usually take VSC light away also, however sometimes the VSC system will glitch out and a Steering Angle relearn is necessary, it takes about 3mins to perform and a good quality scan tool with 2004 current software. Good Luck.

May 16, 2011 | 2004 Toyota RAV4

2 Answers

Toyota Camry V6 2003 with Check Engine, Trac Off and VSC lights on. Went to AutoZone and got code P0430. Can anyone assist with what to do next? Thanks in advance.


hey man sorry to tell you this but u will need a cat bank 2 its easy to take out it should only be 5 12mm nuts on the top and 2 14mm bolts on the bottom and some that r holding on to the trans.

Dec 13, 2010 | 2003 Toyota Camry

1 Answer

03 toyota 4 runner vsc trac and trac off light are on, what´s the problem with?


VSC stands for vehicle stability control and trac is traction control they are incorporated into the ABS system all receive signals from the wheel sensors you must use a digital ohms meter to find the one reading different and replace it in some cases you might find bad connections at the plugs.in any case your brakes will work fine you just wont have ABS braking or traction control

Nov 13, 2010 | 2003 Toyota 4Runner

2 Answers

The vsc trac and vsc off, plus the check engine just came up on the dash board. What do I do to make them disappear? Its a toyoto 4runner 2004.


For some reason on Toyota and some Lexus vehicles certain check engine light CEL issues also result in the ECU lighting up the vsc trac and vsc off lights. The ECU actually switches these anti skid and anti lock brake systems off and the lights are to remind you that they are disabled. 1) Check that the fuel cap is on securely 2) Check the oxygen sensors on the exhaust, check that connections are clean and there are no missing wires. 3) Have someone check the on-board diagnostic codes if the CEL is still on

Aug 20, 2010 | 2003 Toyota 4Runner

Not finding what you are looking for?
2004 Toyota Sequoia Logo

3,238 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...