Question about 1992 Buick LeSabre

1 Answer

Oil pressure gauge acting up. acceleration causes it to almost max out/ go over to the right? could it simply be that this is old as hell and it is just that?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 67 Answers

Probably needs a new oil pressure sender. replace it and keep driving....
good luck

Posted on Jul 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What to check when oil pressure gauge flucuates while driving a jeep cherokee


To verify there is a problem, remove the oil pressure sending unit, replace it with a test gauge, start the car, idle, accelerate etc and watch the gauge for any abnormal variations it should react to evry change in acceleration and not be below the minimum or above the max as per the service specs.

Aug 14, 2014 | 2000 Jeep Grand Cherokee Laredo

1 Answer

Oil pressure gauge


oil pressure sensor, low pressure due to dying pump. or blown gasket causing the pressure to leak out. Check the easy ones first like the sensor. Good luck

Nov 08, 2013 | 2004 Dodge Ram 1500

1 Answer

Oil pressure gauge high 1987 chevrolet blazer 350 5.7 liter


YOur best bet on a truck that old is to install a mechanical oil pressure gauge. They are available at any auto parts store or even Target or Walmart. Just buy the kit and follow the instructions. Mounting and routing the oil line is the hardest part.
It would be very unusual for the oil pressure to be maxed high in a 350 that is over 20 years old so i have to think the issue is the guage.

Feb 10, 2012 | Chevrolet Blazer Cars & Trucks

2 Answers

CAN A OIL PRESSURE GO DOWN TO 25 WHILE IN GEAR AND 40 WHILE HITING THE GAS IT SHOLD STAY AT 40 45 NORMALY NO MATER WHAT RIGHT ITS A 2000 DENALI 4X4 I DO HAVE ISSUES WITH 02 SENSORS IS THAT THE REASON WHY


Oil pressure is not constant, while idiling the pressure is less than when accelerating. Usually when the oil pressure gauge fluctuates it is a sign of low oil level.

Feb 04, 2011 | 2000 Chevrolet Tahoe

1 Answer

2005 nissan armada oil gauge


no,,, fluctuations mean =low oil pressure,oil level low,oil old or too thin viscotly,oil pump loosing or not develloping the correct pressure
pressure release valve spring weakened

Jul 06, 2010 | 2005 Nissan Armada

1 Answer

The oil pressure gauge in my 2002 Duramax Diesel engine PU increases during acceleration and returns to normal following acceleration. Why would this happen?


That is normal. As you accelerate and rpm's increase the oil pump rpm increases. I think the oil pump runs 1 to 1 or 2 to 1 with the crankshaft rpm. Check the oil and inspect for any visual leaks if the gauge does not operate like that consistently. If it is intermittent or it just started acting that way, the sender my be bad. Other than that any Chevy Dealer will say that is normal.

Jun 01, 2010 | 2002 GMC Sierra 2500HD

1 Answer

Oil pressure drops, metal shavings, and somehow my oil level incr


My truck does the same thing, pressure never drops to 0 but drops low, replaced the oil pressure sensor and same thing happened. My oil is always black and has a lot of metal in it, next time you change your oil, pour a quart of transmission fluid into the oil and let it run for 10 minutes or so, this should thin out the oil and possibly unclog some of the ports that may be gummed up. What could have happened with the dipstick is that the old oil was too nasty to drain all the way, with the fresh oil it could have thinned out and raised the level, try the transmission fluid trick and see what happens, next possibility is to have the engine scoped to see whats going on inside

Apr 21, 2010 | 1997 Chevrolet S-10 Pickup

1 Answer

Oil pressure gauge is showing max pressure. Figure that sensor is bad???


I agree with you, replace the oil pressure sending unit.

May 07, 2009 | 2004 Chevrolet Tahoe

1 Answer

Oil pressure gauge on max - running rough


install a fresh set of plugs. make sure to check them for proper gap, even if they are " pre-gapped "


hope2help shack

Apr 19, 2009 | Jeep Grand Cherokee Cars & Trucks

1 Answer

1992 jeep wrangler oil pressure goes off scale while accelerating


try replacing the oil filter and oil make sure u use the right grade oil for it if it still does it u need yo go to mechanic or if u have one connect a external oil pressure gauge to the engine to check if the car gauge is reading correctly if it is reading right then the oil pressure releif vale is stikking

if the car gauge is reading wrong change oil pressure sender

Dec 20, 2008 | 2002 Jeep Grand Cherokee

Not finding what you are looking for?
1992 Buick LeSabre Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...