Question about 1994 Chrysler LHS

2 Answers

The windshieldwasher light comes on after about 10 seconds after start, it is full and connections are good could this be a trouble signal for something else? it is on a 1994 chrysler lhs

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

Check or replace the level sensor in the washer fluid tank.

Posted on Jul 08, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

How to make sure this is -20 below for windshield fluid

Posted on Sep 06, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 volvo glt. TPS


When you turn the vehicle on the PCM does a check on the system. For most sensors, it checks power and ground. Turns the light off if all is good. Since yours comes on after a few seconds, you need to check the signal return wire. Wires tend to break right at the plug. You'll need a volt/ohmmeter to check it. Also check the continuity of the wire from the TPS to the PCM. Anything over 5 ohms needs replaced. I just cut the wire and run a new one.

Sep 24, 2016 | Volvo S70 Cars & Trucks

2 Answers

?why is there no spark on spark plugs


What is year--make--model?
Usually if no spark, no fuel pressure, and especially no injector pulse, I check for rpm signal. The rpm signal comes from crank sensor. Don't replace anything unless your testing points in that direction.
I have to ask, how long since a tune-up?
Are there any applicable trouble codes?
Make sure battery has a full charge and battery connections all good.

Apr 12, 2016 | Cars & Trucks

1 Answer

Why do I have an intermittent problem with ABS and power steering lights?


Bad or loose intermittent wire connections to and from sensors. Some unauthorised mechanic has been working on the car? Take it back and talk to the service manager, or the shop owner.

Apr 14, 2015 | 2010 Volkswagen Polo 1.2

3 Answers

Turn signals work inconsistently. fuse and bulbs fine, same with hazards


Try replacing your turn signal flasher if all bulbs and fuses are good.

Jul 02, 2014 | 1998 Chevrolet S-10 Pickup

1 Answer

2000 Dodge stratus - runs ok but at times will "chug" or misfire driving down highway - think its an electrical issue as it will almost "act up" when using cruise, turn signals, air conditioning, etc. ALSO...


You should still take it and get the computer scanned for trouble codes.
If the check engine light comes on for more than 10 seconds there should be codes set.

Jan 18, 2013 | Cars & Trucks

1 Answer

2000 pontiac grand am ,car cuts off on road .security.light comes on and you wait 5 min .sec.light goes out car will crank and go 2 to 10 miles .then problem starts over again.in code history in obd2 tool...


Here's a trouble shooting guide.Trouble Code: P1632

Theft Deterrent Fuel Disable Signal Received

Possible Causes:


Perform the Powertrain Onboard Diagnostic System CheckPassword Learn Procedure - Attempt to start the vehicle (leave the ignition "on"). The Theft System telltale will flash for 4 seconds and then remain "on" for 10 minutes. Theft System Learn Mode will display Disabled on the Scan ToolTurn the ignition "off" after the Theft System telltale goes "out".Repeat steps 1 and 2 two more times. After the Theft System telltale turns "off" on the 3rd key cycle, and Theft System Learn Mode will display Enabled on the Scan Tool, attempt to start the engine. Once the engine starts the password is learned.

Oct 27, 2012 | Cars & Trucks

1 Answer

03 Taurus, battery light comes on. R&R bad alt &


You may have a a/c voltage leak comming from the alternator..If its a rebuilt alternator sometimes you get a bad one ..But make sure all your connections are good ecspecially the small wires coming out the back ..These are the field and sensor wires..Plus make sure all your grounds on the vehicle are not broken or missing..You can have good voltage but it may have a drop going to the computer because of a ground and cause the light to come on

Sep 15, 2011 | 2003 Ford Taurus

1 Answer

My '93 suzuki sidekick automatic transmission 4 wheel drive after warm up "overdrive off" starts flashing on and off and when on the drivetrain stops working


The O/D light's flashing means there is some kind of transmission trouble.

The codes are..


Trouble Code (1) Probable Cause
12 ............................... System Operation Normal
21 ..................... No. 1 Shift Solenoid Open Circuit
22 .................... No. 1 Shift Solenoid Short Circuit
23 ..................... No. 2 Shift Solenoid Open Circuit
24 .................... No. 2 Shift Solenoid Short Circuit
25 ............................. TCC Solenoid Open Circuit
26 ............................ TCC Solenoid Short Circuit
31 ............ Vehicle Speed Sensor Open Or Short Circuit
32 ................ Throttle Position Sensor Short Circuit
33 ................. Throttle Position Sensor Open Circuit
34 ................ Defective Park/Neutral Position Switch
36 .............. (2) No Signal-Both Vehicle Speed Sensors
(1) - Check listed component for probable cause. Also check wiring and connections of specified component.
(2) - No signal from both transmission and speedometer mounted vehicle speed sensors.

If a trouble code is present, OD OFF light will flash a trouble code. The number of flashes will equal first digit of trouble code. After a one second pause, second digit will be displayed. If more than one trouble code is present, next trouble code will be displayed after a 3 second pause. Smallest number trouble code will be displayed first. Trouble codes will be repeated.

Hope this gave you some insight on the issue.

Mar 08, 2011 | 1993 Suzuki Sidekick

1 Answer

My daughters 2005 Ford Taurus went dead after leaving her lights on accidently after only 10 minutes. Someone jumped her and all was well. Since then ,every once in a while, ALL of her signal/trouble...


if lights flattened battery after 10 mins then its a new battery as no reserve amperage ,as for the lights on the dash i have no idea to be honest without a play with it

Nov 30, 2010 | 2005 Ford Taurus

Not finding what you are looking for?
1994 Chrysler LHS Logo

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...