Question about 2005 Ford Expedition

Open Question

2005 Expedition hesitates when pushing on the accelorator

After driving my 2005 Expedition for about 4 hours, it starts to hesitate when i push on the accelerator. If I let it sit for 20 minutes or so, it seems to work just fine. This has happened to me a couple of times. I have replaced the fuel filter and used some fuel additives just in case it was some bad fuel. Had a mechanic run a diagnostic but didn't come up with any codes, also had him run a pressure test on injection system, he said it was within spec. I suspect a fuel pump problem, but not sure

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 99 Expedition - Stutters and loses power when accelerating

My was doing the same thing, it was an EGR valve and a misfire on the #2 cylinder which required a new spark plug and a coil pack
t

Posted on Mar 13, 2009

Ad
  • 1 Answer

SOURCE: 2002 VW Passat- Hesitation

If you haven't already you should check your spark plugs to see if you a bad plug or possibly a bad coil pack.

Posted on Nov 19, 2008

  • 120 Answers

SOURCE: 1991 chevrolet silverado truck engine hesitates,

Trouble Code 44 indicates that the O2 sensor is showing a persistently high exhaust oxygen content (lean), despite the efforts of the ECM to increase ...
Code 42 : Electronic spark timing (EST) circuit fault

Posted on Feb 18, 2009

  • 5 Answers

SOURCE: 2002 ford windstar..hesitates or stumbles under load like hill

did you have code cleared and also try fuel injector cleaner, as a clogged or dirty injector can show as a misfire,

Posted on Mar 16, 2009

MantoothAZ
  • 8 Answers

SOURCE: 2005 ford ranger fuel pump relay gets hot and engine dies

Like Laurie Mack said. It is the inertia switch below the glove box. Here is some funny information. DON'T change the fuel pump first. Interesting fact: I bought the new inertia switch from Ford and the install instructions that came with it said to install the switch in the protected area to the right where the fuses are. It is like Ford knows it was a dumb place to put the inertia switch, but they won't let you know until after you buy a new one. I have read at least 20 other people on here that had the same problem I just had.

Posted on Apr 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hesitation on acceloration po406 code


P0406 Exhaust Gas Recirculation Sensor A -Circuit High

Dec 22, 2012 | 2005 Chrysler 300

1 Answer

B2200 jerks and hesitates


Check fuel pressure. If good, rebuild carb.

Nov 12, 2017 | 1988 Mazda B2200

1 Answer

Two questions how do you change a low beam lightbulb in a cadillac srx 2005 and why in early morning starts does the same car hesitate to pull away?


1. Remove front wheel well front half splash guard, each side. There are about 2 screws and the guard pulls forward to seperate from the rear half.
2. After removing the splash guard, you can access one screw that attaches the front fascia, each side.
3. Then about 6 plastic push pin type screws along the bottom, underneath.
4. About 5 push pin type screws on the top.
5. Fascia should then simply pull forward. It is a bit bulky and an extra pair of hands is helpful.
6. Then there are 3 screws to remove the headlamp assembly. Unclip the wiring harness.
7. Then 4 screws to remove the bulb access cover plate.

Dec 24, 2010 | 2005 Cadillac SRX

1 Answer

I have a 2003 ford expedition starting problem


hook up a fuel pressure guage and check it at start up, key on pressure should build and hold , if not check it could be regulator of leaking injector

May 20, 2010 | 2003 Ford Expedition

1 Answer

Pontiac 200 Grand Am 3.4L V6 3000+ RPM


have you checked the engine for vacume leaks or advanced timing or even sticking accelorator cable or linkage? these are always a good place to start for excess acceleration

Apr 30, 2009 | 2000 Pontiac Grand Am GT

1 Answer

1997 Cavalier while you driving hesitates and stall


I had to replace my Idle Air Control Valve and Throttle Position Sensor.

Apr 28, 2009 | 1997 Chevrolet Cavalier

1 Answer

Hesitation and jerking


tcc sylinoid is bad go to autozone let them check with there computer its free to check it same problem for lots of 04 05 impalla andmonty owners

Apr 22, 2009 | 2005 Chevrolet Impala

1 Answer

1998 plymouth breeze


Does it hesitate no matter how far u push the gas pedal?

Aug 14, 2008 | 1997 Plymouth Breeze

Not finding what you are looking for?
2005 Ford Expedition Logo

Related Topics:

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5579 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...