Question about 2004 Ford Freestar

Open Question

Freestar abs 04 freestar abs light on codes c1095 b1342 not real sure where to start, any ideas? checked fuses/relays already wifes van I don't know it to well

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 295 Answers

SOURCE: AFTER HAVING THE 2000 LINCOLN LS TESTED GOT THE

I would take the car right back to the shop that cleared the code. There was a 50/50 chance of clearing the codes. The good thing is now the shop will be able to pin point the failure with the fresh code. Most of the time the abs controller is going out. The controller also might not be readiing the tire sensor . If one sensor goes out the abs light will come on. The controller could be working fine and one of the sensor has to be replace. That is the cheapest cost. The abs controller and abs hydraulic controller is big bucks to replace , The part is around 1500 bucks. The tire sensor are around 25.00 35.00 each.

The manufacture has made the vehicle to where if the abs system is not working correctly then the brake system will automatically work as normal brakes with out the abs system.

Yeah its a pain in the you know where to take back but I would fight tooth and nail with the shop not to charge you any additional check out time. If the shop stands behind there work they will not charge you additoinal check out time.

Good Luck

Posted on Jul 26, 2009

Ad
  • 32 Answers

SOURCE: 2005 ford freestar wont start

Check the battery. If the battery is weak all you will hear is the starter soliniod clicking. Make sure that all of the cables have good clean tight connections.
Most Auto parts stores can test your battery to see what shape it is in.

Posted on Sep 19, 2009

  • 1 Answer

SOURCE: 04' Ford FreeStar - The Radio Stay On When Van Is Off

I have the same problem - the radio and the lights for the power door locks stay on even when you take the key out and open then drivers door which is supposed to turn them off automatically. I have noticed that when you turn the key back to the accessory position and then off everything shuts down.

Posted on Dec 19, 2009

  • 252 Answers

SOURCE: i have an 2004 ford

code b1342 means the ecu in your vehicle is faulty call the dealer ship with last 8 digits of vin to get correct ecu part # and pricing new your looking at 800-1400 or go to www.everdrive.com when you get info from dealer they have 3 year unlimited mile warrenty and probably cost 280 bucks

Posted on May 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

91 gmc 3500 van brake light sensor comes one stops shifting right


you need to know witch ABS code and PCM code first before any repair.
hope it helps

Mar 17, 2014 | GMC Cars & Trucks

1 Answer

2004 LINCOLN LS TRACTION CONTROL LIGHT FLASHING & ABS LIGHT ON & BRAKE LIGHT ON. DTC CODES B1342, C1730, C1998.


first check brake fluid level then you will have to test the wheel speed sensors that the codes refer to. when there is a sensor problem it will activate both the abs and traction control lights. the red brake light comes on when there is low fluid condition(leak),worn brakes that need servicing. also if there is a abs module problem it can set codes. you need to know what the codes mean this is a starting place to diagnoise.

Mar 06, 2014 | 2002 Lincoln LS

1 Answer

Code B1342, U1009, U1027, U1059


What your doing continuing to drive it with ANY
Transmission issues,will ruin the trans & most likely
has already

At the very least your going to have to remove the valve body
& clean it & update it

May as well just pull the unit & rebuild it ,seeing as it is
a transaxle & the one out there with the most problems
& shortest life span

May I suggest you sell it & stay away from vans forever

I know they are popular & having owned a trans shop, i know
there are too many issues to own one & they are not a safe
vehicle if you get in an accident,so much so, I won't ride in one

I only drove them to road test after a trans repair, when i had
the shop & never since

Aug 27, 2013 | 2004 Ford Freestar

1 Answer

I need fuse bx information for 98 mercury montaineer i don't have owners manual to check fuse diagram my abs light comes on and i have power going to factory towing package


If the abs light comes on than the fuses are good. If the abs light did not come on when you turned the key on than I would be suspicious of a fuse or relay failure. The first thing you need to do is have the abs module scanned for codes. You local auto parts store may do this for you for free otherwise you can either spend a couple hundred dollars on an abs scan tool or pay for an abs diagnostic charge at your local auto shop. Once you know what code or codes are causing the light to come on you will have a much better idea opt what the problem is. To things that will help you out. 1. If the abs light comes on when you start the car and then goes out until your start to drive than it is likely you have a speed sensor that is going bad, or possible a wheel bearing that is getting sloppy and causing excessive air gap. 2. If the light comes on and never goes out than the abs system is failing it's self test. The first thing I would do is ohm check all four wheel speed sensors (1998 might only have three, one on each front wheel and one in the rear differential). If one is open or low on resistance than it is bad. Hope that helps.

Jul 03, 2011 | Mercury Mountaineer Cars & Trucks

3 Answers

Ebcm motor relay circuit problum


Motor relay circuit this is for the ABS, you will need ot restore the third eye brake light and check fuse in the engine junction fuse box, (cigarette lighter fuse) make sure it didnt open

May 15, 2011 | Chevrolet Tahoe Cars & Trucks

1 Answer

2000 LINCOLN LS, WELL WHEN THEY DID THE TEST THE CODE WAS B1342 ABS MODULE, THEN IT WAS TEST DROVE & EVRYTHING WAS OK BUT WHEN I DROVE IT ALL THOSE LIGHTS CAME BACK ON & ARE STILL ON, ....REPLACE...


MAKE SURE YOUR CAR BATTERY AND ALTERNATOR IS IN GOOD OPERATION.HAVE THEM TESTED.I HAVE SEEN A CAR WITH ABS AND AMPS LIGHTS ON.THE ALTERNATOR WAS NOT PUTTING OUT ENOUGH VOLTS TO RUN THE ABS BRAKE SYSTEM. IF ALTERNATOR AND BATTERY IS GOOD.I WOULD REPLACE THE ABS RELAY FIRST.ITS GOES BAD CAUSE THE ABS BRAKES NOT TO WORK.IF ABS RELAY IS GOOD.THEN IT HAS TO BE ABS MODULE GOING BAD.IT HAS TO BE REPLACED.

Jul 26, 2009 | 2000 Lincoln LS

1 Answer

Abs light is on


The problem may be that you just have a faulty wheel sensor that is sending false signals to the your on board computer.
You will need to get the ABS computer scanned. Check all fuses first before getting it scanned.

ABS light comes on with ignition then should go off when you start the car.
If abs sensor does not turn off after disconnecting the battery, then there is a real problem, a faulty sensor or ABS malfunctioning.
When the ABS led comes on immediately after you start the car and stays on usually is one of the relays.
The main one is called surge arrester relay, if it is faulty usually there have been anovervoltage.
There should be two more, usually located behind the black plastic cover of the ABS.
Testing and changing the faulty relay can fix the problem.

If light turns off on startup, and comes back on when you reach some speed, usually you need to check the wheel sensors. You test them unplugging the sensor located behind the wheel and testing it for continuity with a multimeter.

Jul 17, 2009 | 2005 Ford Freestar

3 Answers

04' Ford FreeStar - The Radio Stay On When Van Is Off


Nothing wrong with it. When you remove the key, it stays on for about 20 minutes. It gives you time to finish listening to your radio and roll up the window. Once the driver door is open, everything shuts off or if 20 minutes has passed. 
 
 

Mar 28, 2009 | 2004 Ford Freestar

2 Answers

When you brake and the van is near a complete stop the brakes let go a little then kick in hard. Sounds almost like when you start the vehicle and the ABS light goes out


As I already knew one of my rear wheel bearings was going, ie lots of noise above 60km, vehicle has 250K KMs, I read my service manual and it indicated most probable one of the bearings reading zero under 5 KM per hr causing full pressure by the ABS to be exerted on the rear brakes. Works fine with the ABS cct breaker pulled. Solid brakes with ABS above 5 km/hr. No ABS light on, do not have an ABS code reader only the basic GM code reader. Vehicle is 1992. Thanks Anyway

Jul 21, 2008 | Pontiac Trans Sport Cars & Trucks

Not finding what you are looking for?
2004 Ford Freestar Logo

Related Topics:

319 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5516 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...