Question about 1995 Chevrolet C1500
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: want to change torsion bar keys
The torsion keys are supposed to give 2-3" additional drop vs.the "free" method. I know adjusting the torsion bars kills the ride but how bad is it and how far can you go???
Believe, 15/16 socket would be the correct size. Also, be aware that they are probably pretty rusted and VERY hard to turn at first. Air tools do no good, so you'll need a 1/2" drive breaker bar and a long pole to put on the end. This is the fastest way to get the torque you need to break those suckers loose.
I suggest measure and writing down the height about 3-5 spots on each side, whether it be the frame, body, or whatever. Crank each side a few FULL thread turns, then measure again. Once you get about the height you want, measure both side to make sure they're equal. After that, it's best to get a full alignment as some of the suspension will now be at different angles (of course).
Posted on Apr 19, 2009
fuel pump is on the engine or either in the gastank follow the fuel line chevys are the easiest auto to work on a new i think yours is in your tank remove both straps and remove hose to filler neck. the fuel **** is in the center of th tank removed by a lock washer system holding the pump in also be careful that you follow the fuel lines though and that you remove bolts that hold the fuel ine to the frame and up to the engine or fuel filter then engine an up to the carb that way you can lower tank without bending fuel line any way however you took it off put it back if a human put this thing together then a human can fix it
Posted on Jun 09, 2009
Jack up the car remove wheel remove brake caliper and remove rotor rent a ball joint press remover and installer tool (at schucks you get money back when you bring it back) if it's 4 wheel drive you will have to remove the axle shaft next pull the snap ring off on the top side and put tool on the lower tie rod end and press out, next do the top press out top joint next sand ball joint sockets so it is clean lube with WD-40 next press in top ball joint and then lower ball joint. In this order otherwise you will have to un install the top ball joint by removing the pin then nut.
Posted on Aug 19, 2009
Tips for a great answer:
Mar 21, 2017 | 2001 Chevrolet Silverado 1500
Feb 19, 2016 | Cars & Trucks
Jul 18, 2012 | 2004 Chevrolet Silverado 1500 Crew Cab
Jul 25, 2011 | Chevrolet Chevy Cars & Trucks
Jan 28, 2011 | 1999 Chevrolet Silverado 1500
Mar 14, 2010 | 1999 Dodge Ram
94 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: