Question about 1995 Honda Accord

1 Answer

Replaced starter, now it turnsover but wont start. tinkered with fuses a little and it will start is fine 4 the day but when it sits overnight it wont start again help

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Contributor
  • 274 Answers

Try replacing fuel-felter,And you may want to replace battery

Posted on Jul 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Chevy S10 4.3L starting Problem... My truck doesn't start after it has sat for a while, usually after it sits overnight. Typically it starts after a little starting fluid.


It sounds like the fuel drainback valve is allowing fuel pressure to bleed off overnight. In some cases you can add an external one, in others a new fuel pump is required to be installed, check with your favorite mechanic.

Mar 03, 2015 | Cars & Trucks

1 Answer

Turns over but wont start


check the ignition control module

Jul 08, 2010 | 1995 Honda Accord

1 Answer

Have a 01 Tahoe with new red top and fairly new alternator. It charges at about 14v. But if I leave the Tahoe set for a week, it wont start.Where do I look for a voltage leak. The Tahoe seems to be working...


Start with the basics; Is the reason the car does not start is that the battery is discharged after a week of sitting or a case that it won't start without a jump although the battery is still good. If the car just does not start after sitting then try the following; Pull the negative battery cable and let the car sit overnight. Reconnect the cable in the morning and see if it starts. If it does then you are looking for something that is pulling current from the battery. Could be lots of things; light on in the glove box or trunk, a short in a wire, etc. You can try pulling a couple of fuses each evening and in the morning, replace the fuses and see if the car will start after sitting. If it continues to discharge the battery then try another set of fuses. The day it starts after sitting then you have narrowed the electrical system that is discharging your battery. Focus on those systems

Feb 21, 2010 | 2005 Chevrolet Tahoe

3 Answers

My 98' chevy c1500 5.7l vortech pick up truck wont start! It turns but wont catch. Sounds exactly as if i was to run out of gas. New battery, alternator is fine, starter is fine, recent tune up, changed...


Can you hear the fuel pump in the gas tank running for a few seconds when you turn your key to the on position without starting the engine? If you do not hear it something is wrong! If that's not the issue this could take a little while to pin down so feel free to contact me: over4dy@yahoo.com

Nov 07, 2009 | 1998 Chevrolet C1500

1 Answer

Saturn sc2 wont start


You most likely have a burnt terminal in your Inside fuse block.Easiest way to check this is to remove the console trim panel next to the drivers side front of console,just pulls loose.Then while trying to start the engine reach down & wiggle the wring going into the front 68way connector.If it takes off & starts to crank you have a burnt terminal in the fuse block.If you remove the front connector (68 Way) there are 2 of these 68 ways in that block.You can look inside at the male terminals you will see one terminal with plastic melted around it.If you see this,that''s your problem!! You will need to find a used Fuse block at junkyard with same Part #.Very important to get same part!! Hope This helps

May 14, 2009 | 1995 Saturn Sc

1 Answer

Car wouldnt start replace ignition switch, clutch switch then starter worked for 2 days now starter clicks but wont start left overnight car starter but when turned off wont restart


sounds like there is a dead spot in the starter. i think the other stuff may not have needed to be replaced. when the car won't start, have someone try to start while you TAP the starter with a hammer.- probably the starter, though.

May 14, 2009 | 1995 Saturn Sl

1 Answer

Hi i have a peugeot 306 lx auto wont start


are the spark plugs sparking ?? if not then it could be an ECU fault or the immobiliser cut in.Seems strange that the clock and fuel gauge have stopped as well or they are just coincedental

Feb 28, 2009 | 1991 Peugeot 405

2 Answers

Wont start


resistor.............tell the mehanic

Jun 27, 2008 | 2003 Dodge Caravan

Not finding what you are looking for?
1995 Honda Accord Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...