Question about 2007 Kia Rondo LX V6

Open Question

Where a the spark plugs on a 4 cyl kia rondo - 2007 Kia Rondo LX V6

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

NJFIRESTORM
  • 84 Answers

SOURCE: Spark Plug Gap for a 2.0 4 cyl.?

0.54 is the gap for the plugs

Posted on Jun 13, 2008

  • 1779 Answers

SOURCE: spark plugs

Have u ever changed plugs before? Do u have any tools? You will need a spark plug socket, which is especially designed for this purpose, it will help to prevent damage to the plugs when u remove and install them. Also a ratchet wrench for the socket, and depending on your vehicle, u may need an extension. Purchase manufacturer recommended plugs (check your owners manual), you have to check the 'gap' of the plugs before installation, so u need a 'feeler gauge' or spark plug gap tool available at parts stores. Plug gap is set at the factory, but sometimes during shipping and handling they get banged around, so u have to check to make sure the gap is correct. 1st remove one plug at a time (so u don't mix up the order). To remove grab the spark plug wires, grab the 'boot' (the area of the wire that fits over the spark plug), push in, twist (does'nt matter which direction)and then pull out to remove. U don't want to yank on the wire, u can damage the the wire, so make sure u r twisting/pulling as close to the plug as possible. Once the wire is disconnected, remove the spark plug. Insert a new plug, by putting it in the socket, then by hand (not attached to your ratchet wrench yet) carefully screw it in (do not force it!). Once it's hand tightened, put the ratchet on and tighten snuggly (don't use brute force!) check the tightening instructions on the spark plug box. Reattach wire, proceed to the next plug. Aren't glad u don't have a 12 cylinder engine? How many miles on your Passat? If it's approaching 100k, u should also change your spark plug wires. Good Luck! Let me know how it goes. countrycurt0

Posted on Oct 06, 2008

  • 54 Answers

SOURCE: change spark plugs 2001 4 cyl hyundai sonata

You change One spark plug, and One wire at a time. Do you know where your timing belt is? If not, its on either the right or left side of the engine. There is a covor to the timing belt. You take the First plug that is closest to that belt. Then you work your way to the next closest all the way to the last one. Remember, you have to do ONE at a time.

Posted on Nov 30, 2008

motor1258
  • 6674 Answers

SOURCE: firing order 4 spark plugs 4 cyl

1,3,4,2.

Posted on Apr 29, 2009

aaangie220
  • 202 Answers

SOURCE: I have a 2002 kia optima 4 cyl. 2.4L. The fuel

that car might not have a fuel fitler. it is built into the fuel pump. check with the local pep boys they can locate it for you

Posted on Aug 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the rear spark plugs on the firewall on a 2008 Kia Rondo with a 2.7 liter engine


a bit of this & that; probaly need a jack (raise engine relative to body/firewall or opposite that) and an assortment of socket extensions, swivel joint & patience. Do it w/ engine cold & use a little 'never sieze' on new plugs. It is possible, just not convenient.

Dec 26, 2016 | 2008 Kia Rondo

1 Answer

How do I change the spark plugs on my 2007 Kia rondo lx v6


REPLACEMENT
1. Remove the ignition coil connector (A).
2. Remove the ignition coil.
3. Using a spark plug socket, remove the spark plug.26379325-trdzh3npzosxk4r5ena25aw0-5-0.jpg

Nov 30, 2016 | 2007 Kia Rondo LX V6

1 Answer

Kia sportage 2.0 cyl 4 misfire after spark plug change valve cover was leaking oil into cylinder ran good for a day now miss fireing again


It will take a while to get rid of all the oil that leaked into the spark plug hole. Take it apart again and recheck.

Feb 28, 2015 | 2002 Kia Sportage

1 Answer

Where is cylander 5 on a kia rondo LXV6?


Anon, whats with the double post. See attached diagram.
Firewall
1 - 3 - 5
--> transmission
2 - 4 - 6
radiator
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Kia Rondo Genuine Parts Kia Parts Overstock
Get the Best Priced Kia Rondo AC Compressor
RockAuto

Jun 17, 2014 | Kia Rondo Cars & Trucks

1 Answer

I need to change my spark plugs in my 2007 Rondo. How do I unplug the individual coils in each hole to get to the plug without breaking?


you take the electrical feed connector off the their is a small bolt which holds the coil in place ,Well most modern vehicles are like this but i havent worked on a petrol version as yet as all the ones i get are diesels .

Jan 21, 2011 | 2007 Kia Rondo LX V6

3 Answers

Need help with diagnostic codes


P0300 Multiple/Random Misfire detected.
P0301 Misfire detected - Cyls. 1-4.
P0302 Misfire detected - Cyls. 1-4.

Jul 25, 2009 | 2006 Kia Rio

Not finding what you are looking for?
2007 Kia Rondo LX V6 Logo

Related Topics:

232 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...