Question about 2003 Dodge Intrepid

1 Answer

Where is the PCM on a 2003 Dodge Intrepid SE - 2003 Dodge Intrepid

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,044 Answers

Most likely you can find it just in front of the transmission mounted just behind and on the bumper. Strange place for it but in that year dodge was putting them there. You'll see 2 connectors with bunches of wires going in.

Posted on Jul 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the pcm computer located at on a 2003 dodge intrepid sE 2.7?


On the left side engine compartment (fender side), directly in front of the power distribution center. Left is considered drivers side no matter the direction looking at.the vehicle.

May 24, 2014 | 1995 Dodge Intrepid

1 Answer

Location of tranmission module for 2003 dodge intrepid 2.6 se


not sure on that car...autozone can print you out diagram as to its location and how to install in most cases..They charge nothing for this.....

Aug 18, 2012 | 2003 Dodge Intrepid

1 Answer

Hello, have a 2003 Dodge Intrepid SE - 2.7L with 42LE Transmission - just replaced the solenoid pack and OD-UD, LR accumulators-new filter gasket and fluid - now it's giving me OBDII codes P0700 (


It sounds like you have a handle on this but I will ask the dumb question, are you coating the orings with petrolium jelly or trans assembly jelly? As far as the codes go, you might have a bad ECM. That mmany codes all at once seems suspect.

May 31, 2012 | 2003 Dodge Intrepid

1 Answer

What is causing my 2003 dodge intrepid se to slip and then the rpm's increase and it start dragging like?


Check fluid levels.If someone has put fluid in they might have put the wronge fluid .If the mile are over 60000 CHANGE FLUID AND FILTER!!!!!.Make sure that you use the rite fluid and DONT LET SOMEONE TALK YOUinto Aflush wthoutCHANGING THE FILTER THat probably what is wrong Sevice it with the proper fluid and FILTER!!!!! OGGD LUCK

Oct 15, 2011 | 2003 Dodge Intrepid

1 Answer

I recently changed the engine of my Chrysler Intrepid 2001 2.7 V6 with a Chrysler Intrepid 2003 2.7 V6 engine. The engine runs fine except that the 2001 engine had an EGR sensor but the 2003 does not ....


you can talk to someone a the dealer(service manager/tech)to see if they can reprogram the pcm so it recognizes there is no egr on this motor

Sep 08, 2011 | 2001 Dodge Intrepid

1 Answer

I have a 2003 Dodge Intriped SE. It is over heating and the heater does not blow hot air in the moring after the car is warmed up.


You likely have low coolant causing a large air pocket. This will cause the sensor to pick up the hot steam but the lack of flow through the heater core will not heat up the interior.

Feb 22, 2011 | 2003 Dodge Intrepid

1 Answer

My water outlet cap popped off and its leaking water and the water that stays boils. Should i replace my water pump 2003 dodge intrepid se 2.7


replace the cap--is the radiator damaged? No reason to replace the water pump. Boiling is caused by leak, faulty thermostat, clogged radiator, or head gasket.

Aug 22, 2010 | 2003 Dodge Intrepid

3 Answers

Where is the tcm for 2002 dodge intrepid people say behind the driver side headlight but the dealer told me that was the pcm not for the trans. so what is the truth i know that the tcm i bought is smaller...


I too have a 2002 dodge Intrepid, after 10 minutes of driving the car, when i make a stop it won't shift properly, in order to make it shift, i have to turn the ignition off and back up again!
If anyone can help me locate the TCM that would be great.
I'm ready to drive it off a cliff
Thanks in advance!

Jun 22, 2009 | 2003 Dodge Intrepid

1 Answer

PCM unit


PCM is the standard automotive acronym for Powertrain Control Module, previously know as the ECM and ECU, in 1996 the term was standardized for the new OBD 2 emission control system.

Apr 29, 2009 | 1999 Dodge Intrepid

7 Answers

2002 Dodge Intrepid transmission not shifting


Flush out your transmission with the correct type fluid, Mopar ATF+4, and correct filter. Disconnect Negative cable, to reset computer, for at least 24 hours. Check grounding straps for PCM, ensure they are tight and clean.
This method worked on my 2003 Intrepid SE, 3.5L, Police Pkg car.
Good Luck!!

Jun 27, 2008 | 1997 Dodge Intrepid

Not finding what you are looking for?
2003 Dodge Intrepid Logo

Related Topics:

282 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...