Question about 2002 Chevrolet Blazer

1 Answer

I can't close the doors on my chevy blazer - 2002 Chevrolet Blazer

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

With the door open try tripping the catch piece manually.
to do this hold the door handle in the open position while
at the same time you reach over to the catch and it should flip right up .before you do this put the window down so you can test several times.then give a good shot of w.d. 40

Posted on Jul 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The driver side door on my 2002 chevy blazer wont close.how do i fix it?


Door pins are a common failure on that series of Blazer/S10's. Also, another point of contention that the door faces is a sticky latch. Basically, the door latch re-latches itself and when you shut the door into the catch, it slams into it and bounces off. An easy fix is a 3 part cocktail of brake parts cleaner. Open and shut the latch with a screw driver acting as the catch and your interior door handle a few times. P'Blaster, open and shut the door a few times with the screwdriver acting as the catch. Finally, a good shot of white lithium grease. Open and shut the door with a screwdriver as the catch several times. Once you feel it is un-stuck, actually close and open the door several times. If you notice the door rising every time it catches, you MUST replace the door pins (cheap fix). If the door still has issues, replace the door latch (and since you're in there, do some PM and replace the actuator as well).

Apr 08, 2012 | 2002 Chevrolet Blazer

1 Answer

I have a 2002 chevy blazer that the driver side door won't close all the way but it's NOT the latch inside the door, the door seems to be lower than the latch.


Sounds like your door hinges are worn. Pin and bushing kits are available at parts stores, and with a little patience are not awful to install. Installing a pair of these should restore the door to the original height, and allow the door to close properly.

Sep 06, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

Recall list for a 1997 Chevy Blazer 2 door 2 wheel drive


please go to the web page below for a list of the recalls and what the problem is for the recall

http://www.carcomplaints.com/Chevrolet/Blazer/1997/recalls.shtml

Jul 01, 2010 | 1997 Chevrolet Blazer

1 Answer

Where is the fuel filter located on my 2004 Chevy Trail Blazer? WE


On 05+ Trail Blazer, the fuel filter is integral with the fuel pump inside of the fuel tank. It is a non-serviceable part. On 02-04s, the filter is on the drivers side frame rail at about the B-pillar. If your trail Blazer is a late 04 which means that it was build close to the 05 Trail Blazer, you may have a non serviceable fuel filter. Good luck and check under your Trail Blazer or look at your manufactured date sticker on the door which would help you indicate if your 04 is a early Trail Blazer and you'll have the fuel filter on the inside frame rail under the driver's door.

Mar 05, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

'95 Chevy Blazer driver's sit wire doen't have


the wires between the door and frame are probobly broken from opening and closing so much....run into it a lot...cheap fix is to cut the rubber boot off with a razor knife and splice in a piece of wire....tight working in there and make sure you seal them up with heat shrink and lots of electrical tape,,,good luck...Lee

Aug 21, 2009 | 1995 Chevrolet Blazer

1 Answer

Interior lighting stays on all the time on a 2001 Chevy Blazer


on your interior light switch (dimmer switch) just get in the vehicle close doors and turn the dimmer switch and that should do it

Jul 04, 2009 | Chevrolet Blazer Cars & Trucks

2 Answers

Driver's side door adjustment on a 2000 Chevy Blazer


check your door bushings in the door hinge these probably need replacing. if you can lift up on door and feel play they are wore out. common issue on these if not you can put a wood block betwwen bottom of door and body and push on top of door to bend it a little to close top tighter

Jan 27, 2009 | 2000 Chevrolet Blazer

1 Answer

Chevy Blazer door wont close....


easy fix open the door take a screw drive and slighty pry the latch on the door back while pulling up on the door handle magic you can lock ya truck now.

Jan 09, 2009 | 1989 Chevrolet C1500

1 Answer

CONTROL SWITCH HEATER


the problem is not the selector, it is the air temp control blend door motor, the only way to fix this is to remove the dash, there is no way to manually close the door for heat because you can not reach it.

Dec 17, 2008 | 2000 Chevrolet Blazer

Not finding what you are looking for?
2002 Chevrolet Blazer Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8274 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...