Question about 1987 Chevrolet Camaro

1 Answer

Need written instruction on installing an Ignition Switch on a 1987 Camaro Iroc Z28, can u help?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,857 Answers

Go to mitchell1diy online and pay the ten bucks if noone responds..

Posted on Jul 07, 2010

  • 1 more comment 
  • James Bigham
    James Bigham Aug 13, 2014

    first remove the center button on steering wheel be careful there is a plastic connector for the horn that almost always breaks you have to push gently and turn it counter clockwise a little then it will come towards you! then with snapring pliers pull c clip off steering shaft! then with a 13/16 socket 1/2 or 3/8 drive extension and ratchet remove center nut from shaft you will need some specialty tools for the rest a steering wheel puller a lockring spring compressor and a torx bit remove the steering wheel if no tool place two knees on both sides of lower part of st.wheel and one hand on top center and gently tap on shaft with a hammer you can mess the threads up if you get too wild with the hammer! the lockring spring compressor will follw thread the tool on the shaft then align the cbracket on lockring and tighten wingnut to press lockplate down to remcove retainer clip for lockring and horn assymbly! then you will use a phillips s.d. to take off the turn sig arm bracket and the three turn sig assymbly screws and gently pull assym up but enough to clear shaft and your lockig pin will be visible then remove it and the cylinder will come straightout! follow the instructions in revers for reassymbly! and youre done!

  • James Bigham
    James Bigham Aug 13, 2014

    if it is the switch then it is located on top of the steering column and you will want a repair manual to get this right cause the wrong adjustment will be a nightmare!

  • James Bigham
    James Bigham Aug 13, 2014

    Add a Commentgood Luck!

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace the rear axel bearings on a 1988 Chevrolet IROC Z28 Camaro


Put car in neutral, remove wheels, calipers and rotors, diff. cover. rotate carrier until you see wrist pin retaining bolt, remove bolt and slide out the wrist pin out of carrier. Next push axle inward to remove inner axle "C" retainer washer then slide axle out of tube. Then pry off axle seal and with slide hammer w/attachment remove axle bearing.

Feb 23, 2014 | 1988 Chevrolet Camaro

Tip

How To Replace Ignition Coil 82-92 Chevy Camaro Iroc-Z Pontiac Trans Am Part 2...


How To Install Replace Ignition Coil 82-92 Chevy Camaro Iroc-Z Pontiac Trans Am Part 2 1AAuto.com<utube src="jMtq0HqGtk0">

on Jul 28, 2011 | Chevrolet Camaro Cars & Trucks

Tip

How To Replace Ignition Coil 82-92 Chevy Camaro Iroc-Z Pontiac Trans Am Part 1...


How To Install Replace Ignition Coil 82-92 Chevy Camaro Iroc-Z Pontiac Trans Am Part 1 1AAuto.com<br /><br /><utube src="hiczZ2JugAg"><br />

on Jul 28, 2011 | Chevrolet Camaro Cars & Trucks

1 Answer

I have a 1987 camaro Iroc z28 , it has a 350 small block.... I'm having problems , i put a new battery, alternator and starter in and have no power won't even turn over completely nothing .i...


Did you replace the battery and alternator at the same time?Sometimes if you have a bad alternator and you put a new battery in,the bad alternator can completley drain your battery.

Apr 30, 2013 | Cars & Trucks

1 Answer

87 IROC WITH A ZZ4 OUT OF A 91 Z28... fitted a


Fuel pressure? Do you hear the fuel pump running? Read the codes to see if ECM is still alive. Do you have spark at the plugs? Remember all motors need 3 things to run air, fuel, and fire at the right time.

Mar 16, 2010 | 1987 Chevrolet Camaro

3 Answers

Just bought a 1987 Iroc Z. Need to know why my


look at waser bottle and there is a pump . replace the pump very easy to do

Nov 12, 2009 | 1987 Chevrolet Camaro

2 Answers

How do I replace the ignition switch on 87 iroc z28


It is easier for me to drop the column... Good Luck!

Oct 09, 2009 | Chevrolet Camaro Cars & Trucks

2 Answers

I have a 1987 Camaro Iroc Z28 5.0 engine. I'ts


Fuel pump is located in the fuel tank. A shop can do a fuel pressure pretty easy. You could do it to, you just have to spend 50 to buy a tester, or spend 20 to have a shop do it.

Aug 16, 2009 | 1987 Chevrolet Camaro

1 Answer

Looking for a wiring diagram 1987 Z28 camaro


bruce in the wireharness on the plugins they have numbers, write them down and go to the neares chevy dealerchip,talk to the parts personel if posible to the parts manager.and talk to him about the problem you are running into ,then they can ck the numbers to see if you have the right wireharness for your z28 camaro,you might have a harness for a camaro but it could be tha its for a v6 or just a camaro, and not a z28 camaro that couid be the diference.let me know

May 31, 2009 | 1987 Chevrolet Camaro

1 Answer

1984 Camaro Z28 Wiper switch wont work properly


hello I will take a picture of the Diagram and send it to yea I have a 86 Iroc z28 So i have a Haynes manual for yours as well for most of the f body's are universal. I need a Email or a way to send you the file?

Dec 01, 2008 | 1984 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...