Question about 1998 Cadillac DeVille

1 Answer

Question - what is best way to remove altenator

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 114 Answers

Remove serpentine belt then losen the bolt holding the altenator.

Posted on Jul 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why won't the newly installed altenator work on the 2006 Ford Taurus? The cars gauges stopped working and a red icon was lit up on the dash (appeared to be the check engine light) when the car was moving....


as its a used part it may not be in working order , check the charge rate by putting volt meter across the battery terminals when engine running , the reading should be around 13.5 -14 volts , if not then check the alternator belt is tight enough and retest the charge if lower than 12 volts then the alternator is useless , a non charging alternator will give the symptoms you've described, th ered icon is the non charging warning light , dont drive if the check is low as will ruin your battery as well, take alternator off and get a lift back to the supplier , best to by new

Jul 15, 2014 | 2006 Ford Taurus

1 Answer

Replace alternator 2008 aveo


disconnect negative battery cable. Then remove rubber boot on altenator. Remove nut and cable attached. Unplug and remove wire harness also attached to altenator.
Loosen and remove both bolts holding on altenator.
Remove altenator.
Reverse process to reinstall. Pry on belt tensioner with pry bar and socket to loosen belt and place on altenator pulley after it is installed.
Last reattach battery cable and start vehicle.

Jun 04, 2012 | 2008 Chevrolet Aveo

1 Answer

How to remove altenator from a 96 monte carlo 3.4 litre over head cam engine


  1. unhook battery
  2. take belt off - has a tensioner pull up on to release belt
  3. unhook wires from altenator-mark the wires so remember where they go
  4. take out bolt's that hold altenator on
  5. remove altenator -replace in reverse order

Nov 11, 2010 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

Install a altenator for a 2006 jeep commander


I would rate this a 5 in difficulty. If you have a metric socket set, basic hand tools and a supertine belt tool it's fairly easy repair. You can rent a surpentine belt tool at Autozone.

Disconnect the battery
remove the cowling
remove the supertine belt from the altenator pully
disconnect the red wire on the back of the altenator
disconnect the harness plug from the altenator
remove the bolts holding the altenator to the mounting brackets.
Reverse the process with the new altenator and it it's done.
Make sure your battery is charged before you start the engine a low battery can cause damage to your new altenator.

May 20, 2010 | 2006 Jeep Commander

2 Answers

Replace altenator 2002 bmw 325ci


disconnect the negative battery. remove the belt by rotate the tensioner roller clockwise. from the left car side u will see three hexagon screw 13mm under the altenator. loose out the screw and remove the altenator. before that unplug the two wire behind the altenator.tq

Feb 28, 2010 | 2001 BMW 325

1 Answer

R&r of alternator for 2003 trail blazer Any thing special to pay attention to? Will remove battery conection prior to removal of old one.


Onceyou have the altenator removed, confirm that the diode pack is workin correctly. If it s not, change the pack. If it is, trade the altenator for a rebuilt one. Look in the yellow pages for a starter/altenator rebuilder.

Jan 27, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

Trailblazer 2002 stalls when a/c is running.when defrost or a/c is engaged truck will stall out.when driving at speed truck will run with a drag.


hELLO THERE
This would normally indicate that the compressor motor is starting to go out or the altenator can not keep up with the load demand from the a/c so you should have the altenator checked and posssiably go with a altenator with a biger amperage
But if the air conditioner compressor is starting to go out when they do the compressor will lock up all together and you will not be able to start the vehical it will not even turn over so the way to test this is to remove the belt from the compressor or remove the compressor totally and try to run the vehical and see if the vehical runs ok now if so you know what the problemn is ok
Best regards Michael

Nov 27, 2009 | 2002 Chevrolet TrailBlazer

2 Answers

How to remove the altenator in a 1997 Deville


disconnect the positive lead to the battery and disconnect the wires behind the alternator loosen all 3 bolts / nuts and brackets and remove replace in reverse method

Sep 23, 2009 | 1997 Cadillac DeVille

1 Answer

1999 hyundai code b1111 battery and alternator test good . dealer can not find anything wrong with battery or alternator but light comes back on every 20 miles or so


its the warning control light in the altenator.you will need to change the regulator in the altenator or replace altenator .best advice ??ignore it

Jul 09, 2009 | 2001 Hyundai Sonata

4 Answers

Checking the power steering fluid levels


the power steering resevoir is underneathe the altenatror or your vehicle. you have a gm 3800 series II engine the resevoir is located near the fire wall on the passengerside right under the altenator. the easiest way to check this is to remove the altenator. I say this because there is not much room to put your hands in that area because your coolant overflow tank is there as well. disconnect the ground to the battery first. then disconnect the power lead to altenator. remove serpentine belt. then remove the plug from the altenator. remove the bolts to the altenator and move the altenator aside there you will see the resevoir for the power steering. installation is in reverse order... please rate this......thanks

Sep 28, 2008 | 2001 Buick Regal

Not finding what you are looking for?
1998 Cadillac DeVille Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...