Question about 1987 Ford F 350

1 Answer

Ilp have an 87 F350 with a 460 and a manual trany

Ilp have an 87 F350 with a 460 and a manual trany just rebuilt the carb the truck cranks over with no problem and is getting fuel to the carb but does not fire and start it has sat for over a year any thoughts or ideas would he

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Did you drain the old fuel out of the tanks? Old fuel will not fire most times it goes bad and mosture accumulates. Next question for you are you getting and spark?

Posted on Aug 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Suzuki diagram


no CRANK
OR NO START

IS THE 87 Still stock?, many are not, engine swaps,?
and changed carbs. ?
post what engine is there G13?
and fuel system. there.? EFI or CARB.

if still stock the stock manual wins big time.

http://www.fixkick.com/sammi-stuff/index.html

check fuses. first.
if not crank, then hot wire starter
or jumper cable start from running car.... like AAA does... dig?
next time tell if
CRANKS but dont start
or
will not crank.
we can not guess that.
nor engine options.

Aug 15, 2014 | 1987 Suzuki Samurai

1 Answer

1987 Samurai idles fine. Above idle goes lean, runs rough, mc dwell 0. Rebuilt carb., no change. replaced with rebuilt carb., no change. Timing bounced around when engine running bad, replaced dist....


87 has no ECU. so must be an engine swap to a 89 or newer tracker
or last sammi that did have EFI.
you said EFI and Carb in same paragraph and that is a contradiction.
post to my bbs for more help.
http://www.fixkick.com/bbs/

post a link to a photo of your engine, many sammy cars have a newer engine and EFI added. no matter we can fix it, but you need to learn whats under the hood first, photos rule in this word.

3764f14f-21cf-4d3f-a26f-ebe32cc08cba.jpg

Feb 19, 2013 | 1988 Suzuki Samurai

1 Answer

My 2 barrel-holley on an 87 Dodge trk. the butterfly sticks open and wont take gas, after im driving awhile


Have you tried using a spray carburetor cleaner? Also, is the fuel filter clean?

Jul 11, 2012 | Dodge D150 Cars & Trucks

1 Answer

How do I shut down EGR system on 1986 toyota 22r 4x4 truck


I am original owner of 1986Toyota Pickup 2wd caRB. 4SP MAN. SHORT BASE MFG.IN JAPAN. I NEVER HAD ANY PROBLEMS WITH ANYTHING UNDER THE HOOD OR IDLE OR ACELLERATION. iT RUNS JUST LIKE THE DAY i BOUGHT IT IN oCT. 1986. i NEVER ADJUSTED CARB OR CHOKE OR CLEANED IT iT HAS ALL ORIGNIAL PARTS EXCEPTTHE STARTER, BATTERY AND WATER PUMP GASKET.

May 25, 2012 | Toyota Cars & Trucks

1 Answer

1.Can a flashing hold light/faulty mass air flow sensor burn the clutches in a transmission? 2.if vehicle reves out after changing into second gear and transmission is rebuilt and problem still persist...


The ecm would not cause this, it sounds like someone did a poor rebuild, if the engining is reving and the car doesnt what to go then the clutches may be bad, a mass are flow would not cause a trany to go bad, the flashing hold light is a problem but should not be happening after the trany was just rebuilt, something is not right here, the trany was just rebuilt and now the hold light flashes and the motor rev going into 2nd gear, that trany has problems a bad ecm wouuldnt cause this slipping reving problem you are having , i would have a trany shop check to see if that trany was really rebuit.

Jan 12, 2011 | 1998 Subaru Forester

1 Answer

How to tune the carburator on a 87 chevy caprice brougham?


An 87 Caprice shouldn't have a carb from the factory. As far as I know it should have a throttle body injection system. But if it does have a carb the idle screws are sealed with caps that have to be removed before they can be adjusted.They were preset at the factory and the carb would have to come off and be rebuilt. The best thing to do would be to find a good shop that can do it or buy one rebuilt at the autoparts store. Then you only have to set the curb idle, which is a spring loaded screw the bumps against the throttle linkage. Hope this helps.

Oct 21, 2010 | 1987 Chevrolet Caprice

1 Answer

I have a 94 ford taurus 3.0 with overdrive. i need to know what kind of transmission i need for it.


When looking for a trany all you need to do is tell them its a 1994 taurus with a 3.0, but just keep in mind these tranys have a lot of problems so if you get a used one theres no telling how long it will last, your best bet is to find a used one that has been rebuilt or get a rebuilt one, these tranys are known for going bad, anyway that car should have the trany AXOD-E this is the type of trany you have, hope this helps/

Sep 08, 2010 | 1994 Ford Taurus

2 Answers

No 3th or 4th gear , auto trans


auto tranys look somewhat like a jet engine with blades that a pushed by trany fluid. In 3rd or fourth gear these BANDS are damaged. looks like a trany overhaul.

Jun 20, 2010 | 1993 Honda Accord

1 Answer

Carb Floods out


Your float level is to high when you put the kit in they give you a float adjustment gauge,you will have to pull you carb back off and reset, but before you do that what is you choke set at if it wrong it will flood too,But if it set right you can look down your carb and you see gas dripping your you float is to high

Sep 19, 2009 | 1983 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5677 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...