Question about 1990 Dodge Daytona

2 Answers

Cannot find fan relay switch on 1990 dodge daytona

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 92 dodge daytona my fans wouldnt engage so i took a peace of heavy duty amp wire an put it to the fan an then to a light switch seems to work fine u just gota turn it on an off

Posted on Jul 10, 2012

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

There is two places where relays were placed on these cars. one where everyone knows is under the hood. second less people no is on the drives side up under by the fire wall. you have to take the bottom saftey cover off and than what each one is displayed on the back off the cover.

Posted on Aug 22, 2010

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

djchillsnyc
  • 151 Answers

SOURCE: locate a fan relay switch

56541646.gif
check your blower motor resistor also, like in this pic
the fan relay is loacated driver side under the dash fuse box









Posted on Dec 16, 2008

bunnydawg
  • 5158 Answers

SOURCE: 1990 dodge daytona headlight covers

there is a concealed headlight control unit behind the dash on the left side of the steering colunm. in the fuse box it's fuse number 3

Posted on Mar 21, 2009

  • 1 Answer

SOURCE: headlamp motor relay location.

Had the same problem on mine. It's easy to resolve. in the center top of the dash board,juste under a plastic panel, you will see a plastic box whit a big plug you problem is inside. This box is seal by a cahoutchouc resin, its better to open the box when te temperate is very hot, the resin is more easyer to put out. Open te box delicaly and be careful of the electric plate. When you have clean resin of the electric plate check all weld, you will find one or more who are not very well. you juste have to rebuild the bad weld. you problem is now repair. if you have any question you can write me on diagnostick_bike@hotmail.com excuse my english but I'm a french man

Posted on Aug 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My elictric fuel pump want kick on on my 1990 dodge daytona v6 3.0


Sounds like you may have a bad fuel pump, check your fuel pump relay and fuse first, if you find these 2 items to be operational then you more then likely have a bad pump and that will require removal of the gas tank for further inspection of the pump assembly...

Dec 10, 2010 | 1990 Dodge Daytona

1 Answer

!990 dodge daytona Fuel pump does not turn on when key is on


I would check the fuel pump fuse and the relay for the fuel pump. Most likely the fuel pump has gone bad.

Oct 27, 2010 | 1990 Dodge Daytona

1 Answer

Need to locate the fuel pump relay on my 1990 daytona, 3.0 I have ripped the car apart following bum leads. I'd like to replace this before venturing into gas tank removal for fuel pump replacement. Any...


don't go too far yet, have you checked if you have voltage to the fuel pump?? any relay will be close to the fuse box, disconnect the harness to the pumptas close to the tank as you can and check there

May 07, 2010 | 1990 Dodge Daytona

1 Answer

Location of the front wiper relay


hi i got a 1990 dodge daytona shelby if you look under the dash on the driver side in the far back left hand side and kinda look up there should be about 14 relays there you well need a flash light trust me i have no clue what one is it hope it help keep that daytona runing it a good car o make sure that wiper motor is not short out

Jan 04, 2010 | 1991 Dodge Daytona

2 Answers

Head lights wont stay on


Check your steering column. There is a switch that cancels the turn signals in there. If it's bad, your signals will act funny and this also affects the hazard switch. Banging on the dash is what triggers the signals to work as the vibration goes into the steering column also. You might also want to check the fuses, relay switch, located inside the the left fender next to the steering column. Sometimes, the radio and the turn signals will go funky at the same time. Make sure your radio is grounded.
Hope this helps.
Cheryl
1990 Dodge Daytona 2.5 ltr. Automatic

Nov 27, 2009 | 1990 Dodge Daytona

1 Answer

Is there suppose to be a spacer plate between the engine and transmission of a 1990 Dodge Daytona....automatic


hello i got a 1990 dodge daytona shelby 2.5 with a a413 transmission auto there is no spacer plate on mine

Oct 04, 2009 | 1990 Dodge Daytona

1 Answer

1990 dodge daytona headlight covers


there is a concealed headlight control unit behind the dash on the left side of the steering colunm. in the fuse box it's fuse number 3

Mar 21, 2009 | 1990 Dodge Daytona

1 Answer

1990 daytona still wont start


Automatic or manual shift ?

Automatic:
Check for power from the starter relay. Yes / No ?
Check for power fronm the ignition switch. Yes / No
Did you replace the neutral safety switch. Yes / No

Did you buy or borrow a REAL factory service manual ? Get one.

Mar 19, 2009 | 1990 Dodge Daytona

Not finding what you are looking for?
1990 Dodge Daytona Logo

Related Topics:

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...