Question about 2006 Chevrolet Equinox

Open Question

How do i replace wheel bearings o a 2006 chevy eqiunox font wheel drive

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 24 Answers

SOURCE: replace front wheel bearings

The bearings in your car are pressed into a hub. If the part is available as an assembly, it can be replaced that way. Generally on a front drive car:
Remove wheels and brake calipers
If it is pressed in: remove the rotors, disconnect the drive shafts and remove the steering knuckle. Then the old bearing is pressed out and the new one pressed in with a machine shop press. If the bearing is part of the hub, that will be unbolted and the new one swapped.

On a scale of 1-10 difficulty, Id rate it a strong 7

Posted on Jun 20, 2008

mrgreenz
  • 962 Answers

SOURCE: (How do I replace rear bearings) chevy sliverado RWD

Check to see if the drum is hotter than normal. If the bearings are bad, you have to lift the truck and remove the axle. Remove the wheel drum until you get to the axle. They to remove the axle, you have to open the rear end Spider gear ***** at the middle. They have a half moon wedge or a clip you have to remove. They you pull out the axle.Replace the bearing grease it and seal it. Then put it back in the reverse order. Sounds simple but it is not that simple. Takes work

Posted on Jan 11, 2009

Healeyman
  • 1198 Answers

SOURCE: front wheel bearing removal on 2006 F350 touchtone 4X4

Get a good repair manual. Front ends on 4X4s require proper care.

Posted on Apr 25, 2009

  • 1 Answer

SOURCE: replace font wheel bearing

how to change wheel bearing on a 2001 nissan altima

Posted on May 09, 2009

  • 72 Answers

SOURCE: Need directions for replacing a hub bearing

REMOVE BRAKES, ON BACK SIDE OF SPINDLE REMOVE FOUR RETAINING BOLTS AND HUB ASSEMBLY SHOULD COME OFF.. MAY HAVE TO TAP WITH A HAMMER TO BREAK FREE FROM THE SPINDLE... BE SURE TO THOUOUGHLY CLEAN THE SPINDLE BEFORE INSTALLING NEW BEARING ASSEMBLY.

Posted on May 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

WHAT IF ANY SPECIAL TOOLS ARE NEEDED TO REPLACE A REAR WHEEL BEARING ?


No.
The most you'll need is a big hammer or a air hammer to loosen the bearing from the spindle but just like changing a front bearing

Jul 14, 2014 | 2006 Chevrolet Impala

1 Answer

05 cavalier , font grinding noise still there after replacing both wheel bearings. when driving i'll swerve back n forth and sound changes tone but still there on both sides


Could be the rears ,locating wheel bearing noise is a difficult job and even with 45 yrs experiance i still get it wrong ,ALSO I HAVE NOTICED THAT IT PAYS TO FIT ONLY SWEDISH OR GERMAN bearings even british but a lot of the spares coming in are cheap but made in china need i say any more ,your noise is definatly wheel bearings but i do feel it could be the rears and i would suggest that take an old time truck fleet fitter and sit him in the back and go for a drive ,if any of us old codgers are still alive that is

Jan 03, 2013 | Chevrolet Cavalier Cars & Trucks

1 Answer

Roaring noise with my 2006 Chevy Cobalt?


while the wheel bearings still feel tight they are the cause of your problem, after a collision most cars suffer from this problem depending on the speed of the accident the forces encountered during a sudden stop causes intense stress and fatigue on the bearings

Dec 06, 2012 | 2006 Chevrolet Cobalt

1 Answer

Just replaced both front hubs on my 06 avalanche still have a hum coming from the font


my vote is wheel bearings similar problem on front wheel drive vehicle when when drum and all fell off bearings had siezed. good luck

Nov 25, 2011 | 2006 Chevrolet Avalanche

1 Answer

2006 chevy impala rack and pinion changed


IF you had the rack replaced and did not align it is possible the wheels are so far out that tires are scrubbing road causing noise. other thing could be a wheel bearing i would recommend getting alignment and drive

Oct 28, 2011 | 2006 Chevrolet Impala

2 Answers

2006 chevy silverado abs light comes on goes off comes on goes off


Hi...your problem might be coming from your front wheel bearing hubs. They are know to cause this problem as they wear out and eventually have to be replaced.

http://www.autozone.com/autozone/parts/2006-Chevrolet-Silverado-3500-4WD/Wheel-Bearing-Hub-Assembly-Front/_/N-jnpe7Z8kns

If I helped...please rate me...thanks!

Sep 18, 2011 | 2006 Chevrolet Silverado

1 Answer

I have a 2006 chevy trailblazer LS and I have recently noticed that during cold days when I pull out of my drive way and put the gear into drive that the stabilitrac light and the stabilitrac service light...


VERY common problem on GM vehicles. They built the wheel speed sensor into the wheel bearing and have had nothing but trouble. Get the trouble codes read to find which wheel is setting the code. Then check the wiring. You'll probably have to replace the bearing/hub
Trac off light

Aug 26, 2017 | Chevrolet TrailBlazer Cars & Trucks

1 Answer

Steeing wheel vibrates when i turn to the left from a stop


Does it feel like it's trying to pull back straight? if so, I would say you have a seized strut bearing on the right side.

Jun 02, 2009 | 2006 Chevrolet Impala

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

549 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...