Question about Chrysler Concorde

1 Answer

Need manual to concord

Need to replace fan tempeture sensor to the radiator fan

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 593 Answers

The fan gets it's signal from the engine temp sensor, located near the
thermostat housing. There are also 2 relays for the fan hi + lo located
on the fan shroud(2.7 eng.) and for the 3.5 eng. in the fuse/relay block
near the radiator expansion tank. Hope this helps.

Posted on Jul 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sensor switch


The radiator fan is controlled by the computer which uses the signal from the engine coolant temp sensor.

Jul 02, 2013 | 1994 Chrysler Concorde

1 Answer

My caprice runs cool as long as its on the road with no traffic once i hit traffic tempeture goes real high but if i get out of traffic n just hit the road it will cool back down. ive changer ignition...


A bad head gasket can cause overheating. Have you noticed a loss of coolant? If you take your radiator cap and then start your car you can watch for bubbles. Be careful not to burn yourself while doing this. If you see bubbles well then that means that exhaust gasses are getting in somewhere and yes that would cause the overheating issue. I'm a firm believer in using only OEM thermostats. Does your car have an electric fan? If so there is a switch that turns it on at a certain temperature that may be failing. You say that you replaced the radiator. How about the hoses? You say that you replaced the temp sensor. There are usually two of them, one for the gauge and one for the ecm. I'm assuming that your car has AC and has a condenser. If it does, how does the condenser look? If it is damaged or dirty it could be abstructing airflow and not letting enough in for the radiator. Hope some if this helps.

Apr 17, 2011 | 1994 Chevrolet Caprice Classic

1 Answer

1998 chrysler concorde fuse under the hood for the radiator fan to work keeps blowing out


The radiator fan has a short in it,and it is going out,replace the fan motor.

Aug 15, 2010 | 1998 Chrysler Concorde

2 Answers

I have a 95 chrysler new yorker the fans faulty.


try checking fan motor to see if is good take it of and use battery to make them work if that dont help motor is bad

Apr 08, 2010 | 1995 Chrysler New Yorker

1 Answer

My tempeture reading is -40 all the time but the navagation seams to work on the overhaed system


You need to replace the ambient air temp sensor located on the radiator support in front of the radiator.

Mar 16, 2010 | 2001 Ford Explorer Sport Trac

1 Answer

Where is the radiator for 2002 concorde


For access to the radiator, firsth you need remove or disconnect the following:
Disconnect negative battery cable. Drain cooling system. Upper radiator hose . Upper radiator closure panels. Radiator fan assembly . Radiator fan electrical connector.

Good luck.

Mar 02, 2010 | 2002 Chrysler Concorde

1 Answer

2000 daewoo lanos where is located the tempeture sensor?


On my 1999 it is located near fan has 2 wires almost looks like a o2 sensor

Feb 09, 2009 | 2002 Daewoo Nubira

1 Answer

Radiator


have you checked coolant tempeture sensor for the fan or its relay or the cooling fan itself to make sure its not burnt out and the fuse.

Oct 31, 2008 | 1998 Mazda Millenia

1 Answer

96' dodge Neon 2.0


The fan could just be dead. To test the fan apply 12 volts DC directly to the correct wires of the fan. I just replaced a dead fan in a PT Criuser.

Oct 22, 2008 | 1996 Dodge Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...