Question about 2005 Hyundai Tucson

1 Answer

Car has done only 3600 miles but clutch seems to slip when trying to pull hard. Hyundai Tucson 2 litre crdi

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 977 Answers

Check your clutch pedal for free play it should be 3/4" it might be adjusted up to much, you might have to adjust it off a little....hope this helps....cheers

Posted on Jul 07, 2010

  • anthony beer Dec 05, 2010

    you may find that the master cylinder has failed ..this is a common problem with the tucson any main dealer will replace it free of charge

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Hyundai. Tucson, 59 plate' clutch slips at high speed when changing gear


check /replace clutch cable or replace master cylinder. If the clutch has not been replaced it may need a clutch kit as the indications are that the pressure plate is weak ( worn clutch plate or from overheated clutch)

Feb 10, 2015 | Hyundai Tucson Cars & Trucks

1 Answer

Hyundai tucson crdi


You might have an air lock in the fuel system. The lines from the injector pump possibly need broken loose at the injectors and cycle the fuel pump several times until nothing but pressurized fuel comes out.

Jul 26, 2014 | 2006 Hyundai Tucson

2 Answers

I have a 2007 Hyundai Tuscon Limited. After starting the car and turning off the engine a few times, the car will not crank again. Approximately 20-30 minutes it will start again. However, when...


to all those posting about tuscon clutch problems.... seems this is a common prob..! my tucson 55 plate cdx (38k miles) is curently in repair . 1. i started having problems finding 2nd gear, this occured for a few weeks. 2. then i lost most of tension in clutch pedal,.
I got a mate to fit a new master cylynder (1hour work), and that seemed to resolve the problem.... but only for several weeks....! eventually i was unable to find most gears on selection.... the dealership fitted a new slave cylynder today (3.5 hours work) but called me to inform me it still has not resolved the problem and they will now replace the complete clutch system (6.8 hours work) sadly my warranty has just expired...!!

Aug 22, 2011 | 2005 Hyundai Tucson

1 Answer

Hard to get my tucson in gear


Check you have no air in the clutch fluid.Bleed the system.If that does not cure the problem then if you have good pressure at the pedal you pressure plate is faulty.Then the only solution is to replace the clutch.

Dec 29, 2009 | 2004 Hyundai Tucson

2 Answers

Hyundai tucson 2 liter crdi gear box sound its a manual transmission


Hi there, the Common Rail Diesel Inyection (CRDI) 2000 cc 112 Hp M/T have a big trouble on cluth plate, and sounds very loud between 1500 and 2000 rpm on 2,3,4 shift.That motor has too much torque and cause excesive wear in the cluth roll and plate so starts roominess in the cluth system. You could change those parts but quickly the sounds come again. Hyundai is the resposable of that damage. I hope in the near future recall the CRDI model 112 Hp and replace the cluth.

Sep 20, 2009 | 2005 Hyundai Tucson

1 Answer

I have a 'check engine' amber light illuminated


dear friend-your vehicle need to be hooked up to a HI-SCAN-PRO or GDS in order to read your fault codes.only if you have a fault code will you be able to carry out any repairs.

Jul 05, 2009 | 2006 Hyundai Tucson

1 Answer

Hyundai tucson clutch


Thank you for the request. Since the car only has 24,000 miles on it, I would take it back to the dealer. It does sound like that your clutch needs an adjustment of some type. Since I do not own a Hyundai I have no idea what the actual problem might be. I just did some research and found out that the clutch in your car is hydrolic (meaning that it uses a master and slave cylinder with hydrolic fluid to push the clutch arm when you push the clutch pedal with your foot). Trying to work on this type of clutch system can sometimes be a very hard to do. With the small amount of miles your car has on it, I would get the dealer involved in solving this problem. It could be something as simple as bleeding air from the hydrolic system of the clutch or it might be replacement of either the master cylinder, the slave cylinder and/or the fluid line that goes in between those two cylinders.

Much good luck in fixing this problem.


Nov 26, 2008 | 2005 Hyundai Tucson

7 Answers

2005 Hyundai Tucson jerking violently


mirandamcl,

I just took my 2006 Tucson in to have this fixed. It was simply that that hose from the air filter was not clamped on tight. That was 2 days ago, no more problem.

May 18, 2008 | 2006 Hyundai Tucson

Not finding what you are looking for?
2005 Hyundai Tucson Logo

Related Topics:

568 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...