Question about 2000 Chrysler Sebring

1 Answer

How do you unstick power seat? - 2000 Chrysler Sebring

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 3,230 Answers

Hi there,

Well you can please follow the below steps -
1. Lean into the backseat of the car behind the driver's seat. Shine a flashlight underneath the driver's seat and use a mirror to inspect the horizontal fore/aft adjuster screws. These screws can be identified as the long and horizontally placed screws underneath the seat.
2. Remove the power seat by loosening and removing the bolts that keep it connected to the floor. 3. Use a clean, wire brush to clean any mechanism that appears oxidized. Toggle the seat adjuster switch in both directions to clean all visible and non-visible parts. Toggling will also help you determine if the cleaning has restored full functionality. 4.Use a generous amount of grease to coat the adjuster screw mechanisms. 
5. Turn the adjuster seat switch on and off. Try all of its functions to make sure that they're all operational.
6. Replace the vehicle seat. Make sure the fasteners are torqued to 61 Nm (45 foot pounds) to ensure that the power seat will work optimally. Post comments if further you have the same problem.....

Good Luck!!


Posted on Jul 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to unstick a thermostat in a 2000 chevy malibu

Theres no good way to unstick thermostat. Just replace it!

Oct 10, 2015 | Cars & Trucks

1 Answer

My 4514 Honda has a snow blower for the winter . It keeps stalling and the fuel pump never shuts off so I guess isn't pressurizing . I pulled the fuel line at the carb & it is pumping gas ....

sounds as if there is sticky gum in the carb that is keeping the float from seating unless it is hot enough to unstick. Take the carb bowl off and examine it for gum (real old gasoline will do that.

Feb 02, 2015 | Honda Cars & Trucks

1 Answer

Webasto sunroof wont close

check to see if you can use the manual crank to unstick it then use the power

May 08, 2014 | 1998 Isuzu Rodeo

1 Answer

The seat warmer button is stuck on. the heater is working but I don't need my "seat" warmed that much:) any way to unstick it?

is your seat staying hot? the if so just order a replacement switch from your dealer .{if you needed a more expensive part then I would have suggested that you visit your local vehicle dismantlers } but the switch should not be too expensive ..and to replace all you need to do is turn of power{disconnect the battery just for safety .} the using a small blade screwdriver prize out the original switch and just unplug from the wiring loom and then when you have your new one just click in the wiring and click the new switch and you should be sorted ..if that has not sorted your problem then the relay may be fused in the closed position {but unlikely } but for now if its annoying you the just remove the appropriate fuse .good luck

Oct 22, 2013 | 2006 Hyundai Tucson

1 Answer

My power seat won't move forward or backwards.

its stuck, find someone to unstick it.

Aug 05, 2013 | 1997 Honda Accord

1 Answer

Where is the transfer case control module located on a 1997 chevrolet silverado

Try driver side behind trim panel behind seat if extra cab same place should on the side behind panel good luck other place would be on back or side transfercase sometimes u can give it a tap with small hammer to get them to unstick but that's just temp fix

Feb 21, 2013 | Cars & Trucks

2 Answers

Stuck rear door

I have the same problem with my 2003 I can't get the little door open that is behind the drivers side.

Jul 29, 2010 | 2002 Ford F150 Regular Cab

1 Answer

2000 nissan altima: driver side seatbelt is in fully retracted position and stuck.. how do i unstick/loosen it?

Take the bolt out of the top of the seat belt and release the pressure on it.If this doesnt work the safety module will have to be replaced.

Jan 18, 2010 | 2000 Nissan Altima

2 Answers

1994 olds 98 rear seat belt (behind driver seat) is stuck

If brute force doesn't unstick it remove the back seat and pull the cover off of the reel. The problem should be apparent. You can turn the reel with a large screwdriver if need be.
If the belt is damaged find another one at your local recycler, the side reel is behind a plastic panel that is easily removed, the assemblies are held in by big bolts.

Sep 13, 2009 | 1994 Oldsmobile Ninety Eight Regency

1 Answer

Rear right seat belt will not release when you try to pull out is stuck how do i access to replace or to unstick

Spray with WD40 and try to unlock. If you need to access it, pull up the seat from between seat and backrest, it will pop out.

Jun 15, 2009 | 2000 Toyota Avalon

Not finding what you are looking for?
2000 Chrysler Sebring Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides