Question about 2000 Toyota Sienna

1 Answer

How much freon does 2000 sienna take to fill from empty

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

3 pounds; there is a sticker under the hood

Posted on Jul 14, 2010

  • rokoszjs Jul 14, 2010

    3 pounds

    there is a skicker under the hood that tells this

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

A/C blowing hot air 2000 CDX Daewoo


over filling it was a big mistake, so was guessing.
the freon is added by weight, from empty. not volume.
if the compressor spins, and no cold air , then its a big problem
the only tiny problem to cause this would be leaves packed in evaporator coil. (deep inside air box in cab)
take it to a shop before you damage the compression and fill the whole
thing full of metal chucks wrecking everything, at once $$$$
do not let the compressor run, if it dont get cold. do not.
get it serviced.

Apr 12, 2013 | Suzuki Forenza Cars & Trucks

1 Answer

Why does my 2004 toyota sienna cool and then not cool


Make sure the Freon pressure is between 30 to 40 Psi, maybe vacuum the system and fill gas again.

Sep 30, 2012 | 2004 Toyota Sienna

1 Answer

How do I add Freon to 2000 Izuzu Trooper?


There is only two ports on the ac unit. when you get fluid at auto store,the end will only fit one and that will be the low pressure side so dont bother about putting it on the wrong on. Simply start car up an turn the ac unit on ( it must be on ) hook up fluid and fill until can is empty. some come with gauge which will show how much is needed and if not dont bother just let the can empty. In most cases it take the whole can anyways......hope this helps and good luck.

Aug 12, 2012 | Cars & Trucks

1 Answer

Ac on i am getting hot air only


Out of freon. The only thing that you can do is locate the fill ports that look like valve stems for filling tires, take the cap off and depress the needle valve with something. If you get some pressure spraying out then you can buy a refill kit and add freon to it. If you dont get anything coming out when you do that, the whole system is empty and it means that you need to take it in and spend a lot of money to have it professionally redone.

Aug 06, 2012 | 2000 Jeep Grand Cherokee

1 Answer

Puts 3 cans of R12 freon still not cold. This is 2000 sienna. How many cans does it need?


Three cans (36 ozs.) of refrigerant is probably more than an empty system would hold; however, I'm more concerned that you have put in the wrong refrigerant because most if not all vehicles since at least 1993 are using R-134 refrigerant.

Aug 08, 2011 | 2000 Toyota Sienna

2 Answers

My 2001 sienna air conditioner is blowing some cold air but could be colder. Can I just replace freon?


A lot of your local parts stores sale a hand held device that you pull the trigger on with it hooked to you ac line and it will tell you if it is low or ok or over charged. It comes with a can of R134 and I think it was around $40 but it is well worth it so you don't over fill andlock up your AC pump

Jun 30, 2011 | 2001 Toyota Sienna

1 Answer

Hi, I have 2000 Toyota Sienna, after using the AC for some minutes its cut off and never cool again till I switch it off and on it later. I just replace the condenser and re-fill the gas. What could be...


The catalytic converter has no bearing on your air conditioning system. If the compressor is shutting off, it is because of inadequate freon, or air and moisture in the system. When you replaced the condenser, the dryer should have been replaced with a new one. The system should have been completely evacuated of any old freon and fresh freon and oil put back in the system. If the a/c guy didn't change the dryer, then the system has been contaminated with whatever was accumulated inside the old one. If your catalytic converter is bad, the computer will trigger trouble code and the check engine light will come on. Have ethe computer scanned for trouble codes.

Jan 14, 2011 | 1998 Toyota Sienna

1 Answer

How to add refrigerants? To a 2000 buick lesabre.My car is blowing hot air it went from cool to hot. and now it just hot air coming out.


look for the fitting that is the smaller of the two and is attached to the line that is the larger of the two, this is the "low" fill side, add 2 cans of r134a freon each can is one pound the system empty holds 2 3/4 pounds of freon thats 2 3/4 cans.
I would buy 1 can of leak detector/freon combo and one can of dye/freon combo, if it takes more add a small amount of a third can that has an oil mixture in with the freon that would complete your systems needs the cheapest and fastest way possible.
If you want it done to the book then you need to have a certified A/C man vacumn pump down the system, replace the reciever drier, add freon and oil to fill the system and then check for leaks.
Happy Motoring!!

Jul 14, 2010 | 2000 Buick LeSabre

2 Answers

How much freon goes in a 2000 Chevrolet Silverado ?


If a/c system is empty, a full recharge of freon is 1.98 lbs. of 134a freon almost 2 lbs.

Jun 16, 2010 | 2000 Chevrolet Silverado

2 Answers

2005 Sienna Steering Turnning Problem


Hi, first thing is to check the power steering pump reservoir to see if its empty. if so, fill to specs. if the problem still exist, make sure the power steering belt is tight and is free spinning and the pulley is working as well.

Mar 13, 2009 | 2004 Toyota Sienna

Not finding what you are looking for?
2000 Toyota Sienna Logo

Related Topics:

1,059 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...