Question about 1994 Jeep Grand Cherokee

1 Answer

Oil leaks from oil pressure sending unit on my 1994 jeep grand cherokee limited v8 5.2 liter

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Replace it immediately the leak will only get worse. On some, you may need a sending unit socket, unless it has flat sides that will work with a wrench. Wrap the thread with teflon tape (one turn) to prevent it from leaking there and do not over-tighten or it will snap off.

Posted on Jul 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil leaks on my jeep grand cherokee 2000


Most common are valve cover gaskets worn out...especially the inline 6 cylinder...inspect the oil pressure sending unit located beside the oil filter...these are the most common and least costly fixes...Hope this helps.

Aug 03, 2012 | 2000 Jeep Grand Cherokee

1 Answer

Oil leaks from oil pressure switch on 5.2 liter engine in 1994 jeep grand cherokee. Need instruction for location and replacement in vehicle.


lets step back and take a look at what your are saying?so you have an oil leak from the oil pressure switch, and you ask me for instructions to the location?then you want to replace the vehicale?????? sory im lost .adrian,,,

Aug 07, 2010 | 1994 Toyota Camry

2 Answers

Where is the oil pressure sending unit on a 1993 jeep grand


on the 4.0 motor Under hood, passenger side, lower engine area, rear of distributor, mounted in engine block.
on the v8 Under hood, center, rear engine area, passenger side of distributor, mounted in block.

Feb 09, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Where is the oil pressure sending unit located on a 2000 jeep grand cherokee 4.0 liter


Removal & Installation
  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure sender connector (4).
  5. Remove the pressure sender (2).
6eaedba.gif
Oil pressure sending unit


To install:
  1. Install oil pressure sender.
  2. Connect oil pressure sender wire.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.

Jan 12, 2010 | 2000 Jeep Grand Cherokee

1 Answer

1993 Jeep Grand Cherokee, V6. Oil Pressure Gauge Read High.


it could be the sensor you should look at the oil pressure relief valve

Jun 10, 2009 | 1994 Jeep Cherokee

2 Answers

Oil leak from sensor


It's called an oil pressure sending unit. There are two versions one for vehicles with a light on dash, one for those with a gauge. It's not expensive and MUST be replaced. Not hard to do.

May 11, 2009 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1994 Jeep Grand Cherokee Logo

804 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...