Question about 1991 Ford Bronco

1 Answer

Where is the back up light switch located in the engine compartment for a 1991 Ford Bronco XLT with a 302 V8?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 667 Answers

The back up light switch is located on the transmission, left side, it is the trange selector switch as well. Hope this helps, Let mw know.

Posted on Jul 07, 2010

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel pump on 1990 ford bronco 302 V8 5.0 liter


Under the Hood.

You can find the exact one on

www.bbbind.com and put your Exact car in for the Location

Apr 12, 2013 | 1990 Ford Bronco

1 Answer

Don't watch video My project I have a 1991 Ford XLT Lariat that had a 302 efi V8 in it. I noticed I lost power one day and progressively gotten worse. I was going through 3 qts of oil a day in the la


Are u leaking oil if not your piton rings have gone most luckily and it is a huge job to put new ones back In might be best to get a new engine

Nov 02, 2012 | Cars & Trucks

1 Answer

How to replace an exaust manifold on a 1991 ford bronco 302-v8


start by removing nuts from exhaust pipe on the underside, then remove the 8 bolts that hold manifold to engine and pull it up. make sure when reinstalling you inspect the gasket and replace if needed. there is also a circular gasket between the exhaust manifold and the exhaust pipe, inspect and replace if needed. reverse for install.

Jun 03, 2010 | 1991 Ford Bronco

1 Answer

1990 Ford Bronco, 302 v8 (5.0), AOD Auto Transmission, Edelbrock Intake, headers, 23Lb injectors. Truck will start anr seems to run fine but dies when put into gear, acts like there is a dead spot when I...


is your computer inside the engine compartment? if so i am geussing it got coolant on it also and is keeping the injectors open and running the pump when it should be off.

Jan 25, 2010 | 1990 Ford Bronco

1 Answer

302 v8 on a 76 ford bronco just rebuilt has


sounds like your timing is way off,if no timing gun and you dont have specs,loosen your distributer a bit and rev your engine to about3000 rpm and just listen to the engine while you slightly turn the distibuter until it is the smoothest sounding with no sputtering then tighten your distributer back up or pay the bucks get it timed at a shop its cheap

Oct 19, 2009 | 1981 Ford Bronco

1 Answer

Where is the thermostat located on a 1991 ford bronco fullsize with a 5 liter 302 cubic inch engine


follow the upper radiator hose to the engine it is behind the housing that the hose is clamped on, two 13mm bolts hold it on

Aug 03, 2009 | 1991 Ford Bronco

1 Answer

Spark plug wire diagram


1-5-4-2-6-3-7-8 counterclockwise

Jul 11, 2009 | 1986 Ford Bronco

1 Answer

My thermacter is bad


Part of the air filter system that uses hot air from the exhaust manifold to warm up inlet air during cold weather operations. It is actuated by a vacuum hose connected to the intake manifold by a check valve that goes to a small actuator valve in the intake snorkle of the air filter container. Make sure the vacuum check valve is in series.

May 23, 2008 | 1988 Ford Bronco

Not finding what you are looking for?
1991 Ford Bronco Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...