Question about 1994 Plymouth Voyager

1 Answer

Where can I find the map sensor in a 1994 plymouth voyager

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Plymouth Master
  • 17,970 Answers

For 1994 Plymouth Truck Voyager 2WD 3.0L MFI 6cyl the MAP Sensor is located under hood, passenger side, upper engine area, end of intake manifold cover, mounted next to alternator on engine.

Hope helps (remember rated this).

Posted on Jul 05, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
leetamara
  • 702 Answers

SOURCE: 1994 plymouth voyager hood release cable broken

Get a flash light and shine it under the hood and use a screw driver to pull the latch over to one side to pop the hood open.

Posted on Jun 12, 2008

  • 102 Answers

SOURCE: will a distributor from a 1994 plymouth voyager with 3.0 engine fit a 1997 plymouth voyager 3.0?

I don't think so, 1996 was the change in computer systems for all cars and trucks

Posted on May 18, 2009

marge48
  • 20 Answers

SOURCE: SETTING TIME ON 1994 PLYMOUTH VOYAGER

Hi LMSADA,

Contact the parts store that sold you the timing belt and they should be able to give you the timing settings on your van.

You know if you are going to keep doing major work on your van it would be worth your while to purchase a Chilton's book that is specific for your van.

Marge48

Posted on May 20, 2009

  • 7353 Answers

SOURCE: What does a MAP Sensor look like, where is it

So you dont know where it is, or what it looks like, but you know its bad, and need to replace it? Its on the end of the intake plenum, 3 wires, once you find it, you will figure out how to replace it.

Posted on Oct 14, 2009

  • 1129 Answers

SOURCE: 1994 plymouth voyager heating problems. Just

After the car warms up feel the heater hoses that go into the fire wall from the motor both should be warm if only one is warm and the other is cool the heat valve that opens the flow of antifreeze to the heater core is not functioning locate the valve (either under dash in passenger compartment or in the egine compartment) it has a vacuum line going to it and it should have vacuum when the heat is on if not replace the vacuum line or valve itself. Back flush heater core and also be sure the level of antifreeze is up to the top low antifreeze will cause no heat to occur.

Posted on Jan 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have 2000 plymouth grand voyager cold strat runs ruff and has no codes


Possibly MAP sensor, cold air idle control in throttle body.
Can clean intake with throttle body cleaner

Oct 20, 2014 | 2000 Plymouth Grand Voyager

1 Answer

Too much gas being dumped into throttle body of 1988 plymouth voyager v6


at the risk of asking for clarification on motor size and equiptment, im going out on a limb and guessing you have one of three problems, 1)bad o2 sensor,2)map sensor, map sensor hose,or 3)if you have an egr valve, it could be leaking and tricking the o2 senson, oh yeah, did i mention the coolant temp. sensor could be telling the ecm that it is -40 degrees? check the vacuum line to map sensor for cracks, you should have a lable under the hood to show you the hhoses. also the coolant sensor is near the distributor, unplug it and chheck for corrosion on the terminals, as for the o2 sensor you are going to need a scanner or volt meter tocheck that.but check the basics first. vacuum leaks,ect.

May 04, 2012 | 1988 Plymouth Voyager

1 Answer

Where is map sensor located on 1998 plymoth voyager


Its on the top of the BLACK PLASTIC going to your air filter..IT will be 2 inches by 3 inches with 1 plug and 3-4 screws holding it depending on engine size.....Make sure when you remove it to get the hole cleaned out sometimes the old map sensor breaks the plastic off.

Mar 11, 2012 | 1998 Plymouth Voyager

1 Answer

I have a 95 plymouth voyager with a check engine lite that is reading code 14 what is this


That's voltage side of M.A.P. sensor. Check connector and clean it, and re-try , if that doesn't work replace the MAP sensor.

Jul 13, 2011 | Plymouth Voyager Cars & Trucks

1 Answer

What do engine light codes 12 32 15 13 mean on a 94 voyager van


12- is battery has been disconnected recently, or went dead. Nothing to be concerned about.
13- Map sensor or vacuum to it, faulty.
15- is a speed sensor malfunction, such as bad connection, or faulty sensor.
32- is EGR related, perhaps vacuum line off, or bad, or faulty valve as well.

That's 2 issues related to vacuum lines, so I'd look at them real close before replacing parts.

Oct 10, 2010 | 1994 Plymouth Voyager

1 Answer

Po108 and po172


P0108: MAP sensor circuit high input
P0172: System too rich (bank 1)
Possible repair for '108', replace the Map sensor. Clear codes and run car. If ok, the MAP sensor may have caused the '172' error. Hope this helps.

Nov 15, 2009 | 1997 Plymouth Grand Voyager

1 Answer

Will a distributor from a 1994 plymouth voyager with 3.0 engine fit a 1997 plymouth voyager 3.0?


I don't think so, 1996 was the change in computer systems for all cars and trucks

May 17, 2009 | 1997 Plymouth Voyager

1 Answer

94 plymouth voyager 94 won't shift to higher gear


Trans is in limp mode. Speed sensor problem with the transmission. Take it to the dealer. I had mine done for 186 bucks.

May 06, 2009 | 1994 Plymouth Grand Voyager

Not finding what you are looking for?
1994 Plymouth Voyager Logo

Related Topics:

399 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...