Question about 2004 Toyota Avalon
Posted by Anonymous on
Pull on the belt to see the tensioner pulley move put a wreanch on the nut holding the pulley on and pull the tensioner back as now the belt is loose slip it off the easiest pulley to grt to. work the belt off the reat of the pulleys and work the new one back on till you getr back to the easy one pull back on the tentioner and slip the belt over the easy pully letting loose of the tenstioner will keep the belt tight.
Posted on Jul 05, 2010
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Actually you don't have to do all of that. I just replaced one from the top. On the passenger side of the engine where the belt is, you will see the tensioner in the middle. Using a larger breaker bar with the socket that fits the bolt in the middle of the wheel, force the tensioner toward the front of the car to release pressure to remove the belt. I think it was a 15mm but can't remember for sure. I do know they are all metric sizes on that engine. The tricky part is to remember how the belt is routed. If you forget, see the diagram below. There isn't much room to work, but I'm proof that it is possible. When putting the new best on, route all pulleys and leave the alternator for last since it's right on top and easy to get to. Good luck and be patient. It's doable.
Posted on Apr 12, 2010
locate tensioner pulley; release tension from belt; remove belt; make sure not to forget how the belt is routed; route belt around all pulleys but tensioner; put tension on tensioner pulley; route belt over tensioner pulley
Posted on Oct 07, 2009
You'll have to remove the engine cover under the bottom so you can position the new belt on the pulleys properly. Get a wrench or tensioner tool and turn the tensioner clockwise to relax the drive belt. Don't apply excessive force.
It's hard to draw a picture with words, but looking at the engine from the passenger side of the car, there are basically two top pulleys, two middle, and two bottom. The drive belt goes around the outside of the two top and two bottom, and on the inside of the two middle.
Posted on Nov 07, 2009
I have to find out how to send you a picture, I can't do it on here for some reason. if you want give me your e-mail address and I'll send it to you.
Posted on Jan 05, 2010
SOMETIMES THE DIAGRAM IS ON THE UNDERSIDE OF THE HOOD. OR ON THE WHEEL WELLS INSIDE THE ENGINE COMPARTMENT. CHECK UNDER THE HOOD ANYWHERE A STICKER COULD BE. IT MIGHT ALSO BE IN THE OWNERS MANUAL.
Posted on Feb 23, 2010
Tips for a great answer:
Jan 27, 2016 | Toyota Cars & Trucks
Oct 08, 2014 | Cars & Trucks
Aug 26, 2014 | 2006 Toyota Avalon XL
Mar 10, 2014 | 1995 Toyota Avalon
Jan 08, 2013 | 2004 Toyota RAV4
Jun 27, 2011 | 2004 Toyota Avalon
Jun 06, 2010 | 2000 Toyota Avalon
Mar 21, 2010 | 2001 Toyota Avalon
Feb 20, 2010 | 2004 Toyota Corolla
May 24, 2015 | 2004 Toyota Avalon
1,773 people viewed this question
Usually answered in minutes!