Question about Cars & Trucks

2 Answers

Hi I have a 2002 Chrysler Town & Country 3.8L engine I have replaced the starter & the Starter relay and all I get is a clicking from the relay but nothing else I have been reading up on the starting system and it says it could be the fusible link could be burned but I see no illistration where it is located can anyone help me or tell me if I am searching in the right area to solve my problem

Posted by Anonymous on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 541 Answers

Your fusible link is located on the positive wire going to the starter. bypass it to test it

Posted on Jul 05, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

First check voltage at starter, with a test light check voltage at big wire at starter, should always have voltage, then while some one turn key to start, you should only have voltage while key is held to start at small wire at starter, if you don't more then likely it's going to be the ignition switch, there no fuse link to that part of stater system, small wire comes from switch and big wire from battery, also while key is held to state check voltage again at big wire, if no voltage there, check battery connection that goes down to starter, now if you do have voltage at all check points, could be a defective starter, try hitting it with a hammer with key to start, if it stats bad starter, hope this was very helpful.

Posted on Jul 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2002 town and country will not start intermittently. Been checked out at garage. Say they cannot find anything. Most times when try to start all warning lights come on.


Will not start how intermittently ? The engine won't turn over or engine does turn but won't start . Starter relay , lose connection . Checking power an grounds would be the first place to start , voltage drop test the main electrical circuits . Voltage Drop Testing the Starter

The starter circuit control is achieved by the starter motor relay ! It is located in the under hood fuse/ relay box or as Chrysler calls it ,integrated power module ! If you pull out the relay an look on the bottom where the pins stick out you will see four sets of numbers .30,87 an 85,86 ! 30 is B+ voltage . 87 is to the starter solenoid . If you jumped those two spots where the relay plugs into the starter would crank the engine over . The last two 85 an 86 are the control side .If you checked with a volt meter where 86 plugged into ,with key on it would show B+ voltage . The last pin is from the PCM - engine computer . When turning the key to start a signal is sent to the PCM to let it know crank has been requested , in return the PCM supplies a ground to pin 85 energizing the starter motor relay sending B+ voltage to the starter motor cranking over the engine . Here is another video on test from the relay base (where relay plugs into ) This is for a horn circuit but same thing . VEHICLE RELAYS Testing from the relay base The relay could be going bad , you never know .Replacing the relay mite not be a bad idea . Good luck , hope this helps !

Jul 23, 2016 | 2002 Chrysler Town & Country

1 Answer

2004 Chrysler Town and Country won't start. Lights, radio and horn works just fine. Even put in a new starter and still get nothing. Ran a wire from battery to the starter and got a little kick.


Chrysler Town & Country Questions - My van won't start ...

www.cargurus.com > Questions > Chrysler > Town & Country

CarGurusSep 29, 2008 - ckf2004 answered 4 years ago. I have a 96 chrysler town and countrylx and the engine died, turned over but wouldn't start, I researched and replace the flywheel .... My van sometimes won't start because it kills the battery.

My town & country 2004 wont start sometimes - CarGurus

www.cargurus.com > Questions > Chrysler > Town & Country

CarGurusMy town & country 2004 wont start sometimes - My van start doing something really weird. it will ... Asked by TownCountryguy May 03, 2013 at 03:31 PM about the 2004 Chrysler Town & Country Base .... Sometimes you tap it & it won't work.

Van won't start - Chrysler town and country - YouTube

? 1:01
https://www.youtube.com/watch?v=mkEL2vlLZr0
Jun 26, 2014 - Uploaded by Philip Walker
We have the same issue currently...very randomly...with our 2008 Caravan at the moment. Wife just got ...

2011 Chrysler Town & Country Engine Won't Turn Over, Will ...

www.carcomplaints.com/Chrysler/Town_Country/.../engine_wont_turn_...
The 2011 Chrysler Town & Country has 34 complaints for engine won't turn over, will not start. Average repair cost is $902.00 at 58178 miles.

Jan 14, 2016 | Chrysler Cars & Trucks

2 Answers

2001 Chrysler Town & Country. When turn key to start nothing happ


Two things to try, If you have a second origional key try that first. If the problem still persists, you will need to take the vehicle to a reputable garage to have the problem diagnosed. You could have a bad key and the theft deterent system is causing the problem or it could be a bad ignition switch or start relay.

Nov 07, 2009 | 2002 Chrysler Town & Country

1 Answer

Describe your 2002 Chrysler Town &


Safety neutral switch o.k.? Tried moving shifter through all gears while holding key in start position?

Aug 03, 2009 | 2002 Chrysler Town & Country

1 Answer

2002 Chrysler Town and Country won't start.


Clean your battery terminal contact surfaces and verify actual battery voltage (should be at least 12v) Also check that both battery cables are secure and clean on other end. Then, check starter relay if problem continues.

Aug 02, 2009 | 2002 Chrysler Town & Country

1 Answer

'02 T&C starting click click click vroom


needs the starter replaced. The solenoid is going bad.

May 28, 2009 | 2002 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...