Question about 1993 Chrysler Lebaron

1 Answer

I have a 1993 Chrysler Lebaron. I parked it and now it will not start. I cleaned the battery cables and checked all the wires nothing wrong there. I still have power to everything sonot the alternator. I hear a clickng noise when I turn the key to the start position. Do you have any sugestions as to what might be wrong?

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 6,826 Answers

If the connections are clean and tight, and the battery is good, it should start, unless the starter itself is bad.

That's what I suspect.

Good luck to you.

Posted on Jul 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 Chrysler LeBaron speedometer under reports the speed. Is there a plastic gear for speedo or does the dash cluster have to come out?


speedometer drive gear in the transaxle where speedometer cable goes into transaxle.could just have loose speedometer cable bolt.

Oct 05, 2012 | 1993 Chrysler Lebaron

1 Answer

Firing order 1993 3.0 liter chrysler lebaron diagram


Check this for 1993 Chrysler Lebaron 3.0 liter SOHC V-6 VIN "3"

zjlimited_734.gif

In this link find additional details about Car's Firing Order

Hope this helps (remember to rate and comment this free answer; leave an testimonial).

Sep 26, 2011 | 1993 Chrysler Lebaron

1 Answer

95 LEBARON won't start, its dead not the battery


If the battery and the starter are good then you need to check the ground to the motor,or clean the battery cable ends with a knife to get off the black **** that builds up on them over time.

Nov 01, 2009 | 1995 Chrysler LeBaron

1 Answer

Have a 1993 chrysler lebaron has an aftermarket alarm we have no remote for it it has enabled itself so now we cant start it disables the ignition does any body have any ideas on how to disable it our car...


Under the dash you should find the fuses for the system. They won't be in the fuse box. You are looking for wires that are wrapped in electrical tape. The fuse holders should be hanging somewhere around the bottom of the column or near the left kick panel. Remove the fuses to disable the system. Now after you have done this you need to find the added in relay for the starter disable. This should be hanging around down there too in the same area. Two of the wires from the relay should go in to the column or splice into the wiring going to the ignition switch in the column. Hook these two wires together and then you should be able to start the car.

Sep 02, 2009 | 1993 Chrysler Lebaron

4 Answers

My car wouldnt start , not even tringto turn over. I changed batteries, nothing. took starter off, it checked out bad , so got another starter, and still nothing. I even took battery out off vehicle I was...


THEN IT IS DEFINITELY A ELECTRICAL PROBLEM, TAKE IT TO A SHOP AND PUT IT ON A DIAGNOSTIC MACHINE, SO YOU WON'T KEEP PUTTING UNNECESSARY MONEY INTO IT. THEY WILL TELL YOU WHAT'S WRONG.

Jul 09, 2009 | 1993 Chrysler Lebaron

1 Answer

Code 12 shows up when using key to check for codes on 1993 lebaron 6 cly. nothing shows on scan tool


12 means that the battery has been disconnected sometime in the last 255 starts. 55 is the end of the test. Any codes that are stored will be between these two numbers.

Apr 19, 2009 | Chrysler LeBaron Cars & Trucks

1 Answer

Car not turning over


There are two relays on the firewall drivers side(Little black cubes attached by a bracket).
One is fuel pump and the other is ignition. They function like points did in old cap and
distributor vehicles. Anyway you can get replacements at auto parts store. They are not
attached by the same type bracket as the original but you can drill a hole and use a self
tapping metal screw to attach one of them as the original has only one screw. Replace
both at the same time to save another break-down. Hope this helps.

Feb 01, 2009 | 1993 Chrysler Lebaron

1 Answer

1993 chysler lebaron stalled


Hi Seems to be fine now thanks and I have a 1993 chrysler lebaron

Jan 06, 2009 | 1994 Chrysler LeBaron

1 Answer

Battery Cable Replacement help?


whell now you have two problems but try to jump start the car and let me know what happens, also did you replace the batterie cable with the conector at batterie? or just the cable, if it was just the cable remove the conector and clean it inside

Jun 21, 2008 | 1993 Chrysler Lebaron

Not finding what you are looking for?
1993 Chrysler Lebaron Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...