Question about 2001 Chevrolet Blazer

1 Answer

My wipers dont work and my right signal light flashes fast and my rear wiper dont work. some kind of sensor problem but not sure where that sensor is

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

Ck fuses for wipers and rear wiper, the signal flashes fast most likely because theres a bulb out, turn on the hazard lights and see which bulb is out.

Posted on Jul 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

1999 ford explorer rear wiper don't work


hi there
this is pretty typicalof rear wipers check fuse first to make sure it is good if that doesnt work it is probably the motor which goes out and you can pick one up at your local auto parts store hope this will help you and have a great day

Aug 21, 2011 | 1999 Ford Explorer

1 Answer

Where can i find the switch of my rear wiper?


switch for rear wipers are located the wiper lever (facing the steering wheel, its the right lever opposite the signal lights lever). at the end of the right lever, there is a switch similar to the switch for your headlights.

Aug 05, 2011 | Nissan Minivan Cars & Trucks

1 Answer

I have a 1998 Plymouth voyager and the climate control lights are flashing. I ran a test i found on the internet and got it down to two lights flashing(the ac and the recirculate). I got it to where the...


OK got your message on the other post (About the van) I am assuming that your Voyager is equipped with Automatic Climate Control. Follow the instructions below and you will get a better idea of what is wrong with your system.

Calibration/Diagnostics
1. To enter calibration/diagnostics test, set parking brake. Start and warm engine to normal operating temperature. With engine idling, turn blower switch to high. Turn mode switch to panel. Open all outlets. Move temperature to full cold.
2. Press and hold rear wash and rear wiper buttons simultaneously for 5 seconds (Until ALL LEDs illuminate). All LEDs should illuminate for 5 seconds. Rear wiper and intermittent rear wiper button LEDs will flash alternately during calibration/diagnostics test.
3. After approximately 60 seconds, if only the rear wiper button LED is flashing, calibration is successful and the system is okay. If rear wiper and intermittent rear wiper button LEDs are flashing, Diagnostic Trouble Codes (DTCs) are present. (See "Reading Diagnostic Codes" below)
4. To exit calibration/diagnostics test at any time, press the rear window defogger button, rear wiper button, or cycle the ignition off and then on. Test will automatically terminate 15 minutes after calibration/diagnostics is entered.

Reading Diagnostic Codes
1. Perform calibration/diagnostics test. If a DTC is present after calibration/diagnostics test has been performed, system will flash rear wiper and intermittent rear wiper button LEDs in sequence. Rear wiper represents code level, and intermittent rear wiper button LED represents code value.
2. Each time the rear wash button is depressed, rear wiper button LED wil cycle to the next code level in numeric sequence. After code level 5 is reached, rear wiper button LED will cycle back to code level 1. See table below.

dttech_67.gif

May 12, 2011 | Plymouth Voyager Cars & Trucks

1 Answer

Is there a procedure to check the wiper motor on 1991 S10 pickup (only 42000 miles), to be sure it is defective and not a wiring problem?


ONLY PROCEDURE FOR WIPER MOTOR IS YOU HAVE 2 SPEEDS THAT WORK SLOW AND FAST SPEED.WIPERS WILL RETRACT TO THE BOTTOM OF HOOD LINE WHEN YOU TURN OFF. WIPERS SHOULD TURN OFF. CHECK WIPER RESERVOIR MAKE SURE ITS FULL AND WIPER WASHER SPRAY FLUID CLEAN WINDSHIELD. IF WIPER MOTOR DO ALL THE ABOVE THEN ITS OKAY.IF WIPER MOTOR WORKS SLOW LOOK FOR BINDING AT WIPER ARM LINKAGE AND PIVOT LUBRICATE LINKAGE AND PIVOT COULD HELP.IF WIPER MOTOR DONT WORK CHECK FOR POOR GROUND OR BLOWED FUSE.WIPER WORK AT ONE SPEED CONTROL SWITCH IS BAD.IF WIPER BLADES STOP WHERE EVER THEY ARE OR FAIL TO TURN OFF UNLESS YOU TURN OFF IGNITION SWITCH WIPER MOTOR LIMIT SWITCH BROKEN.IF WIPERS DONT RETRACT BELOW BOTTOM HOOD LINE LOOK FOR MECHANICAL OBSTRUCTION OR WIPER MOTOR FAULTY.

Nov 14, 2010 | Chevrolet S 10 Cars & Trucks

1 Answer

Lights are flashing on the heater controles [the ac , back wiper , all buttons there ] what fixes that. on my 98 dodge caravan


push and haold in the rear wiper and rear washer butts for 5sec or until all lights flash but make sure yor motor is warm and that the ac is on high first.. wait until all lights except for the rear wiper light are off then press the rear wiper button once more..

Jun 19, 2010 | 1998 Dodge Caravan

1 Answer

1996 dodge caravan. the right signal light works sometimes,I have replaced the multi function switch twice with the same results, it only works when it wants to. There does not seem to be a pattern ie:...


I have the same problem. My wiper was not working and I replaced the BCM, now the wiper is working but the left turn signal is not. I believe it is related to the BCM. HL

May 18, 2010 | 1996 Dodge Caravan

2 Answers

Wiper not working ford galaxy m2


No solution sorry - mine have done exactly the same - will wipe front screen if you mess with the stalk - rear wiper works when you push the stalk forwards or backwards but no washer to either - have you found a solution? Kind regards - Andy

Jan 04, 2010 | 2005 Ford Futura

2 Answers

1994 Chevrolet K1500 pickup: wiper and turn-signal problems


The wiper and turn signal switch all on the same stalk switch?
Let me know.
Regards,

Apr 09, 2009 | 1996 Chevrolet K1500

1 Answer

Rear Lights and Wiper Problem


any time you have a crazy electrical problem always check ground connections

Jul 23, 2008 | 2002 Dodge Dakota Club Cab

Not finding what you are looking for?
2001 Chevrolet Blazer Logo

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...