Question about 2007 Chrysler Sebring Sedan

1 Answer

My keys r stuck in the ignition of a chrysler sebring 2007

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 501 Answers

Try wriggling the wheel,or taking the load off .you may have parked it with wheels on hard lock

Posted on Jul 04, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 254 Answers

SOURCE: Keys stuck in the ignition

Try to wiggle the steering wheel back and forth. Most likely you may be experiencing a bad ignition switch.

Posted on Oct 12, 2010

ftw1952
  • 10319 Answers

SOURCE: my keys are stuck in the ignition of my 2007

The tumblers inside the key lock cylinder has jambed up causing this to happen. The only remendy is to replace the key lock cylinder

Posted on Jul 16, 2010

RonPark
  • 855 Answers

SOURCE: 2007 chrysler sebring stuck in park, tried to

IS the car parked on a hill? If so you have to relieve the pressure on the trans. The pressure can be strong enough to prevent the shifter from moving. Also the shift cable could be bad.

Posted on Jun 28, 2009

  • 363 Answers

SOURCE: 2001 chrysler sebring convertable key stuck in ignition -

Is the gear shift button stuck in, if so hit the gear shift a couple of time and that should unstick the botton, allowing you to remove your key

Posted on Jul 23, 2009

  • 538 Answers

SOURCE: 2007 chrysler sebring serpentine belt diagram

Go to; daycoproducts.com, click cars and trucks, then go to serpentine belt. Then on the right side of the screen click on finding your vehicle. Then get the illistration number and click on illistrations, go to that number it should something 6-? or 7-?. It's a pretty good websight.

Posted on Jan 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My key will not come out of the ignition,I don't want it to die, and the reminder was dinging as I got out. Has anyone else had this problem with a Chrysler Sebring?


e steering wheel a little bit back and forth when turning the key to get it out. It may have partially locked. Spray a bit of WD 40 into the lock barrel. Don't use CRC as it will wash out the lube in the lock and the key will stick even more...

Feb 03, 2016 | 2004 Chrysler Sebring

2 Answers

Windshield wipers stop working when the defroster is on


The only thing they have in common is the ignition switch.

Dec 18, 2015 | 2007 Chrysler Sebring Sedan

1 Answer

When i turn key on my 2007 chrysler sebring the starter gets stuck and keeps trying to start even when releasing key have to turn off and remove key to stop starter


there are a few things that will cause this problem 1 is a stuck solenoid, 2 starter drive pinion stuck in the ring gear or flywheel. 3 ignition switch is shorted internally. I would try tapping the starter motor with a hammer or steel bar then turning the key to the on position... If the problem is gone replace the solenoid.

Apr 27, 2014 | Chrysler Sebring Cars & Trucks

1 Answer

2007 Chrysler Sebring Says keys in ignition but there's no keys in? What can I do? It won't let me lock my doors


try to reset by disconnecting battery, if problem persists replace ignition switch

Mar 17, 2014 | Cars & Trucks

2 Answers

1997 Chrysler Sebring starts everytime but shuts off after five seconds everytime. Getting fuel and spark. What could be causing the shutdown?


It sounds like you computer system has gone into "Theft Protect Mode". There is most likely a problem with your security system and the computer "thinks" that the vehicle is being stolen. This can be due to the wrong key being used, or it could be a bad ignition switch or theft module. I would recommend having it diagnosed professionally. It would be very difficult to diagnose the problem without the required computer diagnostic equipment. If any of the parts of the security system are defective, the computer will have to be reprogrammed when they are replaced.

I would, however try a different key in the ignition if you have more than one - before having it towed to a repair facility. If another key works, you will only need to get a replacement key and have it programmed for your car.

Apr 17, 2011 | 1997 Chrysler Sebring

2 Answers

My keys are stuck in the ignition of my 2007 sebring


The tumblers inside the key lock cylinder has jambed up causing this to happen. The only remendy is to replace the key lock cylinder

Jul 16, 2010 | 2007 Chrysler Sebring Sedan

1 Answer

I have 1996 sebring my key is stuck in the ignition


first thing to try would be to remove car from park to a gear and then put firmly back into park...... then retry,
if doin that a few times dont work, you will prob need to replace the ignition cylinder....... make sure it appears gear selector levers parts are all in their place,, visually that is

Jan 22, 2010 | 1996 Chrysler Sebring

2 Answers

Reset oil change message.


YOU TURN IGNITION TO RUN POSITION..ENGINE OFF..PRESS ACCELERATOR 3 TIMES WITHIN 10-15 SECONDS..RELEASE AND TURN KEY OFF..THEN START VEHICLE,IT SHOULD BE RESET

Jul 11, 2009 | 2008 Chrysler Sebring

1 Answer

2001 chrysler sebring convertable key stuck in ignition -


Is the gear shift button stuck in, if so hit the gear shift a couple of time and that should unstick the botton, allowing you to remove your key

Jul 04, 2009 | 1998 Chrysler Sebring

2 Answers

Key stuck in ignition


spay some DW40 in the key slot and wait abut 5 to 10 mins. wigger the key, and slide it out.

Nov 03, 2008 | 1998 Chrysler Sebring

Not finding what you are looking for?
2007 Chrysler Sebring Sedan Logo

Related Topics:

320 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...