Question about 1992 Honda Civic

1 Answer

Engine will turn over but will not start.

Engine will turn over but will not start.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 6,826 Answers

Check the timing belt hasn't broken or skipped
check that the ignition coil is ok.

check for spark and gas in this case. It might lead you to a solution.

Good luck on this.

Posted on Jul 04, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

05 ford ranger started knocking and shut off now won't crank. What is wrong?


Started knocking and shut off ? Now will not start?
That sounds bad - check fluids - engine oil and coolant - those three symptoms can indicate overheating (either by lack of coolant or engine oil).
Did either fluid get low AND does the engine oil look contaminated - milky colored and way overful.
Not Start? Does it turn the engine and just not fire up running?
Or does the engine not turn over at all?
If the engine is siezed - you can tell by the electrical power needed to crank the engine - turn on the lights and try to crank the engine - if all you hear from the starter is a click and all the lights dim - that means a lot of power is needed like:
1. the battery doesn't have enough power - jump start to verify
2. or it requires more power to turn the engine than the battery can provide - engine siezed - try turning the engine by hand with socket/wrench to verify.
I hope your engine is not siezed - if so - hope you still have warranty coverage on the powertrain.
Please let me know what you find and if this helps?

Mar 12, 2015 | 2005 Ford Ranger

1 Answer

Engine turns over but will not start.


Hi there:

When the light comes on, one or more diagnostic trouble codes (DTC) are stored in the engine control module. These DTCs remain even if the light goes out. To address a Check Engine Light problem, the DTCs are retrieved and the appropriate troubleshooting information is followed in order to determine the problem.


Just scanned the computer and send us code number find it.

Hope helps.

Mar 14, 2012 | 1995 Dodge Ram 2500

2 Answers

My car turns over good, acts like it might turn on then continues to turn. I figure it might be fuel filter since low fuel light had come on.Or could it be th fuel pump got hot and is not working properly?


common problem is turning car off with engine not reaching normal operating temp and floods engine. try this. DE-CHOKING PROCEDURE WHEN ENGINE CRANKS BUT DOES NOT START
If the engine does not start, try the following procedure to start the engine using the de-choke mode.
Failure to do so may aggravate the no start condition.
1. Depress and hold the accelerator pedal to the floor and crank the engine for 7-8 seconds. (This will clean out any unburned fuel from the combustion chamber)
2. Release the ignition key to stop cranking.
3. Release the accelerator pedal and start the engine. If the engine starts while performing Step 1 the engine will rev up. Immediately release the ignition key to stop cranking and remove your foot from the accelerator pedal.
^ Do not keep holding the ignition switch in the START position over 10 seconds if the engine does not start. This may result in a weakened or dead battery.
^ Avoid racing the engine or sudden take off right after starting the engine.
^ If the engine still fails to start following the De-choking procedure, have your vehicle inspected by your Mazda Dealer.

for your info there is a recall for this problem. contact mazda.

May 04, 2011 | 2004 Mazda RX-8

2 Answers

Battery was dead and tried to start after charging, starter solenoid clicked and engine turn over slowly without starting. Now engine will not turn over. Battery is charged have power to all accessories...


okay,think of it this way,you tried starting,engine turned slowly,no start.....then you charged battery,engine wont turn over(although accessories work)WHY WAS THE BATTERY DEAD TO START WITH.Try a jump start(another battery)if it starts then you know what im going to say.....

Nov 06, 2010 | 2005 Ford Explorer

1 Answer

Engine will turn over, but will not start


Suggestion, don;t try and start the car with the gas pedal pushed to the floor. Asking for trouble in the future.

Could be a fuel pump, clogged fuel filter.

Check engine light on? If so, Have the code read/scanned at your mechanic, or your local auto parts superstore.

Apr 01, 2010 | 2004 Ford Explorer

1 Answer

92 jeep wrangler has power but wont turn over to start


The terms "turning over" and starting are often confused... Cranking (turning over) is when the starter turns the engine, regardless of the end result. Starting is when the engine actually runs (even if for a moment).
If your problem is that the engine is turning when the starter is engaged, but not starting, then you have either a fuel or spark fault.
If the engine is not turning, check that the battery has a full charge, and holds adequate power when loaded, that proper voltage is reaching the starter and there is a good engine ground. Power should also be present at the small trigger wire on the starter when ign key is turned to start position.After checking these things you can begin to make a decision on what needs attention and proceed from there.

Feb 28, 2009 | 1992 Jeep Wrangler

4 Answers

Car shakes when trying to start and doesn't turn over


  1. hold gas pedal to floor while trying to start. do not pump pedal.
  2. holding pedal to floor is how you start a flooded f.i. engine

Nov 12, 2008 | 2000 Lincoln LS

Not finding what you are looking for?
1992 Honda Civic Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...