Question about 2005 Dodge Stratus
For my 05 dodge stratus, I got the code for the crankshaft and I can't find it! Compeletly frustrated...
I have no idea what size engine you have although I have a website posted below with photos of all made for your year. Look at them and the you can locate where yours is at by the distingushed photos I have sent
Posted on Jul 04, 2010
On the Internet there are a lot of different descriptions of where the CRANKSHAFT position sensor is on the 2005 Dodge Stratus sedan 2.4L engine.
HERE IS WHERE I FOUND IT ON MY CAR:
it was on the front of the engine, behind/under the starter motor.
HOW CAN YOU TELL IF IT IS AT THIS LOCATION ON YOUR CAR:
- One website said that if the 8th number/letter in your car's VIN number is an X then it is located here (this was true for my car).
- To confirm: See if there is a wire (3 wires together actually) leading under the starter motor (see #2 below for a description of the starter motor's location).
THESE ARE THE STEPS I TOOK TO REPLACE IT:
1. Disconnect the positive terminal of the battery. (Turn the wheels all the way to the right, remove/pull back the black plastic cover of the front of the left wheel well, thus exposing the battery, and then unbolt the red positive terminal). You NEED to do this because you'll be working with the starter motor and you don't want to get shocked.
2. Unbolt the starter motor. You can see and access the starter motor from the top. It is situated on the front of the engine block, below the air intake (see the picture). It just has two 15mm bolts on the right side holding it on. You should be able to get a ratchet or wrench to them from the top, or you may even be able to get at them better from below.
3. Lift the starter motor up out of the way. I left all of the wires connected to it, and simply tied it with twine to the plastic air intake above to keep it out of the way. 4. You should be able to clearly see and access the sensor now (see the second picture). It has one bolt, and the plug. *Make sure to put a little oil on the rubber seal of the new sensor before inserting it. 5. Put everything back, in reverse order. A COUPLE OF THINGS TO NOTE: - I believe this applies to model years 2003-2006, and to the 2.4L Chrysler Sebring sedan of the same years. - You probably don't need to jack your car up for this repair. I had my car up on ramps, but in the end I did everything from the top.
Posted on Dec 16, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Dec 28, 2015 | Dodge Cars & Trucks
Feb 24, 2014 | 2004 Dodge Stratus
Feb 26, 2011 | 1998 Dodge Stratus
Jul 19, 2017 | 2005 Dodge Stratus
Jun 30, 2009 | 2002 Dodge Stratus
Jun 23, 2009 | 1996 Ford Taurus
Mar 21, 2009 | 2000 Dodge Stratus
Jan 31, 2009 | 2005 Dodge Stratus
327 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: