Question about Cars & Trucks

1 Answer

I have a 98 jeep grand cherokee limited v8 and the battery keeps draining when the vehicle is off. It'll start fine after being jumped so we let it run to charge the battery back up for about half an hour and go check it later on and it starts. The battery isn't even a year old.

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,036 Answers

MAKE SURE BATTERY CABLES IS CLEAN FREE FROM CORROSSION. MAKE SURE BATTERY CABLES GOOD TIGHT.IF ALL IS OKAY. WELL I HAVE SEEN A GOOD BATTERY CAN ALSO BE BAD.I KNOWN PERSON BOUGHT NEW BATTERY DIDNT LAST A WEEK.IT HAD A FACTORY DEFECT ALTERNATOR WAS GOOD.DO A QUICK CHECK TO SEE IF ALTERNATOR CHARGING BATTERY.CRANK VECHICLE UP CHECK VOLTAGE OUT PUT AT BATTERY.IT SHOULD BE 13.5 - 14.5 VOLTS.IF NOT ALTERNATOR NOT WORKING CHECK ALTERNATOR FUSE AND WIRES.MAKE SURE THEY ARE INTACT.IF ALTERNATOR GOOD.HAVE THE BATTERY LOAD TEST TO SEE IF YOU HAVE A BAD CELL IN IT.IF BATTERY IS GOOD.BATTERY DRAIN CAN BE CAUSED BY RADIO STAYING ON.THE INTERIOR LAMP STAYS ON.FAULTY PCM SHORTING OUT.FAULTY DOOR LOCK SWITCH.FAULTY BLOWER MOTOR RELAY.FAULTY ALTERNATOR DIODE.FAULTY STARTER SOLENOID SHORTING CONTACTS WILL DRAIN BATERY.

Posted on Jul 04, 2010

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 17 Answers

SOURCE: Replace Drivers side Front Door

my 95 gc had bolts, removing the door was the easiest way to change the pins as they were staked in and had to be cut out. But all in all a fairly easy procedure with an assistant.

Posted on May 28, 2009

  • 40 Answers

SOURCE: 1994 Jeep Grand Cherokee V8. limited addition shuts off.

fuel filter is clogged try replacing it

Posted on Jun 19, 2009

  • 43 Answers

SOURCE: Very rough idle on 2002 Jeep Grand Cherokee Limited Edition V8

If you haven't changed the plugs or had the fuel system cleaned, now would be a good time to do it. The number 1 culprit for rough idles is dirty injectors or plugs. You can try an injector cleaner in a can (or bottle) for under $10 and see if it helps, and then work from there. If there isn't any improvement then if you are able to, check the plugs for any gunky buildup and if you find a bad plug, make sure you replace them all (or have them replaced) at the same time.

Posted on Aug 03, 2009

  • 52 Answers

SOURCE: 1996 jeep grand cherokee limited v8 5.2, A/C instructions?

  1. Disconnect battery. This must be done to prevent accidental airbag deployment.
  2. Using on A/C recovery unit, remove all R-134a refrigerant from the A/C system. See: Service and Repair
  3. Remove the shift knob by pulling sharply upward.
  4. Place the transfer case in low range. Pry the shift indicator bezel out of the console using a trim stick.
  5. Apply the parking brake and place the transfer case in neutral. Remove the parking brake trim insert. Remove the console attaching screws. Lift the console up and disconnect the 4WD indicator lamp hamess. Remove the console.
  6. Remove the passenger side knee blocker. Remove the single end screw. Remove the screws below the glove box. Remove the screw at the courtesy lamp. Remove the ash receiver and the screws behind it. Remove the instrument panel armature screw behind the ash receiver. Open the glove box and remove the screws behind it. Lower the panel and disconnect the lamp harnesses. For additional instrument panel service procedures to complete steps 6 thru 25, refer to Instrument Panel, Gauges and Warning Indicators/ Instrument Cluster / Carrier/ Service and Repair/ Procedures. See: Instrument Panel, Gauges and Warning Indicators\Instrument Cluster / Carrier\Service and Repair
  7. Remove the pod switch bezels on both sides of the steering column with a trim stick.
  8. Remove the drive side knee blocker. Remove the end screw and screws located at the bottom of the knee blocker.
  9. Remove the cowl top trim panel by prying it up with a trim stick. Remove the solar sensor if equipped.
  10. Remove the "A" post trim panels.
  11. Remove the remove the bolts that attach the lower instrument panel reinforcement to the instrument panel armature and remove the reinforcement.
  12. Disconnect the park lamp switch.
  13. Pull back the carpet at the transmission tunnel from the base of the instrument panel center bezel. Remove the nuts from the upper studs and bolts through the floor that secure the instrument panel center bracket.
  14. Remove the bolts that secure the instrument panel center bracket to the drivers side of the transmission tunnel.
  15. Remove the screws securing the Vehicle Information Center and remove it. Remove the screw fastening the mounting bracket.
  16. Unplug the vacuum harness connector or vent tube on ATC equipped vehicles and the wire harness located under the passenger side of the instrument panel.
  17. Remove the screws holding the passenger side kick panel, along with the screw from the kick panel shroud.
  18. Unplug the antenna cable near the right cowl side panel.
  19. Unplug the instrument panel wire harness connectors from the junction block at the right cowl side panel.
  20. Remove the bolts that secure the instrument panel armature to the windshield fence.
  21. Remove the nuts that secure the top if the instrument panel armature to the windshield fence.
  22. Remove the bolts that secure the ends of the instrument panel to the cowl side panel.
  23. Remove the nuts that secure the steering column to the brake pedal support and lower the steering column.
  24. Remove the bolts that secure the instrument panel armature to the brake pedal support.
  25. Place a protective cover on the seats. Lift the instrument panel off the windshield fence studs and maneuver the instrument panel out and lower it onto the seats.
  26. Disconnect the refrigerant lines from the evaporator tubes. Make sure to install plugs or tape the ends of the lines and fittings to ensure that excessive amounts of moisture do not contaminate the A/C system.
  27. Remove the vacuum line at the tee from the main vacuum supply harness. This line runs through the body with the upper refrigerant line.
  28. Disconnect the heater hoses from the heater core and clamp the ends closed to prevent coolant loss. See: Heater Core\Service and Repair
  29. Remove the coolant overflow bottle.
  30. Remove the Powertrain Control Module with connectors intact and set aside.
  31. Remove the heater A/C housing mounting nuts from the studs on the engine compartment side of the dash.
  32. Remove the heater A/C housing from the vehicle.
  33. To Install the components, reverse the procedure stated above. Torque Specifications: Instrument panel center bracket to floor transmission tunnel fastener: 28 Nm (250 in. lbs.) Instrument panel to windshield fence bolts and nuts: 12 Nm (105 in. lbs.) Instrument panel to cowl side inner panel bolts: 12 Nm (105 in. lbs.) Instrument panel to steering column support bolts: 12 Nm (105 in. lbs.)

Posted on Aug 11, 2009

  • 6982 Answers

SOURCE: Where is the camshaft sensor located on my 99 Jeep Grand Cherokee

If you still have a cap rotor and ignition wires, it's inside the distributor. If not, it is the part where the distributor used to be (center rear of the engine behind the intake manifold)

Posted on Feb 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is a 1995 jeep grand cherokee limited v8 vs. inline 6 transmission interchangeable?


No sir they will not interchange. i worked at a transmission shop for 7 years. the inline 6 has a 500 trans in it and the v8 has a 518 trans in it. the bellhousings are different.

Jan 03, 2014 | 1995 Jeep Grand Cherokee

1 Answer

Need diagram for fuse panel on 2002 Jeep Grand Cherokee


Hi George:
Other Jeep lover here (Grand Cherokee Limited 5.2L V8)... keep in mind that all this information is in the WJ owners manual...

11_21_2011_8_31_50_pm.jpg

Image: WJ Junction Block (under dash, left of steering wheel)


11_21_2011_8_32_28_pm.jpg

Image: Grand Cherokee fuses 1999-2004


11_21_2011_8_33_59_pm.jpg

Image: PDC (Power Distribution Center, under hood)

Feel free to contact us in the previous link if need additional details about this information.

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Oct 31, 2011 | 2002 Jeep Grand Cherokee

1 Answer

I have a 95' Jeep Grand Cherokee Limited with a


Are you check your previoud questions: check_engine_error

Keep us updated.

Jun 07, 2011 | 1995 Jeep Grand Cherokee

1 Answer

I have a 2004 jeep grand cherokee limited with the 4.7 v8 engine. When I come to a stop the transmission jumps forward like if someone hit me in the rear of the car. I just purchased it about 6 months ago...


it sounds like the torque converter is malfunctioning does it idle rough? def sounds like a trans issue check the fluid while the vehicle is at operating temp check for discoloration

Nov 16, 2010 | 2004 Jeep Grand Cherokee

1 Answer

Everything has stopped working in my 1993 jeep grand cherokee limited edition. the door locks do not work. my compass/temp gauge has stopped working. the signal lights no longer work. my heat/and air no...


does the car start? if it doesnt...then your battery is dead. see if it"ll jump start at least for awhile, if it does and dies again...your alternator could be bad and not charging the battery.

Sep 29, 2009 | 1993 Jeep Grand Cherokee

2 Answers

Fuse box diagram for 1995 jeep grand cherokee laredo


I have the same model Grand Cherokee Limited 5.2L V8, nice truck; for fuse panel description and locations, check page 7 and next. All the infor that you need is here: Jeep-ZJ-Grand Cherokee-Secc-8W-Wiring-Diagrams.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Aug 13, 2009 | 1994 Jeep Cherokee Country

2 Answers

1997 grand cherokee limited 4x4 v8


HI, It may seem obvious, but sometimes overlooked.... have you checked the oil level, as low oil can cause some strange things to happen! My 96 4 liter would be reluctant to move sometimes, but after I topped it up, it has been fine.

Apr 28, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...