Question about 2000 Ford Focus

1 Answer

Lack of power on a right hand bend - 2000 Ford Focus

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 524 Answers

this is due to loss of oil on ur right hand side. transmition may be sluggish due to it. check the oil level in power steering module

Posted on Jul 04, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 96 camry vienta shudders like the engine is missing going around right hand bends and doesn't going around left hand turns

Take it to a repair shop. Something is wrong with the suspension, wheels, wheel bearings or brakes. Drive slowly and carefully.

Sep 15, 2015 | Cars & Trucks

1 Answer

Can a exhaust near the o2 sensor on a 1999 Bonneville cause lack of power

It is very possible that there will be a lack of power. Check that the cat converter is in good condition as they break up and block the exhaust. A faulty o2 sensor will also cause a lack of power as it sends the wrong signal to the ECM to keep the mixture right.

Nov 14, 2014 | Cars & Trucks

1 Answer

Clunking when turning right or on a right hand bend

Unfortunately, you are very likely to need to change drive axle (It is always a good idea to change both as the new one will increase strain on the older one)

Oct 10, 2013 | 1997 Toyota RAV4

2 Answers

On my 1999 chevy siverado 5.3 vortex engine on acceleration backfires at about 3000 rpm. Engine ides rough when heater controls or air condition is on.

Sounds like you have a bad spark plug or wire.It may even be a bad injector .
Symptoms of lack of power under load

Sep 06, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

93' chevy 4.3 V6 vortec. engine problem

fuel lines inside the intake plhenum may be cracked and leaking inside the plhenum. same thing happened to my 1992.sonoma. they are made of a plastic material and tend to crack right in the bend of these lines.

Mar 18, 2010 | Chevrolet S 10 Cars & Trucks

1 Answer

My sunroof switch seems to be broken and i am missing the hand crank for the motor, how can I get the sunroof to close?

First things first, check for blown fuse, is there power @ the switch, if so I would just pull switch use jumper wire to close sunroof and go buy new switch. But with these ole Cats there is more likely a lack of ground or lack of power at the switch. If you DO have pwr. @ the switch and @ the motor THEN check ground @ motor. Good ground? Replace motor, find a hand crank or ...

Mar 10, 2010 | 1986 Jaguar XJ6

1 Answer

I need timing specs 2001 dodge dakota 2.5L

If it's out that far & you didn't say advanced or retarded, then there's a mechanical issue at hand,more than likely. Use a vaccuum guage & see what happens. If it's reading below 15, better check the timing chain. Could also be a blocked cat converter. The timing is computer controlled & rarely has a problem. Factory is 10 degrees advanced & doesn't change no matter what unless you unplug the coolant sensor & move the distributor. So if it's 12 advanced,no big issue,it's something else causing the lack of power. If it's retarded,you got the timing chain issue more than likely. Write back if you need more help.

Jun 27, 2009 | Dodge Dakota Cars & Trucks

1 Answer

2001 elantra lack of power

Confirm ur fuel pump is working. Ensure ur pickup tube is not blocked. Then ensure u did not leave a rag or parts in the manifold tubes. Not laughing it happens. Is the distributor in the right spot. Etc etc. Did u rehook the alt up if removed . Is tje battery fully charged. And lastly is the fuel flowing and freash. Then recheck your work did u replace all parts right. Any air in the head gasket will make the fuel /air mixture off.
Good luck

Jul 16, 2017 | 2001 Hyundai Elantra

Not finding what you are looking for?
2000 Ford Focus Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

5530 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides