Question about 1999 GMC Suburban

1 Answer

1996 chevrolet accelaretion trouble 6.5 diesel went it runs for twenty mines it wont go the eng runs but it stands still.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 14,036 Answers

IF VECHICLE WONT GO IN GEAR OR MOVE.CHECK MANUAL SHIFT LINKAGE ADJUSTMENT AND CHECK TRANSMISSION FLUID LEVEL COULD BE LOW DUE TO FLUID LOST.IF ALL IS GOOD TRANNY COULD BE SHOT.BEFORE FOR BUY ANOTHER HAVE TRANSMISSION PRESSURE TEST CHECK PUMP PRESSURE.

Posted on Jul 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The car is a 1996 2.3 Litre. The motor was running fine then suddenly popped once and now won't run over 35 mph. Checked compression. All cyliders at 150 psi. Checked for spark by hooking spark plug to...


Well this motor has 2 coils so i don't think both went at the same time unless the ignition control module is bad because this is what tells which coil to fire and when.So i would have ignition control module tested.Its either that or the cam position sensor and sense you did'nt get any trouble codes in the computer about the cam sensor i would like it would be the ignition control module.You can get these from www.rockauto.com for about $100.00

May 12, 2011 | 1996 Chevrolet Cavalier

1 Answer

91 diesel trouble starting chevy suburban


I would be more suspicious of the fuel system. Have you changed the filters lately? Do you have a 6.2 or a 6.5?

Aug 10, 2009 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

1996 Ford F-150 300 inline 6 timing gears/timing issue


u have to unplug the spout small gray plug on driver side in the eng comp . on the fender wall on plug that set timming thing it should b 10 deg b4 top dead center then plug spout back in comp will adv timming

May 31, 2009 | 1993 Ford F150 SuperCab

3 Answers

Charging problem on 1996 Dodge Ram 3500 Cummins Turbo Diesel


I had the same problem on a 94 dodge with the cummins. It seems the crank sensor that reads from a notch on the harmonic balancer was the problem Without this sensor reading that the engine is running the alternator wont charge. Possibly the same problem with yours

Mar 25, 2009 | 1996 Dodge Ram 3500 Club Cab

1 Answer

Engin light keeps coming on and the engin keeps jumping.


1st u have to find out what trouble code is turning on the CEL (check eng light), then we can talk possiable causes and fix estimates, go to Kragen auto or Autozone and ask to have a trouble code test run, it is free.

Mar 12, 2009 | 1996 Chevrolet Cavalier

3 Answers

Deisal out of gas wont start


The fuel system has a bleeder located on the engine, located near the passenger side front of the engine. Open the bleeder, turn the engine over until you can see fuel come out on the ground near the front of the engine. Close the bleeder, attempt to restart the engine. It may take a couple of tries, but it should start after five or six attempts. Do not run the starter for more than twenty seconds per attempt, with at least one minute between attempts.

Nov 12, 2008 | 1987 Ford F 250

3 Answers

Change 1996 Chevrolet C3500 from 5.7 gas to 6.2 diesel


YOU DO NOT WANT A 6.2 DIESEL!!! It was one of the worst diesels GM had plus in 1996 you would go witha 6.5l diesel. You would need computer, wiring, IPC and some other stuff, the trans will bolt up, but you better hope its a 4l80E or it will blow up! To be completely honest its not worth it! just as long as you dont live in california

May 14, 2008 | 1996 Chevrolet C3500

Not finding what you are looking for?
1999 GMC Suburban Logo

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...