Question about 2004 Mazda RX-8
Get one of those 9v cig lighter socket power supplies,that will keep codes in yr radio and computer,then you can disconnect the earth first,then positive,then the clamp,then the battery.dont spill the battery acid
Posted on Jul 04, 2010
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Jack the drivers side up and secure on jack stands. Remove the drivers side front wheel. You can then reach through the fender well to remove and reinstall the spark plugs.
Posted on Jun 20, 2009
CHANGING FRONT BRAKE PADS
Jack up the car. Take off your tire. Find the bolt on the back of the caliper and take it off. This should release the caliper, pull the caliper off the disc. Now you should be able to take the pad out. Replace the pad. You'll need a special tool to reset the caliper. As the brakes wear down, the caliper gets tighter so the brakes still work. I'm not sure exactly what its called, but you can borrow one from auto zone. Follow the instructions that come with it to reset the caliper. Slide the caliper back over the disc. If it doesn't go on, you need to reset the caliper more. Put the relese bolt back in. Put your tire back on.Drive slowly and test the brakes.
CHANGING THE REAR BRAKE PADS
The rear brakes on the rx8 are a bit different than most setups...be careful! The only way to move the piston back into the caliper is by way of a special allen head bolt that is directly behind the piston, on the back side of the caliper, installed under a 14mm bolt.
You have to remove this bolt to gain access to the allen head. As you loosen the allen head bolt(counter-clockwise), the piston will move back into the caliper.
Installation is pretty typical, again, the allen head bolt being the unusual part. The manual says to tighten this bolt until the pads contact the rotor, then loosen the bolt 1/3rd of a turn, then reinstall the 14mm bolt.
Posted on Sep 04, 2009
SOURCE: 2004 mazda rx8 power steering
The Mazda RX8 has electric power steering there is no fluid. You may have a problem with you electronic power steering control moduel, or the power steering pump
Posted on Dec 04, 2009
Tips for a great answer:
Dec 31, 2012 | 2004 Mazda RX-8
Oct 29, 2008 | 2004 Mazda RX-8
Jul 21, 2012 | 2004 Mazda RX-8
Aug 18, 2010 | 2004 Mazda RX-8
Jun 25, 2010 | 2004 Mazda RX-8
Feb 15, 2010 | 2004 Mazda RX-8
Dec 11, 2008 | 2004 Mazda RX-8
1,052 people viewed this question
Usually answered in minutes!