Question about 2004 Ford F250

Open Question

Overdrive control doesn't seem to work -- What could be problem????

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 jeep grand cherokee is stuck in second gear, the overdrive button is not functioning, and getting the data control center says service 4wd switch


wow no engine size stated, the 5.2L run a special trans... so....
hopeless to help you much.
zj jeep with automatic.
it didnt lie, it told you to service it, so take it to a shop and let the work on this old dog..
stuck , now what does that mean.
the shift lever lever stuck, or its cable failing end to end.? or?
or shifts from 1 to 2 and hangs there.
or down shifts from 3 to 2 and and hangs there
DIY ? question is that it? you never said intentions.....
so we open the 93 ZJ book and what do we see.
ax-15 stick box, seems not.
the aw-4 auto , electronically shifted with TSM (scan it yet?)
and the 46RH auto. used on the 5.2L, has no TCM brain.
its a Hydramatic.
here are the OD words off the 46h page

Overdrive Control Switch
The overdrive control switch is located in the instrument
panel. In the On position, automatic shifts
into fourth gear overdrive will occur. In the Off position,
the switch overrides the powertrain control module
preventing a shift to overdrive fourth gear range.
The switch has an indicator light that illuminates
when overdrive is turned off. The switch also resets
when the ignition key is turned to the OFF position
so that the automatic overdrive feature is restored.
The use of fault codes is employed to help diagnose
the electronic components that operate the overdrive
unit and torque converter clutch.

Jul 16, 2016 | 1993 Jeep Grand Cherokee

1 Answer

1984 buick century overdrive stopped working when throttle positing sensor went out could this be related


Yes this sensor tells the car what position your throttle is in. if it doesn`t pick it up it won`t know you require overdrive.

Jan 06, 2014 | 1984 Buick Century

1 Answer

After shifting into overdrive you press accel to the floor and it won`t go...just bogs...you stop and start again it does fine till it hits overdrive.


Hello
The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.

Sep 11, 2012 | 1996 Buick Riviera

1 Answer

My 2005 scion xb won't go into overdrive and the speedometer doesn't work


run the fault codes and look for a failed VSS sensor

Feb 22, 2012 | 2005 Scion xB

1 Answer

Kia sophia overdrive doesn't work


The transmission in this car is electronically controlled, so if it isn't shifting properly the very first thing that must be done is to have the TCM (transmission control module) scanned for fault codes, in your case it is likely the a sensor that is called the VSS is defective. Have the test run. Aamco transmission repair will do the test for free and the preliminary diagnosis for free as well.

Please rate my help for Fixya, it improves my status and it is all I ask for my time helping you with your problem. Thanks

Jan 18, 2012 | 2001 Kia Sephia

1 Answer

1998 Chrysler Sebring JXI V6 2.5L Transmission automatic ...the tranny does not slip and seems to shift fine (BUT) it seems like it is louder like it is not going into overdrive on highway. When i go 60mph...


Here is your clue the ABS light and a erratic Tach, that is the speed sensor problem just to let you know they are known problems with the Sebring There is a (TSB) technical service bulletin, about speed sensor delay engagement that you are facing with
A/T-41TA/AE 42 LE Delay Gear Engagement Your fix is to have this check out you may be looking at a flash on the software of the TCM or even the PRNDL switch on the transmission

Jul 11, 2011 | 1998 Chrysler Sebring

1 Answer

Overdrive stopped working 97 dakota 318 auto


has the vehicle speed sensor been replaced? that is what controls when the trans shifts into od

Sep 14, 2009 | 2001 Dodge Dakota

1 Answer

Overdrive light


My overddrive indicator light doesn't work, and I just had my transmission rebuilt, what could be the problem, and how would I solve the problem.

Apr 09, 2009 | 1999 Dodge Durango

Not finding what you are looking for?
2004 Ford F250 Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...