Question about 2001 Buick LeSabre

1 Answer

From the driver's door, the power lock which is seperate from the master window switch works for all except the the right front door. The master switch includes power mirror which also wont work on right front door. The windows from the master switch work only on the left front & rear door. I do hear the solenoid click on the right rear door. Nothing from the right front though. Moving to the right front door switches, the lock or the window switch does nothing. There is a temperature adjustment control also that doesn't respond eighter. Checked the power lock relay in the fuse block & the10 amp fuses for the left front & rear doors. Pulled the inside panel from the right front door & found power from the large orange wire connected to the window motor. How can I be sure it's the door module before I purchase & replace it? Also could not find the right wiring diagram.

Posted by on

  • 5 more comments 
  • Anonymous Mar 11, 2014

    my brother HL-4040CN is holding all my print requests in queue

  • Anonymous Mar 11, 2014

    iwant to see what payments i have made

  • Anonymous Mar 11, 2014

    Kitchen aide model kgct305bwh1

  • Anonymous Mar 11, 2014

    Had to change the door on my 1997 Plymouth Voyager. For that I got the door of a 1996 Model. I put it on but it seems like it is on inch to far back! Can close it. Any advice? Some hidden ajustments I could have missed?

  • Anonymous Mar 11, 2014

    I need to know where the crank position sensor is

  • Anonymous Mar 11, 2014

    none of my directionals work. but both high and low beam work and all running lights and brake light. so basically when i hit turn signal switch nothing happens back or front

  • Anonymous Mar 11, 2014

    I need to know what size socket i need for the big bolt to take off the wheel hub on my 99 grand cherokee

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Expert
  • 4,070 Answers

Hi! I was suspecting the door actuators too... If there are no burnt wires or blown fuse/relay then the problem will be the actuator itself. Once replaced I believe you'll be good. Hope this helps and have a good one!

Posted on Jul 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Tried it today and none of the windows work from master switch on drivers side except ft passenger window, which went down but will not go back up.


You can't put up the front passenger window with it's own switch ? Did you check the POWER WINDOW RELAY in the instrument panel fuse / relay box ? An you checked POWER fuse 30amp same fuse box ? All window switches have direct power from power window relay !
Fuse Block - Instrument Panel
Left of the Steering Column, behind the storage Compartment
P/W Relay
--
Sunroof Switch Assembly, Window Switch - Left Front, Window Switch - Left Rear, Window Switch - Right Front, Window Switch - Right Rear

Apr 02, 2015 | 2003 Pontiac Vibe

2 Answers

I have a Toyota Highlander 2005 Limited. I have two problems on 1. the front right & both rear windows won't resp ond on there own switch but all work from the master switch on the drivers door. Fuses are...


Have you checked each individual door switch
for voltage? If there is voltage and a good ground try jumping the switch with a bypass wire to see if the window responds. It could be a bad master control switch which you can bypass to check to see if its working properly. Drivers door switch module. They are known to be a problem. Hope this helps.

Oct 16, 2013 | Cars & Trucks

1 Answer

1998 olds cutlass driver side window switches dont work except for the switch that controls the passenger side front door window that works but all others dont work, would that mean need a new switch or...


Do the individual door switches work their windows? If so, it would be the driver's side door switch, the master switch, that is bad.
The fact that one window works off the driver switch means that power for the windows is at least getting to the master switch, and that the ground for all power windows is good. If the other door switches work, it is just the master switch, not a wiring problem.

Aug 01, 2013 | 1998 Oldsmobile Cutlass

1 Answer

All windows except the driver's side are not working.


First, if the driver's window is working, there is no need to waste your time looking for fuses. ALL of the windows are powered by the SAME fuse.

The first thing I recommend checking is the window "lock" switch on the master switch. If it is in the "lock" position, none of the other windows will work (it is designed to do that)

Other than that, you need to check for power and ground at all of the other door switches. The BLUE/BLACK wire at each of the switches should have battery voltage anytime the ignition switch is in the ON position. If they do not, the wire is broken between the splice near the driver's door and the right front door. Both the RED and the GREEN wires at each switch should have continuity to ground anytime the master switch is at rest with the "lock" switch in the unlock position (the lock switch breaks these grounds to "lock" the windows and prevent them from being operated).

Jan 31, 2012 | 1991 Mitsubishi Montero

1 Answer

1998 Jeep Grand Cherokee Laredo TSI, Passenger side windows do not work from master switch on drivers door. Both driver side windows work from master switch on drivers side. Passenger side windows do work...


It has to be the switch or the wiring, right? So pull out the switch and probe the back with a volt meter to see if power is coming out of the switch. If yes, trace the wires to the doors.
0900c152800aa140-zzyiglue2iivran2oy1paayi-3-0.gif

Jun 30, 2017 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Cant roll down windows from drivers door. i can roll down the passenger side window from that door but i cant roll down any other window.


The Master Switch may be bad. Thats the first thing to verify good or bad. It may be a big deal to find a wiring diagram and then verify where voltage is lost. All of the window power goes to the Master Switch,(through the lock out switch) then on to each window. Except for the right front window. The diagram is confusing, it does not appear that the lockout switch turns off the RF passenger window.

Oct 28, 2009 | 2006 Chevrolet Impala

1 Answer

Rear side windows


This may be just a case of inadvertently hitting the window lock out n th driver door window switch by mistake. Check that first. Here's some background on window operation

Principles of Operation
The driver power window regulator motor is controlled directly by the master window/door lock/unlock switch (and its integrated "auto down" module). Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The driver power window regulator motor is a reversible motor that is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The passenger power window regulator motor is controlled directly by the passenger power window switch and can also be controlled by the master window/door lock/unlock switch. Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The passenger power window regulator motor is a reversible motor, which is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The power rear quarter glass is also directly controlled by the master window/door lock/unlock switch. The power rear quarter glass power latches also utilize reversible motors. The power rear quarter glass power latches are operated by applying power and ground to the motor leads to open the window, and then reversing polarity on those same leads to close the window.
Symptom Chart Condition Possible Sources Action
  • All windows are inoperative
  • BJB Fuse:
    • F20.
  • Circuit.
  • Power window relay.
  • Front door power window switch.
  • GO to Pinpoint Test A .
  • Single power window is inoperative
  • Front door power window switch.
  • Front door power window regulator.
  • Circuit.
  • Driver door power window switch.
  • GO to Pinpoint Test B .
  • Vent power window is inoperative — quarter window glass power latch
  • Circuit.
  • Quarter window glass switch.
  • Quarter window glass power latch.
  • GO to Pinpoint Test C .
  • The one touch down feature is inoperative
  • Master window regulator and door lock switch.
  • INSTALL a new master window/door lock/unlock switch. REFER to Switch—Master Window Door Lock/Unlock .
  • The back window will not defrost
  • CJB Fuses:
    • F30 (10A).
    • F32 (20A).
    • F34 (20A).
  • BJB Fuse:
    • F27 (45A)
  • Circuit.
  • Heated back window switch.
  • SEC/timer module.
  • Rear window defrost relay.
  • GO to Pinpoint Test D .
  • The back window defrost will not shut off automatically
  • SEC/timer module.
  • Circuit.
  • Rear window defrost relay.
  • GO to Pinpoint Test E .

Jan 28, 2009 | 1999 Mercury Villager

1 Answer

1993 electric windows stopped working on nissan altima


hard to say without testing, but the master window switches are common and will stop the rest of windows working, make sure window lock switch if off

Nov 15, 2008 | 1995 Nissan Altima

1 Answer

Driver Door Not Working Right...HELP!!!!


the master control switch on the drivers door needs to be replaced and it will be fixed.

Oct 12, 2008 | 1996 Acura RL

Not finding what you are looking for?
2001 Buick LeSabre Logo

Related Topics:

201 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...