Question about 1999 Land Rover Range Rover

1 Answer

1999 range rover se changed fuel pump, truck still wont start, relays and fues look good.

Posted by on

  • 7 more comments 
  • hoopshoodsty Jul 06, 2010

    The dealer told me I needed a fuel pump, I got it started drove to a gas station and then it died, tried to start it won't start, now i'm getting no power I checked spark plugs. where is the crank sensor?

  • hoopshoodsty Jul 07, 2010

    not yet, it been to hot to work on the truck, i did look under the truck to see if I saw crank sensor, there is a yellow thing on the oppisite side of the starter is that the crank sensor?

  • hoopshoodsty Jul 10, 2010

    My 1999 Range Rover SE will start but I have to keep my foot on the gas, but when I take my foot off the gas it cuts off. Any ideas???

  • hoopshoodsty Jul 10, 2010

    where do I get the chassis # from, I thought it was the vin#.

  • hoopshoodsty Jul 10, 2010

    is this the chassis # p108046 1998 it is near the air filter on the inside of the truck.

  • hoopshoodsty Jul 10, 2010

    is this the chassis # p108046 1998 it was near the air filter on the inside of the truck.

  • hoopshoodsty Jul 10, 2010

    is this the chassis # p108046 1998

  • hoopshoodsty Jul 10, 2010

    the vin # is salpa1243xa407728

  • hoopshoodsty Aug 13, 2010

    I have a 99 range rover se 4.0 , it wont start, I changed the fuel pump, changed the crank sensor and the tps and it still wont start, can someone please help me get my truck back on the road. It will crank but won't turn over and if it does turn over then it stall and cuts off!!! Help please!!!

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 54 Answers

Why you have replaced the Fuel pump? who advised you to do so?
be guided as follow 1. on the Engine Side on the top there is a fuel rail for the injectors. turn the ign. key to the second position (on) and check the valve located on the fuel rail if fuel is coming pressurized and still won't work. then open on of the spark plugs wires and check if spark is there. (Be Careful doing that). if no spark then is there any message comes up on the Dash? if not messages then you can check the Crank Sensor if no current being generated from the ign. coils.

Posted on Jul 05, 2010

  • 9 more comments 
  • Salmaneid Jul 06, 2010

    if no spark then you need to change your Crank Sensor. it's mounted on the tail underneath of the engine. Basically between the Gearbox and the engine. it's reading the Flywheel rotation in order to generate voltage. the exact place is just the opposite of the Starter motor. Means if the starter motor fitted on the left side of the engine when you stand infront of the car then the Crank Sensor on the Right side.
    if your Vehicle is 1999on Bosch Management engine then part no. is ERR7354

  • Salmaneid Jul 07, 2010

    hi mate...did you have your problem solved??

  • hoopshoodsty Jul 10, 2010

    I got it to start but when I take my foot off the gas, it cuts off. Any ideas

  • Salmaneid Jul 10, 2010

    Can you please send me your VIN/Chassis no. and your email ID so that I can send you pic's and more details how to get your problem solved.
    Regards..


    Salman EID

  • hoopshoodsty Jul 10, 2010

    SALPA1243XA407728 hoopshoodstyle@hotmail.com

  • Salmaneid Jul 10, 2010

    This looks like the idel valve motor is faulty or disconnected...I wanted to know your exact Chassis no. in order to guide you properly but you never did...
    regards..

  • Salmaneid Aug 13, 2010

    Hi There...


    I've been too busy and had no time really to get in touch with you to have your problem solved. The Main problem is that you keep buying parts and that might be not the fault so it's not good of just guessing and wasting time, energy and money. Have you got a friend having same vehicle so that at least I can guide to swap some parts to try instead of just wasting.

  • hoopshoodsty Aug 13, 2010

    I don't have a friend with the same vehicle, do you think getting a diagnostic will help?

  • Salmaneid Aug 13, 2010

    of course...going to any workshop having a diagnostic device to have your truck checked is much much better than keep buying parts for no use. when you get ur truck checked let me know what are the faults showed up so that I can advice u what to do if you want to.
    Regards

  • hoopshoodsty Aug 13, 2010

    ok thanks!!!

  • walker_jerem Jan 18, 2011

    hey my1999 range rover right blinker and back light stays on after i turn off my vechile i have to manualy disconect it to turn it off and it wont blink and message board says replace bulb failure which i did.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why my 1998 range rover 4.0 se won't start unless I use starter fluid. It will only turn over without it.


did you hit a big bump when it stopped? you may have a fuel emergency shut-off switch that tripped or a blown fuse.

Oct 30, 2014 | 1998 Land Rover Range Rover

1 Answer

Range rover 3,9 1990 runs on lpg but will not run on petrol


check all fuses think fuse for pump is under drivers seat on uk models. If fuse ok check for power and earth at the connection on fuel pump. if power and earth possible fuel pump.

Mar 06, 2014 | 1990 Land Rover Range Rover

1 Answer

V8 spark plug diagram


Fuel pump dies around 130k.

Sep 22, 2013 | 1999 Land Rover Range Rover

1 Answer

Location of the fuel pump relay for p38 1998 range rover


Relays are located in the "under hood relay/fuse panel" on the passenger side between the radiator overflow and the battery. Remove the lid and on the underside of the lid you will find the diagram. The fuel pump relay will be indicated by a graphic of a fuel filling station pump. The relay itself is yellow. Also check the pump fuse, located in the same relay box and if needed check your inertia cutoff switch located in the passenger footewell. There is a panel to the right just under the glove box. It has a popout access door but its much easier to remover this small panel and providing clear access to the switch. Push down on the rubber cover on top of the switch. If it is engaged you are ok here. If when you push down you hear a click then the inertia cutoff was switched somehow and this cuts fuel supply. These switches have plastic internal parts and dont take much to fail. Hope this helps. Happy to provide further suggestions if you wish to repost more info. Good luck!

Apr 21, 2013 | 1999 Land Rover Range Rover

2 Answers

I have a 1999 range rover 4.0 se and 4.6 hse .i tried to trun it on but it wont start the battery wrks good its wont do a spark thy told me it might need to replace the fuse box or my alram need to be...


I have a 1998 Range Rover Se i am have a problem with the rover not wanting to start. I check all the fuses and relay but the starter is not getting any fire to it what could be my problem.

Apr 13, 2012 | 1999 Land Rover Range Rover

1 Answer

My Range Rover 2.5 DSE turns over but wont catch


Is your battery good? fully charged? It could be ignition or distributor module. Might also want to check the crankshaft position sensor.Check your fuses/relays for fuel pump and make sure your fuel pump is coming on when your key is turned to the on position.

Sep 20, 2009 | 1996 Land Rover Range Rover

1 Answer

Range rover 4.6


check plugs......check that you grounded both sides of the fuel wire harness to STEEL....not the manifold because it is aluminum...not a good metal for electricility....you will blow the fuel pump fuse and relay....check both....about $10 bucks and change

Feb 25, 2009 | 1999 Land Rover Range Rover

2 Answers

1999 ford taurus


check the fuel pump itself.. if no fuel going through lines... injectors won't work.

Aug 16, 2008 | 1999 Ford Taurus

Not finding what you are looking for?
1999 Land Rover Range Rover Logo

633 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...