Question about 1992 Volkswagen Golf

1 Answer

I need the wires for a vw golf front turn signal. I can find the covers and switches but not the wires It is a 1992

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Volkswagen Master
  • 2,002 Answers

Go to vwvortex.com. Click on the forums. Click on Volkswagon and then on Golfs. The page will have a number of sub forums, one of which should be Classifieds. You should be able to get a good used wire harness in there. You may have to register to respond to ads, I'm not sure but it's no big deal to do so. Hope this helps.

Posted on Jul 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to replace the turn signal switch in a 1992 Cadilac?


Turn Signal Switch REMOVAL & INSTALLATION CAUTION
Some models covered by this manual may be equipped with a Supplemental Restraint System (SRS), which uses an air bag. Whenever working near any of the SRS components, such as the impact sensors, the air bag module, steering column, and instrument panel disable the SRS. Deville, Eldorado, Seville, and Fleetwood - Early Models
  1. Disable the SIR system.
    1. On Deville and Fleetwood, remove the left lower sound insulator. On Eldorado and Seville, remove the left side sound insulator.
    2. Remove the Connector Position Assurance (CPA) and detach the yellow 2-way connector at the base of the steering column.
    3. Remove the steering wheel.
    4. Make sure the ignition switch is in the LOCK position to prevent the SIR coil assembly from going off-center.
  2. Remove the SIR coil assembly retaining ring and the coil assembly. Allow the coil to hang freely. WARNING
    The SIR coil assembly will become off-center if the steering column is separated from the steering gear and is allowed to rotate or if the centering spring is pushed down, letting the hub rotate while the coil is removed from the column.
  3. Remove the wave washer.
  4. Use tool J-23653-C or equivalents, to depress the shaft lock, then remove and discard the shaft lock retaining ring.
  5. Remove the shaft lock.
  6. Remove the turn signal canceling cam assembly.
  7. Remove the upper bearing spring, upper bearing inner race seat and inner race.
  8. Move the turn signal switch to the RIGHT TURN position.
  9. On Deville, Fleetwood, and 1990 Eldorado, and Seville, remove the multi-function turn signal lever as follows:
    1. Make sure the lever is in the OFF position.
    2. Remove the access cover from the steering column housing.
    3. Detach the cruise control wiring connector. Note the position of the connector when installed in the column.
    4. Pull the lever straight out of the turn signal switch.
  10. On Eldorado and Seville, remove the multi-function turn signal lever as follows:
    1. On 1992-93 vehicles, slide the connector cover toward the front of the vehicle.
    2. Unplug the electrical connector. On 1991 vehicles, note the position of the connector when installed in the column.
    3. Push the lever straight in, rotate clockwise 1?4 turn and pull the lever out of the switch.
  11. On Deville, Fleetwood, and Eldorado and Seville, remove the screw, button, spring, and hazard warning switch knob.
  12. On Deville and Fleetwood, remove the one signal switch arm retaining screw. On Eldorado and Seville, remove the 2 signal switch arm retaining screws. Remove the signal switch arm.
  13. Remove the turn signal switch retaining screws.
  14. Remove the wiring protector and detach the turn signal switch connector.
  15. Gently pull the wire harness through the column and remove the turn signal switch. prev.gif next.gif

Nov 12, 2010 | 1992 Cadillac DeVille

1 Answer

1997 vw golf 2.0 5speed start


Check body to motor ground wire and battery to motor and body ground.

Jul 23, 2010 | 1997 Volkswagen Golf

1 Answer

I replaced head gasket on my 1992 vw golf 1.8 8 valve engine.. and it wont start. i checked my spark and it good, fuel delivery its good, i tried to check ,y injectors and there seems to be no signal to...


Yep...youll need to get the timing set. anytime the head comes off,really on any vehicle,its a good idea to set the timing. also,make sure that you have all the plug wires connected in the correct order.

May 01, 2010 | 1992 Volkswagen Golf

1 Answer

How do i change the brake light switch on my vw golf diesel


The brake lights switch is fitted next to steering column under a dashboard.There is plastic cover-just follow the brake pedal and you will see the switch.Disconect the plug and turn the switch anticlock wise.

Apr 22, 2010 | 2002 Volkswagen Golf

1 Answer

Need to wire up disel pump on vw golf


the stop solenoid is on the diesel pump some of them were covered by a steel cover which u have to cut off to see the solenoid and then one of the wires that was goin to the immobillizer is from the ignition put it on the solenoid and it will start

Apr 02, 2010 | 1996 Volkswagen Golf

1 Answer

I have a T25 Transporter 1990 ,front wipers won`t


It sounds like the park switch inside the wiper motor has failed or a bad contact. If you can get to the motor, remove the plate/cover and you should see a micro switch, check it for broken wires or clean contacts. If you dont feel comfortable doing this, then take the car to an auto electrician, he should be able to sort it.
Hope this helps

Nov 12, 2009 | 1999 Volkswagen Golf

1 Answer

1996 VW Golf -


Sounds like you have a electrical problem. Alot of VW's have electrical problems that VW won't recall. Check for burnt wires under drivers side dash but you have to remove the black cover. Fuse box located to the left striaght up. And if the elecrtical is messed up it will be expensive to fix.

Mar 23, 2009 | 1996 Volkswagen Golf

1 Answer

Flasher replacement 2001 VW Passat


vw golf flasher and signal relay are built into the the hazard switch might be the same on the passat try that m8 ??

Nov 15, 2008 | 2001 Volkswagen Passat

Not finding what you are looking for?
1992 Volkswagen Golf Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...