Vehicle running rough initial code misfire cyl 2 replaced plugs and coil pack still rough recheck codes and got P0172/P11341/P1151 O2 or mass air flow sensor ?

Part 3 -How to Test the Ignition Module and Crank Sensor ...

easyautodiagnostics.com > Ford > 2.3L

Mar 1, 2012 - Spark plugs for cylinders #2 and #3 get spark at the exact same time. ...voltage -12 Volts) to both individual ignition coils within the coil pack. ... Ford Mustang or Ranger (or 2.3L Mazda B2300), this is what you'll need ... for this 'Switching Signal' at the coil pack... but you can also test this ... 1991, 1992, 1993.

How to Diagnose a Misfiring Cylinder (2.3L Ford Ranger ...

troubleshootmyvehicle.com > Ford > 2.3L

Apr 3, 2012 - Bad Fuel Injectors can cause a Misfire Condition. ... the ignition system on the 2.3L Ford Mustang or Ranger consists of 2 ignition coil packs, ...

2002 ranger misfire rough idle - Discussion on Topix

www.topix.com > Ford Ranger

Jul 27, 2007 - My truck is giving the code misfire in number 4 cyl. I replaced my spark plugs, Wires, Coil packs (both of them) and all my fuil ... three (3.0L v6) go bad, the fuel/air mixture gets messed up. Judged: 2. 2 ... My truck runs rough only at idle. ...code for ford ranger 2002, 2.3 5speed. truck runs like a champ but that ...

Extremely stumped! I need the best and brightest 1994 Ford ...

answers.edmunds.com > Edmunds Answers

Check Engine Light/Misfire Due to Intake Valve Locks ...

repairpal.com > Problems > Jeep > Liberty

Jeep Liberty Check Engine Light/Misfire Due to Intake Valve Locks/Valves. ...Misfire cyc 4 and random cyc misfires, changed coil packs and plugs... sounds as if rod ... Light came on again (misfire on cylinder 4) - switched coil from 4 to 2. Light ...

Jeep Liberty Questions - Cylinder Misfire code - CarGurus

www.cargurus.com > Questions > Jeep > Liberty

CarGurusMay 27, 2009 - #4 misfire new plugs and coil pack on #4 light came back on after 300 miles if ... How come it stopped misfiring for 2-3 months, and now is back? ... I have a 2005 Jeep Liberty 6 cylinder, engine light came on scaned the codes ...

Liberty Cylinder Misfire / Computer issue? - JeepForum.com

having PO 304 = Misfire cylinder 4,PO 306 = Misfire cylinder 6, as I read above you have done the most. The thing that you have missed is to check whether the Catalytic Converter is faulty or not. To get an idea check whether you have a smell like rotten eggs at the end of the exhaust,you start having problems with cat and needs replacement. My advice before you go for a cat replacement is good to visit an MOT center and check your emissions and then you decide,

P1151 means a lean bank 2 O2 sensor
P1152 Means a rich bank 2 O2 sensor
P1309 Means miss fire detected
I would check your fuel injector for fouling
When they foul the will develop a drip
Causing a fuel fluctuation that will have O2 sensors reporting rich and lean voltage changes
This causes the pcm to adjust injector pulses making them shorter and longer.
causing more fuel or less fuel.
From this condition you may see plug fouling.
Also check for leaking or faulty fuel pressure regulator or restricted return line.
Most of the time it wont be a bad O2 sensor the O2 sensor is just doing its job.
You also have already changed the plugs and Map so there already out of the way.
If this helps please give me some feed back
Hope this works for you FixYa

whatever,change the O2 sensor,then recheck codes.

p0306 is a cyl #6 misfire
p0316 is unknown to me. sry.
p1131 and p1151 deal with the O2 sensors 1151 says Bank 2 Sensor #1 Heater Circuit intermittent. 1131 says that HO2S 11 indicates lean.

p0306. Check the plugs wires and coil at Cyl #6 (second one back from front on drivers side, if it's the same as my Stang)

P0420= Catalyst System Efficiency Below Threshold Bank 1
P0300=Random/Multiple Cylinder Misfire Detected
P0301=Cylinder 1 Misfire Detected
P0172=System Too Rich Bank 1
P2181=Cooling System Performance
you need to write these down,have someone clear the codes in the car,then go for short ride and recheck which if any code reappears.it's like domino's affect,one sensor can start a chain affect with the others.

Higher octane gas 93 with some good octane boost in the black can at autozone cost about 7 dollars or a bottle of 104 octane boost. Change the fuel filter. Probably only one coil pack is bad. The OBDII reader should tell you which one was a misfire.

P0301 = Misfire cylinder #1P0303 = Misfire cylinder #2
P0171 = System too lean cylinder #1
Are you sure on the P1151 code? I am thinking this may be a P0151 which is O2 sensor related.
This looks like you have a fuel system related misfire. I would do a fuel injection cleaning service and then clear codes and see if the codes regenerate.

if it sounds like a leak before the cat try removing the cat and running the vehicle