HOW TO FIX THE FRONT END OF MY 2000 MERCURY SABLE?WHAT PART WILL I NEED TO INSTALL THE HEAD LIGHTS?

Question edited for clarity and typo.
Question moved to sub category.

It is all in here.

2000 Mercury Sable Car Stereo Wire Colors and Locations

https://www.the12volt.com > installbay > stereodetail
2000 Mercury Sable Stereo Wiring ; Ground, Black/Light Green ; Illumination, Light Blue/Red ; Dimmer, n/a ; Antenna, Left Rear ; Front Speakers, 5" x 7" Doors.


..

and taking a short pry bar insecure between the end of the CV axle and transmission and just wiggling and prying slightly should pop the CV axle out

could be a wheel bearing.

google "mercury sable front suspension" go to google images lots to choose from

I've had success with sealing around headlamp with clear silicon. You have to remove it to get all around it.

If that was my car, I would go to the wiring diagrams
I buy for all my vehicles when I first get them

From there you make some choices as to how the system
works & where to start your testing or in an extremely rare
case replace something

I simply can't tell you if that switch you turn is bad or it
is good & it's output goes to a module,need to see the
system on paper

If it happens when the steering wheel is being turned left or right when parking, it could be dry tie rod ends. They will have to be replaced and greased up well to get rid of the sound. This happened to my dad's 1998 Ford Taurus.

sound's like a bad brake rotor, or cv shaft

buy the part only using the correct corresponding part number and then have the mechanic install it for you, afterword you need alignment

hi im wes if you have a 3.0 litre dual over head cam it ts behind the timing belt. if you have a 3.0 litre pushrod engine its on the front of engine any help pleas rate me trying to make a buck thanks wes