If you have the type of crank angle sensor shown in the image, then it will be located on the bell-housing towards the top of the bell-housing and usually on the drivers side. Dis-connect the faulty crank angle sensor and then un-bolt the two bolts that secure the crank angle sensor to the bell-housing and then remove the sensor. The best access to the crank angle sensor is from under the vehicle.
This type of crank position sensor is for an automatic transmission, and this type actually has an elongated slot for the attaching bolt and the crank position sensor should be adjusted so that it does not contact the tone ring and damage the sensor, and after installing this type it would be a good idea to turn the engine over slowly with a breaker bar and socket on the front crankshaft bolt to be sure that the crank position sensor does not contact the tone ring before the engine is started.
×
SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
SOURCE: crank position sensor
need to know what engine but on six cylinder it is on the bell housing at the left rear of engine,on 5.2/5.9 it is on the right side behind the head in the block,and on 4.7l it is on the engine block above the starter.
SOURCE: my 2000 jeep grand cherokee starts but kills after
CHECK IDLE AIR CONTROL SOLENOIDALSO SEE IF YOURS HAS A SHUTDOWN RELAY IN RELAY BOX
SOURCE: Jeep is giving a code of p0340 which is telling me
go to autozones website they have free diagrams
SOURCE: where is crank shaft position
CRANKSHAFT POSITION SENSOR LOCATION FOR 4.0L ENGINE IS ON TRANSMISSION BELLHOUSING AT THE LEFT REAR OF THE ENGINE. FOR 5.2L ENGINE CRANKSHAFT SENSOR LOCATED ENGINE BLOCK BEHIND THE RIGHT CYLINDER HEAD.
1,887 views
Usually answered in minutes!
×