How do your replace the clock bulb on the CRV 2001

The clock does not have a replaceable bulb, the clock itself is dead, it is a very common issue with these clocks. I have a repair service, check out www.autoclockrepair.com. I have removal instructions, etc there. Please le tme know if you have any questions, I would be happy to assist, thanks!

The clock removal instructions are available at www.autoclockrepair.com
If you have a defective clock, we offer a very reasonable repair service with a lifetime guarantee.

Subaru Forester 1998 - 2002
Subaru Impreza/WRX 2002 - 2005
Toyota 4Runner 1996 - 2002
Nissan Pathfinder 1996 - 2004
Honda CRV 1996 - 2001
Toyota Tacoma 1995 - 2004
Toyota Rav4 1996 - 2000
Toyota Land Cruiser 1996 - 2002
Toyota Camry/Corolla 1996 - 2004
Lexus ES300, GS300 1997 - 2004
Saab 9-2x 2004 - 2006
Toyota Matrix 2003 - 2008
Toyota Sienna 1999 - 2003
Ponitac Vibe (Voltz) 2003 - 2008
Suzuki Aerio, Vitara mid 2000s

That is a typical issue with vehicles of this era. I have the removal instructions and an affordable repair solution at www.autoclockrepair.com.

If you mean the fuse keeps blowing, then you should check the clock wire harness for chafed wires. Also check for a loose clock connector, or loos wires in the back of the clock connector.

Hello,

Below are the removal instructions from my website www.autoclockrepair.com. I also offer a very reasonable repair service.


1997 - 2001 Honda CRV Clock removal Instructions
The vent bezel assembly needs to come out prior to clock removal.
Follow these 4 steps
1. Using a wide,thin blade such as a putty or butter knife, pry the
assembly up a little at the bottom until it pops out and slightly.
2. Pull the bottom out as it clears, and the top of the vent bezel
assembly will follow.
3. Once you have the vent bezel out, remove the electrical plug from
the clock.
4. Unscrew the two phillips screws that hold the clock in place.

is the car still start up and run? do the headlights and windows work?

I've seen the clock assemblies go bad on these models. Sometimes one or more of the digital segments will go out not displaying the time correctly or the whole display goes blank. There are two fuses in the clock circuit. Quick check: If your gauges on your dash work and your radio is working, your fuses are good. It also shares a ground with allot of other components. if you don't have any other electrical issues, your ground is also good. The clock will have to be replaced, unfortunately they are quite expensive and they're only available through Honda. -hope this helps.

Have you checked the bulbs? Push the repeater either to or from the drivers seat, should give in one direction then pry outwards. Twist to remove.
Clock light will be a blow bulb. Pain to remove, you'll need to pop the clock out and again, untwist the bulb to replace it. P/No is YAW100030

I have the removal instructions and repair solution at:

www.autoclockrepair.com

common problem with these clocks. you must replace the clock. my 98 crv does the same thing. i havent taken the clock apart yet but i think its a bad connection on the clock circut board. they share the fuse with the radio and or acc plug. i think they are around $225?