How do you get into the bulb area to changr a head light on a 2008 ford fusion?

You have to take the whole dash out to get to it.. not worth the headace.. take it to a pro..

Duplicate question.

On most Ford Trucks and SUV's there will be two philips head screws on the exterior of the light. Undo these two screws and the whole lens will pull outwards. Unplug the bulb and unscrew the retainer - reverse instructions with new bulb in place.
On a newer Ford, there may be an access panel inside the cargo area. If there is, you will gain access to the bulb and retainer from there.

review the owner's manual

Hi there,

Well first of all you may pop the hood, there should be torx bits holding the head light in 3 one behind the grill one on the inner wing and one underneath....... Post comments for further help or information.....

Good Luck!!

Thanks for using FixYa!!

On this website, you find fuse box diagram and description for Ford Fusion (2008)

http://www.autogenius.info/ford-fusion-2008-fuse-box-diagram-india-version

Hi. Since the headlight on the driver side is working then we dont have any problem with the fuse or relay. Check the wiring and the socket of the passenger headlight if it is intact to the bulb. If it is intact, then this could be a headlight problem. Time to replace the passenger headlight.

you must remove the bumper

You have to remove the cover around the gearshift, there you'll find the bulb, it's a small 12V bulb, just pull it out of the holder and install a new one.

There is a splash shield in the right side wheel well. If you take out the screw you can get the access cover off to get to the headlight. It is labeled bulb access.