Question about 2008 Chevrolet Aveo5
The Chevrolet/GM autos rely on a Kelsey ABS actuator system that is electronically controlled. I know its hard to describe sounds, but is it possible the crunch is a hum? If the ABS light comes on and goes off after restart it means one of two things. That the ABS controller is going bad or the speed sensors on the wheels have come loose or gone bad. Under your hood there is a fuse compartment that contains the fuse that controls the ABS system on your vehicle. Its a 60 Amp fuse and large.. Look in your owners manual for its location. . Check it with the vehicle OFF to make sure its not blown or cracked. Leave the fuse disconnected and start the car. The ABS light should STAY on as well as the parking brake light. Test your brakes by pressing down on them while the car is in park and not moving.. do you hear the sound. If you DONT hear the sound then the ABS control module is causing the brake pump to work continuously and thus your "noise". YOu can confirm by placing the fuse back in place and then listening to the car about where the drivers door is... do you hear a hum? If so you can leave the fuse disconnected to deactivate the ABS module. The brakes will still function you just WONT have ABS capability. Confirm this with a very slow roll from park or neutral and press brakes to stop. If you dont hear the noise or a hum, reconnect the fuse and take the car for a drive. Turn to the left and right while applying the brake at an intersection.. vehicle in motion slightly. Do you notice that the ABS light or noise occurs turning one way or the other or both? If it comes on during the turn then the ABS sensor in that wheel or both wheels need to be inspected and possibly replaced. Finally, you need to inspect the brake pads for wear..typically however brake pads have WEAR INDICATORS built in and will start to SQUEAL when you apply the brakes telling you time to replace pads. If its a squeal and not a crunch then have pads replaced. Finally, be sure and make sure you dont have any rocks or road debris within the brake area or between teh pads and the rotors. That would be your final area to review for a CRUNCH noise.
Posted on Jun 11, 2010
Testimonial: "Thank you very much for your suggestions! I ll carry out these checks you have mentioned. Thanks again "
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Nov 23, 2017 | Cars & Trucks
Jul 10, 2016 | Cars & Trucks
Oct 28, 2012 | 2004 Mazda 6
Apr 19, 2010 | 2002 Toyota Camry
Jun 17, 2009 | 2008 Ford F 250 Super Duty 4WD
Dec 11, 2008 | 2006 Hyundai Sonata
642 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: